2011 TOYOTA AYGO lock

OCCUPANT RESTRAINT SYSTEMS105
MS13062a
To install the junior seat:
Sit the child on a junior seat. Run the lap
and shoulder belt through or around the
junior seat and across the child following
the instructions provided by its manufac-
turer and insert the tab into the buckle
taking care not to twist the belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on the child’s hips. See “Seat belts” on
page 48 for details.
CAUTION
DAlways make sure the shoulder belt
is positioned across the center of
child’s shoulder. The belt should be
kept away from child’s neck, but
not falling off child’s shoulder.
Otherwise, the child may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
DBoth high−positioned lap belts and
loose−fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintendedevent.
Keep the lap belt positioned as low
on a child’s hips as possible.
DFor child’s safety, do not place the
shoulder belt under child’s arm.
DAfter inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
DDo not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.
DIf the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact any authorized Toyota deal-
er or repairer, or another duly quali-
fied and equipped professional, im-
mediately. Do not install the child
restraint system on the seat until
the seat belt is fixed.
AYGO WE 99E37E11 02.18

11 0OCCUPANT RESTRAINT SYSTEMS
CAUTION
DWhen using the exclusive fixing bar
for the child restraint system, be
sure that there are no irregular ob-
jects around the bars or that the
seat belt is not caught.
DPush and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
DDo not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
AYGO WE 99E37E11 02.18

11 2STEERING WHEEL AND MIRRORS
MS13019
To change the steering wheel angle,
hold the steering wheel, push down the
lock release lever, tilt the steering
wheel to the desired angle and return
the lever to its original position.
CAUTION
DDo not adjust the steering wheel
while the vehicle is moving. Doing
so may cause the driver to mishan-
dle the vehicle and an accident may
occur resulting in death or serious
injuries.
DAfter adjusting the steering wheel,
try moving it up and down to make
sure it is locked in position.
INFORMATION
Vehicles with electric power steering
system:
When the steering wheel is turned, a
motor operating sound (whining
sound) may be heard. This occurs
when the power steering motor works
and is not defective.
MS13020
Adjust the mirror so that you can just
see the side of your vehicle in the mir-
ror.
CAUTION
Do not adjust the mirror while the
vehicle is moving. Doing so may
cause the driver to mishandle the ve-
hicle and an accident may occur re-
sulting in death or serious injuries.
AYGO WE 99E37E11 02.18
Tilt steering wheel Outside rear view mirrors—

11 6LIGHTS, WIPERS AND DEFOGGER
Headlights and turn signals
MS14001b
HEADLIGHTS
To turn on the following lights: Twist
the headlight/turn signal lever knob.
Position 1—Position, tail, license plate and
instrument panel lights
Position 2—Headlights and all of the
above
However, on some models, all the lights
above also turn on when the engine is
started with the headlight switch off.
The headlight low beam indicator light
(green light) on the instrument cluster will
tell you that the low beams are on.
Adjust the headlight beam level before
turning on the headlights. (See “Headlight
beam level control” on page 117.)
Light reminder buzzer
A buzzer will remind you to turn the lights
off when the driver ’s door is opened if the
engine switch is turned to the “LOCK”
position with the headlights switch on.
NOTICE
To prevent the battery from being dis-
charged, do not leave the lights on
for a long period when the engine is
not running.
MS14002b
High−Low beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight low beam indicator light
(green light) on the instrument cluster will
tell you that the low beams are on.
The headlight high beam indicator light
(blue light) on the instrument cluster will
tell you that the high beams are on.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
with the knob turned to “OFF”.
AYGO WE 99E37E11 02.18

