2011 TOYOTA AYGO lock

ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE151
NOTICE
zThe system will not allow shifting
to the “R” position if the vehicle
speed is over 6 km/h (3 mph). In
case the shift lever is operated un-
der this condition, the “N” indicator
in the instrument cluster will blink.
However, when the vehicle speed
drops below 6 km/h (3 mph), the
gear is shifted to reverse. Make
sure that the vehicle has stopped
completely before shifting to the
“R” position.
zOn an uphill, never hold the vehicle
stop only by the accelerator pedal
operation or when the starting as-
sist system is being activated.
Otherwise the warning buzzer
(pulse sound) will sound and the
clutch may be damaged. In such a
case, pull over and shift the shift
lever to the “N” position. Wait for
around 15 minutes to cool the
clutch before starting again.
zIf the gear cannot be engaged to
reverse when the shift lever is
shifted from the “N” to “R” posi-
tion, try to shift the shift lever to
the “N” position once, then shift it
to “R” position a few seconds later.
(e) Stopping
The vehicle can be stopped by depressing
the brake pedal regardless of the gear
position. This is because the clutch is
automatically disengaged to prevent the
engine from stopping. If the shift lever is
in the “M” position, the gear will be down-
shifted to 1st when the vehicle stops.
However, if you do not drive the vehicle
over 40 km/h (24 mph) or convert the
drive position after starting with the gear
in 2nd, the gear will not be downshifted
to 1st when the vehicle stops the next
time and the gear is left in 2nd.
In case the driver ’s door is opened with
the gear in “M”, “E” or “R” position and
without depressing the brake pedal, a
warning buzzer (long pulse sound) will
sound.
When the engine switch is “ON” and the
vehicle speed is slower than 9 km/h (5
mph), the shift lever will be locked if the
shift lever is in “N” position and the brake
pedal is released for approximately 2 sec-
onds.
Shift lock system is designed for prevent-
ing the vehicle from starting off by the
unintended activation of the starting assist
system.
The shift lock can be released by de-
pressing the brake pedal without holding
the shift lever.
11 02.18
AYGO WE 99E37E

ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE153
MS16008
1: Uphill
2: Level or downhill
To stop the engine:
Check the transmission gear position by
the gear position indicator, then turn the
engine switch off to stop the engine. Re-
lease the brake pedal after a few sec-
onds. The shift lever will be locked in the
position just before the engine switch was
turned off.
You can check the gear position by the
gear position indicator within 5 seconds
after turning the engine switch off.
CAUTION
DIf the gear is not engaged properly
and completely before the engine
switch is turned off, the vehicle
may not be parked with the gear
engaged. Always confirm the gear
position with the gear position indi-
cator when parking.
DOn a level surface or a downhill,
the gear should be put in reverse,
and in the “M(1)” or “E(1)” on an
uphill. Otherwise, the vehicle may
move, and cause an unexpected ac-
cident. If the gear is left in the “N”
position, the vehicle can not be
parked with the gear engaged.
(g) Cancel from parking with gear
Depress the brake pedal, and turn the en-
gine switch to the “ON” position. The shift
lever lock will be released.
Then, shift the shift lever to the “N” posi-
tion. The gear will be disengaged.
11 02.18
AYGO WE 99E37E

160ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE
Parking brake
MS16002b
When parking, firmly apply the parking
brake to avoid inadvertent creeping.
To set: Pull up the lever. For better hold-
ing power, first depress the brake pedal
and hold it while setting the parking
brake.
To release: Pull up the lever slightly (1),
press the lock release button (2), and low-
er (3).
To remind you that the parking brake is
set, the parking brake reminder light in
the instrument cluster remains on until you
release the parking brake.
CAUTION
Before driving, be sure the parking
brake is fully released and the park-
ing brake reminder light is off.
11 02.18
AYGO WE 99E37E

