2014 MITSUBISHI ASX Owner's Manual (in English)

Page 233 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) 1830.5 mm2461 mm368.5 mm475 mm5310 mm613.5 mm766.5 mm850 mm952 mm
10
464 mm
(at kerb weight con- dition)372 mm to 378 mm
378 mm to 387 mm* (at laden condition)11447 mm12487 mm13495 mm14525.5 mm
*:  Ve

Page 234 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) Overheating
This  will  normally  occur  as  a  result  of  some
mechanical  failure.  If  your  vehicle  should overheat,  stop  and  check  for  a  loose  or  bro-ken  water  pump/alternator  drive

Page 235 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) Ventilators........................................................................................... 7-02
Heater/Air conditioning.....................................................................

Page 236 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) VentilatorsE00700100878
*: Optional equipment**
1- Centre ventilators
2- Side ventilators
NOTEl Do  not  place  beverages  on  top  of  the  instru-
ment panel.
If they splash into the air conditionin

Page 237 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) Mode selection dial
E00726501473
To change the amount of air flowing from the
ventilators, turn the mode selection dial.
Heater/
Manual air conditioningAutomatic air conditioning
 Face position
Air  f

Page 238 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) Control panel
E00700601678
Heater/Manual air conditioningAutomatic air conditioning
A- Temperature control dialB- Air selection switch
C- Blower speed selection dial
D- Air conditioning switch E- Mode

Page 239 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) NOTElWhile the engine coolant temperature is low,
the  temperature  of  the  air  from  the  heaterwill  be  cool/cold  until  the  engine  warms  up, even  if  you  have  selected  warm  air  with  t

Page 240 of 418

MITSUBISHI ASX 2014  Owners Manual (in English) NOTElOn  vehicles  with  the  automatic  air  condi-
tioning,  when  the  mode  selection  dial  or  the
blower  speed  selection  dial  is  set  to  the “AUTO”  position  again  after  manual  op