Page 209 of 428
207
Screenwash and washer jets
Windscreen wash and
headlamp wash
Adjusting the jets
The f ront w ashers i nclude a n a djustment f or t he
h
eight of delivery from the jets.
If
you want to modify the factory setting, turn
t
he screw on each jet anti-clockwise, towards
t
he "+" to raise the jet or clockwise, towards
t
he "-" to lower it.
Headlamp wash
F Pull the windscreen wiper stalk towards y
ou. The windscreen wash then the
w
indscreen wipers operate for a fixed
p
eriod.
A
few moments after releasing the wiper stalk,
t
here is a last wipe to clear any runs from the
sc
reen. The
headlamps operate when the vehicle is m
oving and when the dipped beam headlamps
a
re on. However, to reduce the consumption
o
f screenwash fluid, the headlamp wash only
o
perates with every 7th use of the screenwash
o
r once every 25 miles (40 km), during a given
j
o u r n ey.
5
Visibility
Page 210 of 428
208
The windscreen wipers operate automatically, without any action on the part of the driver, if
r
ain is detected (sensor behind the rear view
m
irror), adapting their speed to the intensity of
t
he rainfall.
Switching on Switching offThe automatic rain sen sitive w indscreen w
ipers must be reactivated by pushing
t
he control stalk downwards, if the
i
gnition has been off for more than
o
ne minute.
Briefly
push
the
control
stalk
d
ownwards.
A
wiping
cycle
confirms
that
the
i
nstruction
has
been
accepted.
This
warning
lamp
comes
on
in
the
i
nstrument
panel
and
a
message
is
d
isplayed. Briefly
push
the
control
stalk
d
ownwards
again,
or
place
the
c
ontrol
stalk
in
another
position
(Int,
1
or
2).
Automatic rain sensitive
windscreen wipers
This warning lamp goes off in the instrument p anel and a message is displayed.
Visibility
Page 211 of 428

209
Special position of the
windscreen wipers
To maintain the effectiveness of the "flat-blade" type of wiper blades, it is
a
dvisable
t
o:
-
h
andle them with care,
-
c
lean them regularly using soapy
w
ater,
-
a
void using them to retain
c
ardboard on the windscreen,
-
r
eplace them at the first signs of
w
e a r.
This
position
permits
release
of
the
windscreen
w
iper
blades.
It
is
used
for
cleaning
or
replacement
of
the
b
lades.
It
can
also
be
useful,
in
winter,
to
d
etach
the
blades
from
the
windscreen.
Do
not
cover
the
rain
sensor,
linked
with
t
he
sunshine
sensor
and
located
in
the
c
entre
of
the
windscreen
behind
the
rear
v
iew
mirror.
Switch
off
the
automatic
rain
sensitive
w
ipers
when
using
an
automatic
car
wash.
In
winter,
it
is
advisable
to
wait
until
the
w
indscreen
is
completely
clear
of
ice
b
efore
activating
the
automatic
rain
sen
sitive
w
ipers.
Operating fault
If a fault occurs with the automatic rain s ensitive wipers, the wipers will operate in
intermittent
mode.
Have
it checked by CITROËN dealer or a
q
ualified
w
orkshop.
On
switching off the ignition:
F
a
ny action on the wiper stalk in the minute
a
fter switching off the ignition places the
b
lades vertically on the screen.
When
the system is no longer powered - at least
o
ne minute after switching off the ignition - it is
p
ossible to move the arms manually.
F
T
o park the blades again, switch on the
i
gnition and operate the wiper stalk.Replacement
of the arms must only
b
e done by a CITROËN dealer or a
q
ualified
w
orkshop.
5
Visibility
Page 212 of 428

210
Courtesy lamps
1. Front courtesy lamp
2.
F ront map reading lamps
3.
R
ear courtesy lamp
4.
R
ear map reading lamps
Front - rear courtesy lamps
F With the ignition on, press the c
orresponding s witch.
Front - rear map reading
lamps
With the "permanent lighting" mode, the lighting time varies according to the circumstances:
-
w
ith the ignition off, approximately
t
en minutes,
-
i
n energy economy mode, approximately
t
hirty seconds,
-
w
ith the engine running, unlimited.
In this position, the courtesy lamp comes on gradually:
Permanently
off.
Permanent
l
ighting.
-
w
hen
the vehicle is unlocked,
-
w
hen
the electronic key is removed from
t
he
r
eader,
-
w
hen
opening a door,
-
w
hen
the remote control locking button is
a
ctivated, in order to locate your vehicle.
It
switches off gradually:
-
w
hen
the vehicle is locked,
-
w
hen
the ignition is switched on,
-
3
0
seconds after the last door is closed.Take
care to avoid leaving anything
in
contact with the courtesy lamps.
Depending
o
n
v
ersion, you can
also switch the
courtesy
lamp on or
o
ff by pressing this
b
utton.
Visibility
Page 213 of 428
211
Panoramic sunroof
F Rotate the control A to slide the roof blind t
o the desired position (positions 1 to 4).
Closing the roof blind Anti-pinch
It is fitted with an electrically controlled blind.
Opening the roof blind
F Rotate the control A to position 0 to close
the roof blind.
The
blind has an anti-pinch function.
At
the end of its travel, when the blind
e
ncounters an obstacle on closing, it stops and
m
oves back slightly.
Following
a fault or after a battery disconnection
d
uring the movement of the blind or after it has
s
topped, you must re-initialise the anti-pinch
f
unction:
F
p
lace the blind in the closed position,
F
p
ress control knob B for approximately
t
wo seconds.
5
Visibility
Page 214 of 428
212
Interior mood lighting
The dimmed passenger compartment lighting improves visibility in the vehicle when the light i
s poor.
The
interior mood lighting can be activated
o
r deactivated via the "Driving assistance "
menu,
then "Vehicle settings ".
The
soft lighting provided by the footwell lamps
i
mproves visibility in the vehicle when the light
i
s poor.
At
night, the lighting of the dashboard,
c
entre console, courtesy lamp... come on
a
utomatically when the sidelamps are
s
witched on.
The
interior mood lighting switches off
a
utomatically when the sidelamps are
s
witched off.
Switching on
Footwell lighting
Activation
Its operation is identical to that of the courtesy lamps. The lamps come on when one of the
d
oors is opened.
Visibility
Page 215 of 428
213
Direction indicators
F Left: lower the lighting stalk passing the p
oint of resistance.
F
R
ight: raise the lighting stalk passing the
p
oint of resistance.
Three flashes of the direction
indicators
F Press briefly upwards or downwards, w
ithout going beyond the point of
r
esistance; the direction indicators will
f
lash 3 times.
Hazard warning lam ps
A visual warning by means of the direction i
ndicators to alert other road users to a vehicle
b
reakdown, towing or accident.
F
P
ress this button, the direction indicators
f
lash.
They
can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on the deceleration, the hazard warning lamps
c
ome on automatically.
They
switch off automatically the first time you
a
ccelerate.
F
Y
ou can also switch them off by pressing
t
he button.
Horn
F Press the central part of the steering wheel.
6
Safety
Page 216 of 428
214
This system allows you to make an emergency or assistance call to the emergency services or
t
o the dedicated CITROËN service.
Emergency or
a
ssistance call
For more information on the use of this f
unction, refer to the "Audio and telematics"
s
ection.
Warning triangle
This safety device should be used in addition to the hazard warning lamps.
Its
presence in the vehicle is mandatory.
A
location for stowing the warning triangle is
p
rovided in the tailgate interior trim.
Placing the triangle in the road
F Place the triangle behind the vehicle, a
s required by the legislation in force in
y
our country.Before
leaving your vehicle to set up
a
nd install the triangle, switch on the
h
azard warning lamps and put on your
h
igh visibility vest.
Refer to the manufacturer's instructions
o
n unfolding and installing supplied with
t
he triangle.
Safety