2013 Citroen C3 PICASSO turn signal

1
Monitoring
23








Indicator and warning lamps


Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning
lamp).
Associated warnings
The illumination of certain warning lamps may
be accompanied by an audible signal and amessage in the multifunction screen.
The warning lamps may come on continuously (fixed) or flash.

When the ignition is switched on

Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Certain warning lamps may come onin one of two different modes. Only by relating the type of illumination to the operating status of the vehicle can itbe ascertained whether the situation isnormal or whether a fault has occurred.

Operation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.

Warning lampis onCauseAction / Observations
Left-hand directionindicator
flashing with buzzer.The lighting stalk is pushed down.
Right-hand direction indicatorr

flashing with buzzer. The lighting stalk is pushed up.
Sidelamps
fixed. The lighting stalk is in the
"Sidelamps" position.
Dipped beamheadlamps fixed. The lighting stalk is in the "Dipped beam headlamps" position.
Main beam headlamps fixed. The lighting stalk is pulled towardsyou. Pull the stalk to return to dipped beam headlamps.

Monitoring
30
Warning lampis onCauseAction / Observations
Airbagstemporarily. This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.
fix
ed.One of the airbag or seat beltpretensioner systems has a fault.Have it checked by a CITROËN dealer or a qualified
workshop.
Front seat beltnot fastened / unfastened
fixed then flashingaccompanied by an
increasing audible
signal. The driver and
/or the front passenger has not fastened or has unfastened
their seat belt.
Pull the strap then insert the tongue in the buckle.
Rear seat belt not fastened / unfastened
fixed then flashingaccompanied by anaudible signal.
One or more rear passengers haveunfastened their seat belt.
Power steeringfixed.The power steering has a fault. Drive carefully at reduced speed.
Have it checked by a CITROËN dealer or a qualified
workshop.
Door(s) openfixed if the speed is
below 6 mph (10 km/h). A door or the boot is still open.Close the door or boot.
fixed and accompanied
b
y an audible signal
if the speed is above
6 mph (10 km/h).

4
Access
67
Locating your vehicle
)Press the closed padlock to locate your locked vehicle in a car park.
This is indicated by lighting of the cour tesylamps and flashing of the direction indicators for a few seconds.
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.

Folding the key
)First press this button to fold the key.
If you do not press the button when foldingthe key, there is a risk of damage to themechanism.

Ignition switch



- Position 1: Stop

- Position 2: Ignition

- Position 3: Starting


Starting the vehicle

)
Inser t the key in the ignition switch.
The system recognises the star ting code.) Turn the key fully towards the dashboard toposition 3 (Starting).)
When the engine starts, release the key.
In this case,
your vehicle will not start; contact a CITROËN dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.

Access
68
Remote control problem
Following disconnection of the vehicle battery,replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle. ) First of all, use the key in the lock to unlock or lock your vehicle.)
Then, reinitialise the remote control.
If the problem persists, contact a CITROËN
dealer as soon as possible.

Changing the battery

Battery ref.: CR1620 / 3 volts.
Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition on).)
Press the closed padlock immediately for a few seconds. )
Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again. I
f the battery is flat, you are
informed by illumination of
this warnin
g lamp, an audible signal and a message in the
multifunction screen.
Key reminder
Switching the vehicle off
)Immobilise the vehicle. )Turn the key fully towards you to position 1(Stop)
. )Remove the key from the ignition switch.
)Unclip the casing using a coin at the notch. )Slide the flat battery out of its location.)Slide the new battery into its location
observing the original direction. )Clip the casing. )Reinitialise the remote control.


Do not attach any heavy objects to the key as this could weigh down on it when in the ignition switch and cause a fault.

If the key is left in the ignition switch, an audible signal sounds when the driver's door is opened.

Access
74
Activation
)Press button Afor more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an audible signal.
Deactivation
)Press button Aagain for more than two seconds.
A confirmation message appears on themultifunction screen, accompanied by an audible signal.

Emergency control


Locking the front and rear passenger doors
)Inser t the key in the lock, located on the edge of the door, then turn it one eighth of a turn
.


Locking the driver's door
)
Inser t the key in the lock, then turn it to the
right.

Unlocking the driver's door
)
Inser t the key in the lock, then turn it to theleft.


Unlocking the front and rear passenger doors
)Pull the interior door opening control.
In the event of a fault with the central locking, you must disconnect thebattery to lock the boot and so ensurethe complete locking of the vehicle.
System which locks or unlocks the doors
mechanically in the event of a malfunction of
the battery or of the central locking.

5
Visibility
83
Linked with the Guide-me-home lighting
Association with the automatic illumination
of headlamps provides the guide-me-home lighting with the following additional options:
- automatic activation of guide-me-home lighting when automatic illumination of
headlamps is switched on (in the vehicle
parameters of the multifunction screen configuration menu),
- selection of the duration of maintaining of
the lighting for 15, 30 or 60 seconds in the
vehicle parameters of the multifunction
screen configuration menu (except for monochrome screen Awhere this is
preset).



Operating fault

In the event of a malfunction of
the sunshine sensor, the lamps
come on, this warning lamp is
displayed in the instrument panel and/or a
message appears in the multifunction screen,
accompanied by an audible signal.
Contact a CITROËN dealer or a qualified
workshop.
In fog or snow, the sunshine sensor maydetect sufficient light. Therefore, the lamps will not come on automatically.
Do not cover the sunshine sensor,linked with the rain sensor and located in the centre of the windscreen behindthe rear view mirror; the associatedfunctions would no longer be controlled.

Automatic illumination of
headlamps
The sidelamps and dipped beam headlamps are switched
on automatically, without any action on the par t of the
driver, when a low level of external light is detected or incer tain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or
after the windscreen wipers are switched off, the lamps
are switched o
ff automatically.
Activation
)Turn ring Ato the A"AUTO"
position. The automatic
illumination of headlamps is accompanied by a message in the multifunction screen.


Deactivation
)Turn ring A
to a position other
than "AU TO "
. Deactivation is accompanied
b
y a message in the multifunction screen.