2010 JAGUAR XFR torque

Vehicles with roof opening panel

13. NOTES:


Note the different lengths of screws.


Make sure that the component is installed to the
position noted on removal.
Torque: 2 Nm

Vehicles without roof opening panel

14. NOTES:


Note the different lengths of screws.


Make sure that the component is installed to the
position noted on removal.
Torque: 2 Nm




















All vehicles

15.

19.

































20.
CAUTION: Note the fitted position of the component
prior to removal.


NOTE: Make sure that the component is installed to
the position noted on removal.




























CAUTIONS:


Make sure that the clips are correctly located.


Note the fitted position of the component prior to
removal.
NOTES:


Make sure that this component is installed to the
noted removal position.


Federal vehicles only.

Torque: 9 Nm

21. WARNING: The SRS electrical connectors are unique.
DO NOT force, or attempt to connect electrical connectors
to the wrong sockets.


CAUTION: Note the fitted position of the component
prior to removal.
NOTES:


Make sure that the component is installed to the
noted removal position. www.JagDocs.com

Some variation in the illustrations may occur, but the
essential information is always correct.
Torque: 9 Nm
Installation


1. CAUTION: Make sure that the component is correctly located on the
locating pegs.
To install, reverse the removal procedure.

2. If a new component has been installed, configure using Jaguar approved
diagnostic equipment.

Pedestrian Protection System - Pedestrian Impact Sensor
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011

1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).




Installation

2. Torque: 3 Nm
1. To install, reverse the removal procedure. www.JagDocs.com

Published: 11-May-2011
Pedestrian Protection System - Pedestrian Protection Hood Actuator LH
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

2. Remove the cowl vent screen.

Refer to: Cowl Vent Screen (501-02 Front End Body Panels, Removal and Installation).




Installation

3. Torque: 8 Nm
1. Install is the reverse of removal.

Published: 11-May-2011
Pedestrian Protection System - Pedestrian Protection Hood Actuator RH
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

2. Remove the cowl vent screen.

Refer to: Cowl Vent Screen (501-02 Front End Body Panels, Removal and Installation).




Installation
3. NOTE: Left-hand shown, right-hand similar.
Torque: 8 Nm
1. Install is the reverse of removal.

6. Secure the radiator assembly.











7.
Special Tool(s): 303-1436 Torque: 40 Nm
























8. CAUTIONS:


Support the engine on a jack. The angle may need to be adjusted during this procedure.


Make sure to protect the paintwork.

Special Tool(s): 303-021 Special Tool(s): 303-1436