120LIGHTS, WIPERS AND DEFOGGER
Windshield wiper and washer
MS14008a
To turn on the windshield wiper, move
the lever to the desired setting.
The engine switch must be in the “ON”
position.
Lever position
Speed setting
Position 1Intermittent
Position 2Slow
Position 3Fast
For a single sweep of the windshield,
push the lever up and release it.
To squirt washer fluid, pull the lever
toward you.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
In freezing weather, warm the windshield
with the defroster before using the washer.
This will help prevent the washer fluid
from freezing on your windshield, which
could block your vision.
NOTICE
Do not operate the wiper if the wind-
shield is dry. It may scratch the
glass.
MS14009a
To turn on the rear window wiper, twist
the lever knob upward. (Position 1)
The engine switch must be in the “ON”
position.
To squirt washer fluid on the rear window,
twist the knob upward or downward as far
as it will go (position 2 or 3). The knob
automatically returns from these positions
after you release it.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
NOTICE
Do not operate the rear wiper if the
rear window is dry. It may scratch the
glass.
AYGO WE 99E37E11 02.18
Rear window wiper and
washer

GAUGES, METERS AND SERVICE REMINDER INDICATORS129
(a) Brake System Warning Light
This light comes on in the following cases
when the engine switch is in the “ON”
position.
DWhen the parking brake is applied...
This light comes on for a few seconds
when the engine switch is turned to the
“ON” position even after the parking brake
is released.
DWhen the brake fluid level is low...
CAUTION
It is dangerous to continue driving
normally when the brake fluid level is
low.
Have your vehicle checked at any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped
professional, in the following cases:
DThe light does not come on even if the
parking brake is applied when the en-
gine switch is in the “ON” position.
DThe light does not come on even if the
engine switch is turned on with the
parking brake released.
A warning light turning on briefly during
operation does not indicate a problem.
CAUTION
If either of the following conditions
occurs, immediately stop your vehicle
at a safe place and contact any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped
professional.
DThe light does not turn off even
after the parking brake is released
while the engine is running.
In this case, the brakes may not
work properly and your stopping
distance will become longer. De-
press the brake pedal firmly and
bring the vehicle to an immediate
stop.
DThe brake system warning light re-
mains on together with the “ABS”
warning light.
In this case, not only the anti−lock
brake system will fail but also the
vehicle will become extremely un-
stable during braking.
(b) Driver ’s Seat Belt Reminder Light
and Buzzer
The light and buzzer act as a reminder to
buckle up the driver ’s seat belt.
Once the engine switch is turned to “ON”
or “START”, the reminder light flashes if
the driver ’s seat belt is not fastened. Un-
less the driver fastens the belt, the light
continues flashing.
If the vehicle speed rises above 20 km/h
(12 mph) with the seat belt unfastened,
the buzzer will sound for 30 seconds.
Then, if the seat belt is still unfastened,
the buzzer will sound in a different tone
for 90 more seconds. Even if the vehicle
speed drops below 20 km/h (12 mph), the
buzzer will continue to sound. To stop the
buzzer, fasten the seat belt. If the buzzer
still sounds, make sure the front passen-
ger ’s seat belt is fastened.
AYGO WE 99E37E11 02.18

