2014 Lexus CT200h Owner's Manual (in English)

5378-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Once
An attempt was made to turn the
power switch off when the shift posi-
tion was not in P.
→ To turn off the hybrid system,
first shift the shift position to P
and then turn the power switch
off.
Once
Sounds
once
for 5
sec-
onds
• An attempt was made to lock the
doors using the smart entry &
start system while the electronic
key was still inside the vehicle.
• An attempt was made to lock either front door by opening a
door and putting the inside lock
button into the lock position, then
closing the door by pulling on the
outside door handle with the elec-
tronic key still inside the vehicle.
→ Retrieve the electronic key
from the vehicle and lock the
doors again.
Once
• When the doors were unlocked
with the mechanical key and then
the power switch was pressed, the
electronic key could not be
detected in the vehicle.
• The electronic key could not be detected in the vehicle even after
the power switch was pressed two
consecutive times.
→ Touch the electronic key to the
power switch while depressing
the brake pedal.
Interior
buzzerExteriorbuzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 537 Friday, May 30, 2014 1 1:14 AM

5388-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
■Warning messages
→P. 5 3 4
■Warning buzzer
→P. 5 1 9
Once
The driver’s door was opened and
closed with the power switch turned
off and then the power switch was
put in ACCESSORY mode twice
without the hybrid system being
started.
→ Press the power switch while
depressing the brake pedal.
During a hybrid system starting pro-
cedure in the event that the elec-
tronic key was not functioning
properly ( →P. 565), the power
switch was touched with the elec-
tronic key.
→ Press the power switch within 10
seconds of the buzzer sounding.
Once
An attempt was made to start the
hybrid system with the shift position
in N.
→Shift the shift position to P and
start the hybrid system.
Once
The electronic key has a low battery.
→Replace the electronic key bat-
tery. ( →P. 4 8 3 )
Interior
buzzerExteriorbuzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
CT200h_OM_OM76135E_(EE).book Page 538 Friday, May 30, 2014 1 1:14 AM

5398-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
If you have a flat tire (vehicles with a spare tire)
●Stop the vehicle on a hard, flat surface.
●Set the parking brake.
●Shift the shift position to P.
●Stop the hybrid system.
●Turn on the emergency flashers. ( →P. 5 0 8 )
Your vehicle is equipped with a spare tire. The flat tire can be replaced with
the spare tire.
For details about tires: →P. 4 6 8
WA R N I N G
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the wheel beyond
repair, which could result in an accident.
Before jacking up the vehicle
CT200h_OM_OM76135E_(EE).book Page 539 Friday, May 30, 2014 1 1:14 AM

5408-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
Location of the spare tire, jack and tools
Towing eyelet
Jack
Spare tireJack handle
Wheel nut wrench1
2
3
4
5
CT200h_OM_OM76135E_(EE).book Page 540 Friday, May 30, 2014 1
1:14 AM

5418-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Remove the center deck board.
Remove the center auxiliary box.
WA R N I N G
■Using the tire jack
Observe the following precautions.
Improper use of the tire jack may cause the vehicle to suddenly fall off the jack, leading
to death or serious injury.
●Do not use the tire jack for any purpose other than replacing tires or installing and
removing tire chains.
●Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replacing tires on
this vehicle.
●Put the jack properly in its jack point.
●Do not put any part of your body under the vehicle while it is supported by the jack.
●Do not start the hybrid system or drive the vehicle while the vehicle is supported by
the jack.
●Do not raise the vehicle while someone is inside.
●When raising the vehicle, do not put an object on or under the jack.
●Do not raise the vehicle to a height greater than that required to replace the tire.
●Use a jack stand if it is necessary to get under the vehicle.
●When lowering the vehicle, make sure that there is no-one near the vehicle. If there
are people nearby, warn them vocally before lowering.
Taking out the jack
1
2
CT200h_OM_OM76135E_(EE).book Page 541 Friday, May 30, 2014 1 1:14 AM

5428-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
Take out the jack.For loosening
For tightening
Remove the center deck board and center auxiliary box. ( →P. 5 4 1 )
Loosen the center fastener that
secures the spare tire.3
1
2
Taking out the spare tire
1
2
WA R N I N G
■When storing the spare tire
Be careful not to catch fingers or other body parts between the spare tire and the body
of the vehicle.
CT200h_OM_OM76135E_(EE).book Page 542 Friday, May 30, 2014 1 1:14 AM

5438-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Chock the tires.
For vehicles with 15 inch wheels,
remove the wheel ornament using
the wrench.
To protect the wheel ornament, place a
rag between the wrench and the wheel
ornament.
Slightly loosen the wheel nuts (one
turn).
Replacing a flat tire
1
Flat tireWheel chock positions
FrontLeft-hand sideBehind the rear right-hand side tire
Right-hand sideBehind the rear left-hand side tire
RearLeft-hand sideIn front of the front right-hand side tire
Right-hand sideIn front of the front left-hand side tire
2
3
CT200h_OM_OM76135E_(EE).book Page 543 Friday, May 30, 2014 1 1:14 AM

5448-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
Turn the tire jack portion by hand
until the notch of the jack is in con-
tact with the jack point.
The jack point guides are located under
the rocker panel. They indicate the jack
point positions.
Raise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and the
tire.
When resting the tire on the ground,
place the tire so that the wheel design
faces up to avoid scratching the wheel
surface.
4A
5
6
CT200h_OM_OM76135E_(EE).book Page 544 Friday, May 30, 2014 11:14 AM