2013 Citroen C3 ignition

Monitoring
32
Maximum coolant temperaturefixed red. The temperature of the coolingsystem is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or qualified workshop.
Engine oil
pressure
fixed. There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.
Battery chargefixed.The battery charging circuit has a fault (dir ty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Low fuel levelfixed.When it first comes on there remainsapproximately 5 litres offuelin thetank.You must refuel as soon as possible to avoid runnin
gout of fuel.
This warning lamp will come on every time the ignition
is switched on
, until a sufficient addition of fuel is made.
Fuel tank capacity: approximately 50 litres (petrol),
46 litres (Diesel) or 37 litres (LPG); depending on
version: approximately 30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this could damage the emission control and injectionsystems.
Warning lampis onCauseAction / Observations

1
Monitoring
33
Airbags

temporarily. This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.

fix
ed. One of the airbag or seat belt pretensioner systems has a fault. Have it checked by a CITROËN dealer or a qualified
workshop.
Seat belt not fastened / unfastened
fixed then flashingaccompanied by an
increasing audiblesignal.The driver and
/or the front passenger has not fastened or has unfastenedtheir seat belt.
Pull the strap then inser t the tongue in the buckle.
Door(s) open

fixed if the speed is
below 6 mph (10 km/h). A door or the boot is still open. Close the door or boot.

fixed and accompaniedby an audible signalif the speed is above6 mph (10 km/h).
Warning lampis onCauseAction / Observations

1
Monitoring
35
System which informs the driver when the next ser vice is due, in accordance with themanufacturer's servicing schedule.
The point at which the ser vice is due is
calculated from the last indicator zero reset. Itis determined by two parameters:


- the distance travelled,

- the time elapsed since the last ser vice.
Between 600 miles (1 000 km)and 1800 miles (3 000 km) remainbefore the next service is due
For a few seconds after the ignition is switched
on, the spanner symbolising the ser vice
operations comes on. The distance recorder
display line indicates the distance remainingbefore the next service is due.
Example:
1 700 miles (2 800 km) remain before the next service is due.


Less than 600 miles (1 000 km)remain before the next service is due
Example:560 miles (900 km) remain before
t
he next service is due.
For a few seconds after the ignition is switched on, the display indicates:
For a
few seconds after the ignition is switched
on, the screen indicates:
A few seconds after the i
gnition is switched on, the spanner goes off; the distance recorder fresumes its normal operation. The screen thenindicates the total and trip distances.
A few seconds after the ignition is switched on, the distance recorder resumes its normaloperation. The spanner remains on
toindicate that a service must be carried out soon.


More than 1800 miles (3000 km)remain before the next service is due

When the ignition is switched on, no ser vice
information appears in the screen.
Service indicator

Monitoring
36
For a few seconds after the ignition is switched on,the spanner flashes to indicate that the service must be carried out as soon as possible.Example:the ser vice is overdue by 180 miles (300 km).
For a few seconds after the ignition is switched
on, the display indicates:

A few seconds after the ignition is switched
on, the distance recorder resumes its normaloperation. The spanner remains on.
Service indicator zero reset

After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is as
follows: ) switch off the ignition,)
press and hold the trip distance recorder
zero reset button,) switch on the ignition; the distance recorder display begins a countdown, )
when the display indicates "=0", release
the button; the spanner disappears.
Retrieving the serviceinformation

You can access the ser vice information at anytime. )Press the trip distance recorder zero reset button.
The ser vice information is displayed for a
few seconds, then disappears.
The distance remaining may be weighted by the time factor, dependingon the driver's driving habits. Therefore, the spanner may also comeon if you have exceeded the period since the last service, indicated in the MAINTENANCE AND WARR ANT YGUIDE.


