2013 Citroen C3 bulb

.
.
Contents
Direction indicators 105
Hazard warning lamps 105
Horn 106
Emergency or assistance call 106
Braking assistance systems 107
Tr ajectory control systems 108
Front seat belts 109
Airbags 111
Safety
Parking brake 115
6-speed manual gearbox 115
Gear effi ciency indicator 116
Electronic gearbox 117
Automatic gearbox 121
Stop & Start 124
Hill start assist 127
Speed limiter 128
Cruise control 130
Rear parking sensors 132
Reversing camera 134
Driving
Emergency or assistance 195
eMyWay 197
Audio system 251
Audio and telematics
Alphabetical index
Bonnet 136
Running out of fuel (Diesel) 137
Petrol engines 138
Diesel engines 139
Checking levels 140
Checks 142
Checks
Te m p o r a ry puncture repair kit 144
Changing a wheel 149
Snow chains 156
Changing a bulb 157
Changing a fuse 164
Battery 171
Energy economy mode 174
Changing a wiper blade 175
To w i ng the vehicle 176
To w i ng a trailer 178
Audio pre-equipment 180
Accessories 182
Practical informationTechnical data
Petrol engines 184
Petrol wei
ghts 185
LPG engines 187
LPG weights 188
Diesel engines 189
Diesel weights 191
Dimensions 193
Identifi cation markings 194
Visual search

Fittings
94





Rear parcel shelf
)unhook the two cords, )raise the shelf slightly, then unclip it on each side.






Hooks


The hooks can be used to hold shopping bags.






Storage box
)Raise the boot carpet by pulling the strap
upwards to gain access to the storage box.
This has areas for storing a temporary puncture
repair kit, a box of spare bulbs, a first aid kit,
two warn
ing triangles, ...
)refit the boot floor carpet by folding itslightly in the middle.

11
Practical information
157











Changing a bulb
1.Direction indicators (PY21W amber).2.Sidelamps (W5W).3. Main beam headlamps (H1- 55W).4.Dipped beam headlamps (H7-55W).5.LED daytime running lamps.6.Front foglamps (PSX24W).


Front lamps
The headlamps are fitted with polycarbonate glass with a protectivecoating:)do not clean them using a dry or abrasive cloth, nor with a detergent or solvent product,)
use a sponge and soapy water or apH neutral product,)
when using a high pressure washer on persistent marks, do not keep the lance directed towards thelamps or their edges for too long, so as not to damage their protectivecoating and seals.
Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of seriousburns). - do not touch the bulb directly with your fingers, use a lint-free cloth.It is imperative to use only anti-ultraviolet (UV) type bulbs to avoid damaging the headlamp.
Always replace a failed bulb with a new bulb with the same type andspecification.

Practical information
158
Changing direction indicator bulbs
)Turn the bulb holder a quar ter of a turn and extract it. )Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverse order.
Changing dipped beam headlamp bulbs
)Remove the protective cover by pulling the
tab. )Disconnect the bulb connector. )Spread the springs to release the bulb.)Pull the bulb out and change it.
To r e f i t , c a r ry out these operations in reverse order.

Rapid flashing of the direction indicator warning lamp (right or left) indicates thefailure of a bulb on that side.
When refitting, close the protective cover carefully to preser ve the sealing
of the headlamp.

Amber coloured bulbs, such as thedirection indicators, must be replacedwith bulbs of identical specificationsand colour.

11
Practical information
159
Changing main beam headlampbulbs
)Remove the protective cover by pulling on
the tab. )Disconnect the bulb connector. )Spread the springs to release the bulb.)Remove the bulb and change it.
To r e f i t , c a r ry out these operations in reverseorder.
Changing sidelamp bulbs
)
Remove the protective cover by pulling on
the tab.) Pull the bulb holder pressing on the tabs on both sides. )
Pull the bulb and change it.
To r efit, carry out these operations in reverse order.

11
Practical information
161
Rear lamps
1.Brake / sidelamps (P21/5W).2.Direction indicators (PY21W amber).3. Foglamp, right-hand side (PR21W red)Reversing lamp, left-hand side (P21W).
Changing bulbs
These four bulbs are changed from inside the boot: ) spread the four tabs and remove the bulb holder,
)
turn the bulb a quar ter of a turn and change it.
To r efit, carry out these operations in reverseorder.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
) open the boot,)
remove the access flap from the
corresponding side trim panel, )
unscrew the butterfly nut securing the lamp unit, )
unclip the lamp unit connector,)
extract the lamp unit carefully pulling in its
middle towards the outside,
Amber or red bulbs, such as thosefor the direction indicators and rear foglamp, must be replaced by bulbs of the same rating and colour. The lamps on the tailgate are dummyunits. They are there for aestheticpurposes only.

Practical information
162
bulbs (W5W)
)Insert a thin screwdriver into one of theouter holes of the lens.)Push it outwards to unclip.
)Remove the lens.)Pull the bulb out and change it.
Third brake lamp (4 W5W bulbs)
) Open the boot. )
Remove the plugs A
on the inner panel.)
Push on the centre of the lamp using
tw
o screwdrivers to lever it outwards.) Disconnect the connector and if necessary
the screenwash pipe from the lamp.) Turn the bulb holder for the faulty bulb a quar ter of a turn. )
Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverseorder.

11
Practical information
163

Interior lamp (1 / W5W)


Side readin
g lamps (2 / W5W)
Central storage lamp (W5W)Boot lamp (W5W)


Unclip the cover of the interior lamp 1with a
thin screwdriver, close to the button, to access
the faulty bulb.

Unclip the cover of the readin
g lamp 2with asmall screwdriver at the switch end for access
to the faulty bulb.
Unclip the unit b
y pushing it from the rear.

Glove box lamps (W5W)
Unclip the lamp to access the bulb. Unclip the lamp to access the bulb.