130GAUGES, METERS AND SERVICE REMINDER INDICATORS
(c) Front Passenger ’s Seat Belt
Reminder Light and Buzzer
The light and buzzer act as a reminder to
have the front passenger buckle up the
seat belt.
Once the engine switch is turned to “ON”
or “START”, the reminder light flashes if
a passenger sits in the front passenger
seat and does not fasten the seat belt.
Unless the front passenger fastens the
belt, the light continues flashing.
If the vehicle speed rises above 20 km/h
(12 mph) with the seat belt unfastened,
the buzzer will sound for 30 seconds.
Then, if the seat belt is still unfastened,
the buzzer will sound in a different tone
for 90 more seconds. Even if the vehicle
speed drops below 20 km/h (12 mph), the
buzzer will continue to sound. To stop the
buzzer, fasten the seat belt. If the buzzer
still sounds, make sure the driver ’s seat
belt is fastened.
If luggage or other load is placed on the
front passenger seat, depending on its
weight and how it is placed on the seat,
built−in sensors in the seat cushion may
detect the pressure, causing the reminder
light to flash and buzzer to sound.
(d) Charging System Warning Light
This warning light comes on when the
engine switch is turned to the “ON” posi-
tion, and goes off when the engine is
started.
When there are problems in the charging
system while theengine is running, the
warning light comes on.
NOTICE
When the charging system warning
light comes on while the engine is
running, malfunctions such as the en-
gine drive belt being broken may have
occurred. If the warning light comes
on, immediately stop the vehicle in a
safe place and contact any authorized
Toyota dealer or repairer, or another
duly qualified and equipped profes-
sional.
(e) Low Engine Oil Pressure Warning
Light
This light warns that the engine oil pres-
sure is too low.
If the engine oil pressure warning light
comes on, pull off the road to a safe
place and stop the engine immediately.
Call any authorized Toyota dealer or re-
pairer, or another duly qualified and
equipped professional, for assistance. The
“STOP” warning light also comes on at
thesametime.
The light may occasionally flicker when
the engine is idling or it may come on
briefly after a hard stop. There is no
cause for concern if it then goes out when
the engine is accelerated slightly.
The light may come on when the engine
oil level is extremely low. It is not de-
signed to indicate low engine oil level, and
the engine oil level must be checked us-
ing the level dipstick.
NOTICE
Do not drive the vehicle with the
warning light on—even for one block.
It may ruin the engine.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS131
(f) Malfunction Indicator Lamp
This lamp warns that there is a problem
somewhere in your engine electrical sys-
tem.
If it comes on while you are driving, have
your vehicle checked/repaired by any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped pro-
fessional, as soon as possible.
On some models—
This lamp comes on in the following
cases.
a. There is a problem somewhere in your
engine, automatic transmission electri-
cal system or electronic throttle control
system.
b. The fuel tank is completely empty.
(See “Fuel gauge” on page 124 in this
Section for instructions.)
If it comes on while you are driving in
case a, have your vehicle checked/re-
paired by any authorized Toyota dealer or
repairer, or another duly qualified and
equipped professional, as soon as pos-
sible.
Vehicles with multi−mode manual transmis-
sion or vehicle stability control system—
If engine speed does not increase when
the accelerator pedal is depressed, there
may be a problem somewhere in the elec-
tronic throttle control system.
At this time, vibration may occur. Howev-
er, if you depress the accelerator pedal
more firmly and slowly, you can drive your
vehicle at low speeds. Have your Toyota
checked by any authorized Toyota dealer
or repairer, or another duly qualified and
equipped professional, as soon as pos-
sible.
Even if the abnormality of the electronic
throttle control system is corrected during
low speed driving, thesystem may not be
recovered until the engine is stopped and
the engine switch is turned to “ACC” or
“LOCK” position.CAUTION
Be especially careful to prevent erro-
neous pedal operation.
(g) “STOP” Warning Light
This light will come on when the engine
switch is turned to the “ON” position. After
a few seconds, the light will blink. When
the engine is started, the light will go off.
This means thesystem of the “STOP”
warning operating properly.
This light blinks in the following cases:
DWhen the engine coolant temperature
becomes high and the engine coolant
temperature warning light blinks. If the
engine coolant temperature rises fur-
ther, the engine coolant temperature
warning light remains on and at the
same time, the “STOP” warning light
blinks. In such cases, the engine is too
hot. If your vehicle overheats, stop the
vehicle and allow the engine to cool
down.
DWhen the engine oil pressure is too
low, the low engine oil pressure warn-
ing light comes on and at the same
time, the “STOP” warning light blinks.
In this case, pull off the road to a safe
place and stop the engine immediately.
Call any authorized Toyota dealer or re-
pairer, or another duly qualified and
equipped professional, for assistance.
(h) Low Fuel Level Warning Light and
Buzzer
The warning light blinks and the warning
buzzer comes on when the fuel level in
the tank becomes nearly empty. Fill up
the tank as soon as possible.
On incline or curves, due to the move-
ment of fuel in the fuel tank, the warning
light may blinks and the warning buzzer
may come on earlier than usual.
AYGO WE 99E37E11 02.18