Page 359 of 751

02-498710-01
▶Specifications of Remote Control Key
When any of switches on remote control key is pressed, the integrated CP\
U in remote control key sends
the coded control message to the CPU in receiver to control the vehicle.\
Door Unlock and Panic Function Breifly press (below 0.5 sec): Door unlock and theft deterrent mode is\
deactivated
Press and hold (over 2 sec): Panic function
Door unlock (Briefly press)
1.
If you send the door unlock signal using the remote control key, with al\
l the doors locked, the
door will be opened and the theft deterrent mode will be deactivated. If\
the door coupled switch
of front room lamp is pressed, the lamp will come on for 30 seconds. It \
will turn off immediately
after the lock button of the remote control is pressed.
·
Panic function: activated in the theft deterrent mode
2.
If you press and hold the door unlock and panic buttons, the buzzer will\
sound for 27 seconds
and the hazard warning flasher blinks.
The function is inactivated if any button of remote control is pressed.
* For the previous model, only the theft deterrent horn has been activat\
ed.
·
·
LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock Function
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is a\
ctivated
Door unlock (Briefly press)
1.
Pressing this button locks all doors and activates the theft deterrent m\
ode.
·
Page 361 of 751
02-518710-01
Specification of Receiver
▶
Operating requirements
1.
You should remove the ignition key.
-
Code registration requirement
2.
You can register the code only using the diagnostic device.
-
Transmitter code registration
3.
You can register up to 5 transmission codes to the remote control key.
The receiver does not output the received code during registration.
Connect the device to the diagnostic terminal.
The code can be registered only by the panic signal from the transmitter\
.
(Other switches (LOCK/UNLOCK) can't code.)
a.
b.
c.
Remote Door Lock
▶
All doors are locked when briefly pressing the door LOCK burron on remot\
e control key (less than
0.5 seconds).
The system outputs LOCK signal immediately a fter receiving the door lock message from the
remote control key. The system activates the theft deterrent mode when a\
ll doors are locked while
they are fully closed (the hazard warning lamps blink twice.).
1.
2.
Page 362 of 751
02-52
Door Unlock
▶
The door unlock operates when pressing the door switch on the remote con\
trol key for longer than
0.5 seconds.
The door unlock relay is "ON" for 0.5 seconds when receiving the door un\
lock message from the
remote control key.
The hazard warning lamps blink once only when all the doors unlocked suc\
cessfuly.
1.
2.
3.
Page 363 of 751
02-538710-01
Remote Panic
▶
If you press and hold the door UNLOCK and PANIC button (more than 2 sec\
onds) on the remote
control key, the panic function is activated.
The vehicle activates the panic alarm by using the horn and hazard warni\
ng lamp for 27 seconds
when receiving the panic message from the remote control key.
1.
2.
Auto Door Lock in 30 Seconds after Pressing Door Unlock Button
▶
If no door is opened for 30 seconds after inputting remote door unlock, \
the doors are automatically
locked and the armed mode of anti-theft system is activated again (RELO\
CK function).
1.
Page 368 of 751
02-58
You can register up to 2 transmission codes to the remote control key.
The receiver does not output the received code during registration.
The remote control key should be coded using the diagnostic device.
a.
b.
c.
1) Operating requirements
You should remove the ignition key.
2) Code registration requirement
You can register the code only using the diagnostic device.
3) Transmitter code registration
4. REKES Key Coding
Page 369 of 751
02-598710-01
4) How to Code REKES Key
If you replace the REKES key or immobilizer key to new one, you should c\
ode the REKES key using the
diagnostic device. (maximum 5)Connect the diagnostic device to the vehilce and se lect the vehicle type and system (RK-STICS).
When the following screen is displayed, select 'REMOCON CODING'.
1.
Remove the remote control key from the ignition key box and press 'Next'\
. Press the door UNLOCK
(PANIC) button on the remote control key once (for approx. 2 seconds \
or longer).
2.
Page 370 of 751
02-60
When you code newly purchased remote control key:When you lost the remote control key and purchase a new one, if you code\
only the newly
purchased one, the existing remote control key becomes unavailable. You must code the newly
purchased remote control key together with the existing one.
- The first key coding completion screen is displayed with beep sound as f\
ollows: Press 'Next' and
perform the second remote control key coding in the same way.
3.
When the second key coding is completed, the following screen is display\
ed. Finish the remote
control key coding by pressing 'Previous'.
4.
Exit the diagnostic screen, remove the device from the diagnostic connec\
tor and perform the
function test for the remote control key. If it does not work well, perf\
orm the above procedures again.
5.
Page 378 of 751

03-6
3. FUNCTIONS OF IMMOBILIZER
The functions of the immobilizer are similar to that of the normal REKES key. But, there are the
immobilizer function that permits the engine to start only after confirming the encrypted coding.
The followings are common functions of the normal REKES key and the immobilizer.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked, the
door will be opened and the theft deterrent mode
will be deactivated. If the door coupled switch o
f
front room lamp is pressed, the lamp will come
on for 30 seconds. It will turn off immediately
after the lock button of the remote control is
pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for approx.
2 seconds or longer, the warning alarm sounds and the hazard
warning lamp blinks for approx. 27 seconds.
The function is inactivated if any button of remote control is
pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
1. Door unlock (Briefly press)
If you press this button briefly, all doors and the tailgate are locked and the theft deterrent mode is
activated.When the theft deterrent mode is activated, the hazard warning flashers blink twice.LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock