2010 JAGUAR XFR Bolt

15.

16.
17.
18. Install the special tool to support the rear subframe.

















NOTE: Left-hand shown, right-hand similar.
Remove the rear subframe rear retaining bolt.














NOTE: Left-hand shown, right-hand similar.
Remove the rear subframe front retaining bolt.












Remove the rear subframe.

2. Install new nuts to the stabilizer bar links.
Tighten to 48 Nm.















3. Install the rear subframe.
4. NOTE: Left-hand shown, right-hand similar.
Loosely install the rear subframe front bolt.













5. Loosely install the rear subframe rear bolt.

6. NOTE: Left-hand shown, right-hand similar.

Loosely install the rear subframe reinforcement plate bolts.













7. Tighten the subframe bolts.
Tighten to 80 Nm + 240°.















8. Remove the special tool.
9. Tighten the rear subframe reinforcement plate retaining bolts.
Tighten to 47 Nm.

Vehicles with diesel engine
7.
8.
All vehicles


9.
Remove the support bracket.
Remove the bolts.
Detach the intermediate muffler exhaust hanger
insulators.















Loosen the catalytic converter to diesel particulate filter
(DPF) retaining clamps.




















CAUTION: Make sure that the exhaust system is
supported with a suitable transmission stand.

Lower the exhaust assembly sufficiently to gain access to
the driveshaft heat shield.
Release the 6 exhaust hangers.

Centre bearing retaining bolts 48 36 - Transmission flexible joint retaining bolts 127 94 - Rear drive axle CV joint retaining bolts 73 54 - Driveshaft heat shield retaining bolts 7 - 62

Installation

1. CAUTION: Only tighten the bolts finger-tight at this
stage.























2. NOTE: Make sure that the alignment mark on the
driveshaft is correctly aligned to the alignment mark on the
differential case.

Torque: 75 Nm

Differential fluid - vehicles without supercharger Castrol SAF XO (75W 90) Differential fluid - vehicles with supercharger Castrol BOT 720 (75W 90) Initial Specifications
Item Specification Differential fluid capacity - vehicles without supercharger 0.9 Liters Differential fluid capacity - vehicles with supercharger 1.3 Liters Service Specifications
Item Specification Differential fluid capacity - vehicles without supercharger 0.85 Liters Differential fluid capacity - vehicles with supercharger 1.25 Liters Torque Specifications
Description Nm lb-ft lb-in Differential case front retaining bolt 90 66 - Differential case rear retaining bolts 192 142 - Differential filler plug 27 20 - Differential drain plug 27 20 - Halfshaft constant velocity joint nut 300 221 - Driveshaft retaining bolts 73 54 - www.JagDocs.com

Thrust race 7 Shim 8 Thrust plate 9 Dished washer 10 Bolt (10 off) 11 Clutch basket 12 Multi-plate clutch and pressure disc 13 Differential case 14 Screw (2 off) 15 Bearing assembly 16 Oil seal 17 Oil slinger inner 18 Oil slinger outer 19 Input flange 20 Pinion nut 21 Collapsible spacer 22 Shim 23 Bearing assembly 24 Pinion shaft 25 Mounting insulator inner (2 off) 26 Mounting insulator rubber (2 off) 27 Mounting insulator outer (2 off) 28 Carrier 29 Oil seal 30 Drain plug 31 Vent 32 Breather cap 33 Shim 34 Bearing assembly 35 Drive gear 36 Shim 37 RH sun gear 38 Circlip 39 Thrust washer (4 off) 40 Planet gear (4 off) 41 Pin (2 off) 42 Shaft 43 LH sun gear 44 Shim 45 Bearing assembly 46 Shim 47 Dowel (2 off) 48 Bolt (4 off) 49 Reduction gear casing 50 Reduction gear 51 Shaft 52 Temperature sensor 53 O-ring seal 54 Motor 55 Screw (4 off) 56 Cover 57 Output actuator locking pin 58 Bolt (9 off)