AUDIO SYSTEM163
AUDIO CONTROL
This function is to adjust the tone or bal-
ance. Push the “AUDIO CONT” button to
switch to the audio control mode. To
switch to the BAS, TRE, FAD, or BAL,
push the “AUDIO CONT” button. To adjust
each mode, push the “TUNE/TRACK (
)” button.
BAS: Adjusts low−pitched tones
TRE: Adjusts high−pitched tones
FAD: Adjusts the sound balance be-
tween the instrument panel and
front door speakers
BAL: Adjusts the sound balance be-
tween the right and left speakers
YOUR RADIO ANTENNA
To remove an antenna, carefully turn it
counterclockwise.
NOTICE
zTo prevent damage to the antenna,
be sure to remove it before driving
your Toyota through an automatic
car wash.
zWhen storing the vehicle in a ga-
rage, remove the antenna if it
touches the ceiling.
YOUR COMPACT DISC PLAYER
When you insert a disc, gently push it in
with the label side up. The compact disc
player will play from track 1 through to
the end of the disc. Then it will play from
track 1 again.
NOTICE
Never try to disassemble or oil any
part of the compact disc player. Do
not insert anything other than com-
pact discs into the slot.
The player is intended for use with 12 cm
(4.7 in.) disc only.
MS17003
AUX
Portable music players, such as compact
disc and MD players, can be listened to
through the car stereo speakers by con-
necting a player to the AUX port located
on the audio front panel.
AYGO WE 99E37E11 02.18

AUDIO SYSTEM165
123456(Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station. (See “TUNE/TRACK”
button). Push and hold down the button
until you hear a beep—this will set the
station to the button. The button number
will appear on the display.
To recall a preset station: Push the button
for the station you want. The button num-
ber and station frequency will appear on
the display.
These systems can store one AM and
three FM station for each button. (The
display will show “AM”, “FM1”, “FM2” or
“FM3” when you push “AM/FM”.) The pre-
set station memory will be canceled out
if the power source is interrupted. (Battery
disconnected or fuse blown.)
(Eject button)
Push this button to eject a compact disc.
After you turn the engine switch to
“LOCK”, you will be able to eject a com-
pact disc but you will not be able to rein-
sert it.
TUNE/TRACK (Tuning/Track up/down)
Radio
Tuning:
Quickly push and release the “”or“”
button. Each time you push the button,
the radio will step up or down to another
frequency. If you hear a beep, you held
the button too long and the radio will go
into the seek mode.Seeking:
Push and hold the “”or“” until you
hear a beep. The radio will begin seeking
up or down for a station of the nearest
frequency and will stop on reception. Each
time you push the button, the stations will
be searched automatically one after anoth-
er.
Compact disc player
By using this button, you can either skip
up/down to a different track or fast for-
ward/reverse the track you are listening
to.
Skip up/down tracks:
Quickly push and release the “”or“”
button. The track number will appear on
the display. If you hear a beep, you held
the button too long, and the player will
fast forward or reverse a track.
Fast forward/reverse tracks:
Push and hold the “
”or“” until
you hear a beep. While you are holding
the button, the player will fast forward/re-
verse the track. When you release the
button, the player will resume playing.
“
”(Power)
Push “
” to turn the audiosystem on
and off. The audio power can be turned
on only once even when the key is not
in the engine switch. The power, however,
will automatically turn off when 30 minutes
have elapsed.
VOL (Volume)
The volume can be adjusted by pushing
the “”or“” button.
AYGO WE 99E37E11 02.18