Following this operation, if you wish todisconnect the battery, lock the vehicleand wait at least five minutes for thezero reset to be taken into account.
Service overdue

1
Monitoring
37
Engine oil level indicator

This information is displayed for a few seconds
when the ignition is switched on, after theservice information.
Oil level correct
This is indicated by the flashing of "OIL", linked with the ser vice warning lamp, accompanied
by an audible signal and a message in the
multifunction screen.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to prevent damage to the engine.
Oil level low

This is indicated by the flashing of "OIL--" . Contact a CITROËN dealer or a qualified
workshop.

Oil level indicator fault

Dipstick


There are 2 marks on the
dipstick:


- A= max; never exceed this
level (risk of damage to the engine), -B= min; top up the level via
the oil filler cap, using thegrade of oil suited to your engine. R
efer to the "Checks" section to locate the
dipstick and the oil filler cap on your engine.

The level shown will only be correctif the vehicle is on level ground and
the engine has been off for more than 30 minutes.

Monitoring
38
System which measures the total distance
travelled by the vehicle during its life.
The total and trip distances are displa
yed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
v
ehicle is locked or unlocked.
) With the ignition on, press the button until
zeros appear.



Tr ip distance recorder
System which measures a distance travelledduring a day or other period since it was reset
to zero by the driver.
Clock

Adjusting the time - Choice of units
To a djust the time of the clock and choose the
units used by the screen, use the right-hand
button on the instrument panel, carrying out the
operations in the following order: )press the button for more than two seconds:
the minutes flash, )press the button to increase the minutes, )press the button for more than two seconds:
the hours flash, )press the button to increase the hours,)press the button for more than two seconds:
24H or 12H is displayed,)press the button to select 24H or 12H, )press the button for more than two seconds:

Monitoring
42
Tr ip computer, a few definitions
Range
(miles or km)The distance which can still be
travelled with the fuel remainingin the tank. Related to theaverage fuel consumption over
the last few miles (kilometres)
travelled.
Current fuel consumption
(mpg or l/100 km or km/l) Calculated over the last few seconds.


Average fuel consumption
(mpg or l/100 km or km/l)
Calculated since the last trip
computer reset.
Average speed
(mph or km/h)Calculated since the last trip computer reset.

Distance travelled
(miles or km)
Calculated since the last tripcomputer reset.

When the ran
ge falls below 20 miles (30 km),
dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (10 0 km).


Distance remaining to destination
(miles or km)
This is the distance remaining to be
travelled to the final destination. Itcan be entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.

Stop & Start time counter
(minutes / seconds or hours /
minutes) If your vehicle is fitted with Stop &Start, a time counter calculates the
time spent in STOP mode during ajourney. It resets to zero every time the
ignition is switched on with the key.



If dashes are displayed continuously while driving in place of the digits, contact a CITROËN dealer or a qualified workshop.


This value may vary following a changein the style of driving or the relief,resulting in a significant change in thecurrent fuel consumption.
This function is only displayed from 20 mph (30 km/h).

Comfort
64





Mirrors
Each fitted with an adjustable mirror glasspermitting the lateral rearward vision necessary for overtaking or parking. They can also befolded for parking in confined spaces.

Adjustment
)
Move control Ato the right or to the left to select the corresponding mirror. )
Move control Bin all four directions toadjust. )
Return control Ato the central position.



Folding
)From outside: lock the vehicle using the
remote control or the key. )From inside: with the ignition on, with the control A
in the central position, pull itdownwards.


Unfolding
)From outside: unlock the vehicle using theremote control or the key. )From inside: with the ignition on, with the control A
in the central position, pull itdownwards.Demisting - Defrosting
If your vehicle is fitted with heated mirrors, the
demisting-defrosting operates with the engine running, by switching on the heated rear screen (refer to the "Rear screen demist-defrost"page).
Door mirrors
The objects obser ved are, in reality, closer than they appear.Take this into account in order to correctly judge the distance of vehicles
approaching from behind.


If the mirrors are folded using control A ,they will not unfold when the vehicle is unlocked. Pull again on control A.

The folding and unfolding of the door mirrors using the remote control can bedeactivated by a CITROËN dealer or a qualified workshop.
Never fold or unfold the electric foldingmirrors manually.