2013 Citroen C3 ignition

.Familiarisation
9
1. Steering lock and ignition. 2.Audio equipment steering wheel controls.3.Wiper / screenwash / trip computer controlstalk.4.
Microphone.
5. Scented air freshener.
6.Central locking switch.
7. Multifunction screen.
8.Hazard warning lamps switch. 9.
Central adjustable air vents.10.Sunshine sensor
Hi-Fi audio system central speaker.11. Passenger's airbag.12 .
Side adjustable air vent.13.Glove box / Passenger's airbag deactivation / Audio/video sockets.14.Parking brake.15.Central armrest with storage. 16.
Upper and lower storage.17.Audio system or eMyWay. 18.Heating / air conditioning controls.
Instruments and controls

.Familiarisation
15

Instrument panel
A.With the ignition on, the fuel gauge bars for
the fuel remaining should come on. B.With the engine running, the associatedlow level warning lamp should go off.C.With the ignition on, the oil level indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the level
whi
ch is low.
Warning lamps
1.With the ignition on, the orange and red
warn
ing lamps come on. 2. With the engine running, these warning lamps should go off.
If a warning lamp remains on, refer to the pageconcerned.

Switch panel

Illumination of the indicator lamp indicates the state of the corresponding system.A.ESP/ASR system deactivation.
B.
Stop & Start system deactivation.

Monitoring
23

25, 3012
5
108

.Familiarisation
19

Stop & Start


Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-with a manual gearbox:
at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and you release the clutch pedal,

-
with a 5 or 6-speed electronic gearbox:at speeds below 5 mph (8 km/h), when you press the brake pedal or you move the gear lever to position N.

In some circumstances, STOP mode may notbe available; the "ECO"warning lamp flashes for a few seconds, then goes off.
Going into engine START mode

The "ECO"
warning lamp goes off
and the engine restarts:
-with a manual gearbox:when youdepress the clutch pedal,
-with a 5 or 6-speed electronic gearbox:

●
with the gear lever in position A
or M ,
when you release the brake pedal,

●
or with the gear lever in position N
andthe brake pedal released, when you put
the gear lever in position Aor M ,

●
or when you engage reverse.

In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

Deactivation / Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
switch; the warninglamp in the button comes on.

Driving safely
124

125

12
5
The system is reactivated automatically every time the vehicle is star ted using the key.
Before refueling or doing anything under the bonnet, you must switch off the ignition with the key.

1
Monitoring
23
Panel grouping together the vehicle operation indication dials and warning lamps.
























Instrument panels with manual gearbox
5.Display management buttonServicing information. Adjust the time and choose units.
Reset the service indicator.6.Instrument panel lighting button.Adjusts the brightness of the lighting of the
instruments and controls.
1.Rev counter. Indicates the speed of rotation of the engine (x 1 000 rpm). 2.Vehicle speed. Indicates the current speed of the moving
vehicle (mph or km/h). 3.Fuel level. Indicates the quantity of fuel remaining in
the tank. 4.Screen.
A.Ambient temperature. (°Celsius or °Fahrenheit)B.Gear shift indicator.C.Time.D.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears. E.Trip computer.F.Ser vice indicator. (miles or km) then, Total mileage. These two functions are displayed successively when switching on
the i
gnition.



Screen
For more information, refer to thesection on the button or function and its associated display.


Dials

Monitoring
24

















Instrument panels for electronic or automatic gearboxes
Panel grouping together the vehicle operation indication dials and warning lamps. Depending on the version, the instrument panel may have permanent
back-lighting.
1.Rev counter.Indicates the speed of rotation of the
engine (x 1 000 rpm).2.Vehicle speed.Indicates the current speed of the moving
vehicle (mph or km/h).3.Fuel level.Indicates the quantity of fuel remaining in
the tank. 4.Screen.
5.Display management button
Alternates display between range and trip mileage recorder.
Servicing information.
Resets the selected function to zero (trip
distance recorder or ser vice indicator).
6.Instrument panel lighting button. Adjusts the brightness of the lighting of the
instruments and controls.


ScreenDials
For more information, refer to thesection on the button or function and its associated display.A
.Speed limiter (mph or km/h) or Cruise control.B.Gear shift indicator.C.Electronicorautomatic gearboxinformation.D.Range (miles or km) or Trip mileage recorder.E.
Ser vice indicator
r (miles or km), then Total mileage recorder. These two functions are displayedsuccessively when switching on the ignition
F.Engine oil level indicator. Appears a few seconds after switching on
the ignition, then disappears.

1
Monitoring
25

Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning lamp).


When the ignition is switched on

Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.
When the engine is star ted, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.

Operation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.

Associated warnings
The illumination of cer tain warning lamps may
be accompanied by an audible signal and a
message in the multifunction screen.The warning lamps may come on continuously (fixed) or flash.
Warning lampis onCauseAction / Observations
Left-hand direction indicator flashing with buzzer.The lighting stalk is pushed down.
Right-handdirection indicatorr

flashing with buzzer. The lighting stalk is pushed up.
Sidelamps

fixed. The lighting stalk is in the
"Sidelamps" position.
Hazard warning lamps flashing with audiblesignal.The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.
Certain warning lamps may come on
in one of two different modes. Only by relating the type of illumination to the operating status of the vehicle can itbe ascertained whether the situation isnormal or whether a fault has occurred.









Indicator and warning lamps

Monitoring
26
Front foglampsfixed.The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.
Rear foglampsfixed.The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
Diesel engine pre-heatingfixed.The ignition switch is at the
2nd position (ignition on).Wait until the warning lamp goes off before star ting.
The period of illumination of the warning lamp is
determined by the climatic conditions (up to about
thirty seconds in extreme climatic conditions).
If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again,
then star t the engine.
Parking brakefixed.The parking brake is applied or not properly released.Release the parking brake to switch off the warninglamp, keeping your foot on the brake pedal.Observe the safety recommendations.
For fur ther information on the parking brake, refer to
the "Parking brake" section.
Dipped beamheadlampsfixed.The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlampsfixed.The lighting stalk is pulled towardsyou. Pull the stalk to return to dipped beam headlamps.
Warning lampis onCauseAction / Observations

Monitoring
30
reading the associated message in the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the following warning lamps indicates a fault whichrequires action on the par t of the driver.
STOPfixed, alone or
associated withanother warning lamp,accompanied by anaudible signal anda message on the screen. Illumination of the warnin
g lamp is
associated with a serious braking system or engine coolant temperature problem. Stop as soon as it is safe to do so as the en
gine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Servicetemporarily. Minor problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown in
the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control batter
y,
- saturation of the par ticle emission filter on Diesel
vehicles
(see the "Checks - Particle emissions
filter" section).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed.Major problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown
in the screen and contact a CITROËN dealer or a
qualified workshop.
Warning lampis onCauseAction / Observations