Page 25 of 428
23
- "MEDIA": display of information related to t
he media being played or the radio.-
" NAVIGATION": display of information r
elated to the navigation in progress
(map
and instructions).-
" PHOTOS": display of the photo selected i
n the "Media" menu of the touch screen
t
ablet.
1
Monitoring
Page 26 of 428
24
- "DRIVING": used for the display of the i
nter-vehicle time and information related to
t
he active cruise control.
T
he recommended speed is displayed in
t
he central part.
T
he driver remains responsible for
o
bserving the driving regulations. To
modify the display mode of the instrument pan
el:
F
t
urn the wheel on the left of the steering
w
heel to display and run through the
d
ifferent modes in the right hand part of the
in
strument
pan
el,F
o nce the selected display mode appears in
t
he central window, it is applied after a few
m
oments.
M
Page 27 of 428

25
Indicator and warning lamps
Certain warning lamps may come on in one of two modes: fixed (continuous) or
f
lashing.
Only
by relating the type of illumination
t
o the operation of the vehicle can it
be
determined whether the situation is
n
ormal or a fault has occurred. In the
e
vent of a fault, the illumination of the
w
arning lamp may be accompanied by
a
message.
Refer
to the tables on the following
p
ages
f
or
m
ore
i
nformation.
Visual
indicators
informing
the
driver
of
the
s
tatus
of
a
system
(operation
or
deactivation
i
ndicator
lamp)
or
the
existence
of
a
fault
(
warning
lam
p).
When the ignition is switched on
Certain warning lamps come on for a few s econds in the instrument panel when the
v
ehicle's ignition is switched on.
When
the engine is started, these same
w
arning lamps should go off.
If
they remain on, before moving off, refer to the
i
nformation on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps may be accompanied by an audible signal and a
m
essage.
The
warning lamps may come on continuously
(
fixed) or flash.
The
position of the warning lamps in the
t
ype 2 instrument panel depends on the
c
olour scheme selected.
1
Monitoring
Page 28 of 428
26
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel, this confirms that the corresponding system has come into operation.
W arning / indicator lamp StateCause Action / Observations
Left-hand
direction indicatorflashing with buzzer.The lighting stalk is pushed down.
Right-hand
direction indicatorflashing with buzzer.The lighting stalk is pushed up.
Sidelamps fixed. The
lighting stalk is in the
"
Sidelamps"
p
osition.
Dipped beam
headlamps fixed.
The
lighting stalk is in the "Dipped
b
eam headlamps" position.
Main beam
headlamps fixed.
The
lighting stalk is pulled towards
yo
u. Pull
the stalk to return to dipped beam headlamps.
Monitoring
Page 29 of 428

27
Automatic
headlamp
dippingfixed.
The lighting control stalk is in the "
AUTO" position, pulled towards
y
ou, and the function is activated
("D
riving assistance"
menu).
The
system is in dipped beam mode
a
s there is sufficient ambient light
a
nd/or the traffic conditions do not
a
llow illumination of main beam.The
camera, located in the door mirror, manages the o
peration of main beam, depending on the ambient
l
ighting and driving conditions.
Pulling
the lighting stalk again to deactivate.
For
more information on this function, refer to the
V
isibility
s
ection.
fixed. The
lighting control stalk is in the
"
AUTO" position, pulled towards
y
ou, and the function is activated
("D
riving assistance"
menu).
The
system is in main beam mode
a
s the ambient lighting and traffic
c
onditions allow it.
Warning / indicator lamp
StateCause Action / Observations
Rear foglamps fixed. The
rear foglamps are on.Turn
the ring on the stalk rear ward to switch off the
r
ear
fo
glamps.
Front foglamps
fixed. The
front foglamps are switched on
u
sing the ring on the lighting control
st
alk.Turn
the ring on the lighting control stalk rear ward
t
wice to switch off the front foglamps.
For
more information on the lighting controls, refer to the corresponding section.
1
Monitoring
Page 30 of 428

28
Warning / indicator lampStateCause Action / Observations
Electric parking
brake fixed.
The
electric parking brake is applied. Release the electric parking brake to switch off the
w
arning lamp: with your foot on the brake pedal,
b
riefly push the electric parking brake control lever.
Observe
the safety recommendations.
For
more information on the electric parking brake,
r
efer to the corresponding section.
Diesel engine
pre-heating
fixed.
The "START/STOP " switch has been
pressed
(ignition on).Wait
until the warning lamp goes off before starting.
Once
it goes off, starting is immediate, on condition
t
hat you maintain pressure on the brake pedal for an
e
lectronic or automatic gearbox, or the clutch pedal is
p
ressed fully down for a manual gearbox.
The
period of illumination of the warning lamp is
d
etermined by the ambient conditions (up to about
t
hirty seconds in extreme conditions).
If
the engine does not start, switch the ignition off and
t
hen on, wait until the warning lamp goes off again,
t
hen start the engine.
Blind spot
sensors fixed.
The
blind spot monitoring function
h
as been activated.For
more information, refer to the corresponding
s
ection.
Park Assist fixed. The
Park Assist function has been
a
ctivated.For
more information, refer to the corresponding
s
ection.
Monitoring
Page 31 of 428

29
Warning / indicator lampStateCause Action / Observations
Automatic
wiping fixed.
The
wiper control is pushed
d
ownwards.Automatic
front wiping is activated.
To
deactivate automatic wiping, operate the control
s
talk downwards or put the stalk into another position.
Passenger
airbag system fixed.
The control switch, located at the p
assenger's end of the dashboard, is in t
he "ON "
p
osition.
The
p
assenger's
f
ront
a
irbag
i
s
a
ctivated.
In
this case, do not install a rear ward
f
acing child seat on the front passenger
sea
t.Turn the control switch to the " OFF" position to
deactivate the front passenger's airbag.
In
this case you can install a rear ward facing child
sea
t.
Stop & Star t fixed. When
the
vehicle
stops
(red
lights,
t
raffic
jams,
...)
the
Stop
&
Start
system
h
as
put
the
engine
into
STOP
mode. The
warning lamp goes off and the engine restarts
a
utomatically in START mode, as soon as you want to
m
ove off.
flashes for a few
seconds,
then
goes
o
f f. STOP
mode
is
temporarily
u
navailable.
or
START
mode
is
invoked
au
tomatically. For
more information on special cases with STOP
m
ode and START mode, refer to the "Stop & Start"
s
ection.
1
Monitoring
Page 32 of 428

30
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
T his is may be accompanied by an audible signal and the display of a message.
Warning / indicator lamp StateCause Action / Observations
Passenger's
airbag system fixed.
The
control switch, located at the
r
ight hand end of the dashboard is
s
et to the OFF
p
osition.
The
passenger's front airbag is
d
eactivated.Set the control to the "ON"
position to activate the
passenger's
front airbag.
In
this case, do not fit a child seat in the rear ward-
facing
position.
Dynamic
stability control
(DSC/ASR) fixed.
The
button, located on the centre
c
onsole, is pressed. Its indicator lamp
i
s on.
The
DSC/ASR is deactivated.
DSC:
dynamic stability control.
ASR:
anti-slip regulation.Press
the button to activate the DSC/ASR. Its
i
ndicator lamp goes off.
The
DSC/ASR system is activated automatically when
t
he vehicle is started.
If
deactivated, the system is reactivated automatically
f
rom around 30 mph (50 km/h).
Stop & Star t fixed. The Stop & Start
has been
deactivated. Reactivate the function via the "
Driving assistance"
menu.
Monitoring