170AUDIO SYSTEM
If the TP signal is halted for 20 seconds
after the TP mode was set, the radio will
seek another TP station automatically.
When listening to a tape or compact disc:
Push “TA” to switch the radio mode to TA.
“TA” will appear on the display.
When the traffic information program
starts, the “CD” mode is interrupted and
the traffic information is automatically
broadcasted. When the program ends, the
initial operation resumes.
“TA” volume memory function—The volume
at receiving the traffic announcement is
memorized.
The range of volume memory is limited:
if the volume received previously is grater
than the maximum range of the volume,
this will become the maximum range and
if it is less than the minimum, this volume
will be the minimum range.
You can adjust the volume independently
from the memorized “TA” volume range
while receiving a “TA” station.
To return to the normal mode from the TA
mode, push “TA” once again.
NOTICE
To ensure correct audio system op-
erations:
zBe careful not to spill beverages
over the audio system.
zDo not put anything other than a
cassette tape or CD into the cas-
sette tape slot or CD slot.
zThe use of a cellular phone inside
or near the vehicle may cause a
noise from the speakers of the au-
dio system which you are listening
to. However, this does not indicate
a malfunction.
RADIO RECEPTION
FM broadcasts have a range of about 40
km or 25 miles. When driving away from
a station, you may have to fine−tune the
radio and turn up the volume as the sta-
tion gets weaker. Because FM uses a
line−of−sight signal, tall buildings or hills
may sometimes block reception. These
are all normal characteristics of FM recep-
tion and do not indicate any problem with
the radio itself.
AYGO WE 99E37E11 02.18
Audio system operating hints

180AIR CONDITIONING SYSTEM
Air flow selector settings
MS18002d
: On some models
Operating tips
DTo cool off your Toyota after it has
been parked in the hot sun, drive with
the windows open for a few minutes.
This vents the hot air, allowing the air
conditioning to cool the interior more
quickly.
DMake sure the air intake grilles in front
of the windshield are not blocked (by
leaves or snow, for example).
DKeep the area under the front seats
clear to allow air to circulate through-
out the vehicle.
DOn cold days, set the fan speed to
high for a minute to help clear the
intake ducts of snow or moisture. This
can reduce the amount of fogging on
the windows.
DWith air conditioning:When driving
on dusty roads, close all windows. If
dust thrown up by the vehicle is still
drawn into the vehicle after closing the
windows, it is recommended that the
air intake selector be set to FRESH
and the fan speed selector to any set-
ting except “
”(OFF).
DWith air conditioning:If following
another vehicle on a dusty road, or
driving in windy and dusty conditions,
it is recommended that the air intake
selector be temporarily set to RECIR-
CULATE, which will close off the out-
side passage and prevent outside air
and dust from entering the vehicle inte-
rior.
DDuring use, various odors from inside
and outside the vehicle may enter into
and accumulate in the air conditioning
system. This may then causeodor to
be emitted from the vents.
DTo reduce potential odors from occur-
ring:
It is recommended that the air condi-
tioning system be set to outside air
mode prior to turning the vehicle off.
AYGO WE 99E37E11 02.18

AIR CONDITIONING SYSTEM181
CAUTION
To prevent the windshield from fog-
ging up, do not select the windshield
air outlets during cool air operation
in extremely humid weather. The dif-
ference between the temperature of
the outside air and that of the wind-
shield can cause the outer surface of
the windshield to fog up, blocking
your vision.
NOTICE
To prevent battery discharge, do not
leave the air conditioning system on
longer than necessary when the en-
gine is stopped.
Heating
For best results, set controls to:
With air conditioning—
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sWARM
(red zone)
Air intake—FRESH(outside air)
Air flow—FLOOR
Air conditioning—OFF
Without air conditioning—
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sWARM
(red zone)
Air flow—FLOOR
DWith air conditioning:For quick heat-
ing, select recirculated air for a few
minutes. To keep the windows from
fogging, select fresh after the vehicle
interior has been warmed.
DWith air conditioning:Press the “A/C”
button on for dehumidified heating.
DWith air conditioning:Choose floor/
windshield air flow to heat the vehicle
interior while defrosting or defogging
the windshield.
Air conditioning (with air conditioning)
For best results, set controls to:
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sCOLD
(blue zone)
Air intake—FRESH(outside air)
Air flow—PANEL
Air conditioning—ON
DFor quick cooling, move the air intake
selector to recirculate for a few min-
utes.
AYGO WE 99E37E11 02.18