Page 11 of 284
.Familiarisation
9
1. Steering lock and ignition. 2.Audio equipment steering wheel controls.3.Wiper / screenwash / trip computer controlstalk.4.
Microphone.
5. Scented air freshener.
6.Central locking switch.
7. Multifunction screen.
8.Hazard warning lamps switch. 9.
Central adjustable air vents.10.Sunshine sensor
Hi-Fi audio system central speaker.11. Passenger's airbag.12 .
Side adjustable air vent.13.Glove box / Passenger's airbag deactivation / Audio/video sockets.14.Parking brake.15.Central armrest with storage. 16.
Upper and lower storage.17.Audio system or eMyWay. 18.Heating / air conditioning controls.
Instruments and controls
Page 32 of 284

Monitoring
30
reading the associated message in the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the following warning lamps indicates a fault whichrequires action on the par t of the driver.
STOPfixed, alone or
associated withanother warning lamp,accompanied by anaudible signal anda message on the screen. Illumination of the warnin
g lamp is
associated with a serious braking system or engine coolant temperature problem. Stop as soon as it is safe to do so as the en
gine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Servicetemporarily. Minor problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown in
the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control batter
y,
- saturation of the par ticle emission filter on Diesel
vehicles
(see the "Checks - Particle emissions
filter" section).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed.Major problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown
in the screen and contact a CITROËN dealer or a
qualified workshop.
Warning lampis onCauseAction / Observations
Page 140 of 284
Checks
138
Petrol engines
Screenwash fluid reservoir.2.
Coolant header tank.3.
Air filter.4.
Brake fluid reservoir.5.
Battery.
6.Fusebox.7. Engine oil dipstick. 8.Engine oil filler cap.
Page 141 of 284
10
Checks
139
Diesel engines
1.
Screenwash fluid reservoir. 2.Coolant header tank.3.Air filter.4.
Brake fluid reservoir.
5. Battery.
6.Fusebox.7. Engine oil dipstick.8.Engine oil filler cap.
9.
Priming pump (on fuel filter).
Page 143 of 284

10
Checks
141
Additive level (Diesel with
particle emissions filter
)
According to your version of instrument panel,
the additive reser voir low level is indicated by:
To p p i ng up
The reser voir must be topped up without delay
by a CITROËN dealer or a qualified workshop.
Used products
- fixed illumination of the particleemissions filter warning lamp,
accompanied by an audible signal, or
- fix
ed illumination of the servicewarning lamp, accompanied byan audible signal and a message
that the par ticle emissions filter additive level is too low.
Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.
Avoid prolonged contact of used oil or fluids with the skin.
Most of these fluids are harmful tohealth or indeed very corrosive.
Coolant level
The coolant level should be close
to the "MA X" mark but should never exceed it.
When the en
gine is warm, the temperature of
the coolant is regulated by the fan.
Changing the coolant
The coolant does not have to be changed.
Fluid specifi cation
The coolant must conform to themanufacturer's recommendations.
Top up the level when necessary.
The cooling fan may star t after switching off the engine: take care with ar ticles and clothing that might become caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off theengine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up t
he level.
Screenwash fluid level
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this
fluid must not be topped up or replaced with plain water.
Page 164 of 284