2008 NISSAN TEANA window

PWC-80
< SYMPTOM DIAGNOSIS >
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPERATE
PROPERLY
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPER-
ATE PROPERLY
Diagnosis ProcedureINFOID:0000000003857788
1.CHECK DOOR SWITCH
Check door switch.
Refer to PWC-27, "
ComponentFunctionCheck".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI-35, "Intermittent Incident".
NO >> GO TO 1.

PWC-82
< SYMPTOM DIAGNOSIS >
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
Diagnosis ProcedureINFOID:0000000003826048
1.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch.
>> Refer to PWC-85, "
Removal and Installation".

POWER WINDOW SWITCH DOES NOT ILLUMINATE
PWC-83
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
MA
B
PWC
N
O
P
POWER WINDOW SWITCH DOES NOT ILLUMINATE
Diagnosis ProcedureINFOID:0000000003826049
1.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch.
>> Refer to PWC-85, "
Removal and Installation".

POWER WINDOW MAIN SWITCH
PWC-85
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
MA
B
PWC
N
O
P
ON-VEHICLE REPAIR
POWER WINDOW MAIN SWITCH
Exploded ViewINFOID:0000000003826052
Removal and InstallationINFOID:0000000003826053
REMOVAL
1. Remove the power window main switch finisher (2).
Refer to INT-30, "
DRIVER SIDE : Exploded View" and INT-30,
"DRIVER SIDE : Removal and Installation".
2. Power window main switch (1) is removed from power window
main switch finisher (2) using flat-bladed screw driver (A) etc.
CAUTION:
Never fold the pawl of power window main switch finisher.
INSTALLATION
Install in the reverse order of removal.
NOTE:
If power window main switch is exchanged or is detached, it is necessary to perform the initialization proce-
dure.
Refer to PWC-6, "
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Require-
ment".
1. Power window main switch 2. Power window main switch finisher
JMKIA2558ZZ
JMKIA2559ZZ

PWC-86
< ON-VEHICLE REPAIR >
FRONT POWER WINDOW SWITCH (PASSENGER SIDE)
FRONT POWER WINDOW SWITCH (PASSENGER SIDE)
Exploded ViewINFOID:0000000003857778
Removal and InstallationINFOID:0000000003857779
REMOVAL
1. Remove the front power window switch finisher (passenger
side) (2).
Refer to INT-33, "
PASSENGER SIDE : Exploded View" and INT-
33, "PASSENGER SIDE : Removal and Installation".
2. Front power window switch (passenger side) (1) is removed
from front power window switch finisher (passenger side) (2)
using flat-bladed screw driver (A) etc.
CAUTION:
Never fold pawl of front power window switch finisher (passen-
ger side).
INSTALLATION
Install in the reverse order of removal.
1. Front power window switch
(passenger side)2. Front power window switch finisher
(passenger side)
JMKIA2560ZZ
JMKIA2561ZZ

REAR POWER WINDOW SWITCH
PWC-87
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
MA
B
PWC
N
O
P
REAR POWER WINDOW SWITCH
Exploded ViewINFOID:0000000003857780
Removal and InstallationINFOID:0000000003857781
REMOVAL
1. Remove the rear power window switch finisher (2).
Refer to INT-36, "
Exploded View" and INT-36, "Removal and
Installation".
2. Rear power window switch (1) is removed from rear power win-
dow switch finisher (2) using flat-bladed screw driver (A) etc.
CAUTION:
Never fold pawl of rear power window switch finisher.
INSTALLATION
Install in the reverse order of removal.
1. Rear power window switch 2. Rear power window switch finisher
JMKIA2562ZZ
JMKIA2563ZZ

DIAGNOSIS SYSTEM (BCM)
RF-9
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
L
MA
B
RF
N
O
P
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)INFOID:0000000003812848
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
×: Applicable item
NOTE:
 *1:At model with Intelligent Key system this item is displayed, but is not used.
 *2: This item is displayed, but is not used. Diagnosis mode Function Description
Work Support Changes the setting for each system function.
Self Diagnostic Result Displays the diagnosis results judged by BCM.
CAN Diag Support MonitorMonitors the reception status of CAN communication viewed from BCM. Refer to CONSULT-III opera-
tion manual.
Data Monitor The BCM input/output signals are displayed.
Active Test The signals used to activate each device are forcibly supplied from BCM.
Ecu Identification The BCM part number is displayed.
Configuration Read and save the vehicle specification.
 Write the vehicle specification when replacing BCM.
System Sub system selection itemDiagnosis mode
Work Support Data Monitor Active Test
Door lock DOOR LOCK×××
Rear window defogger REAR DEFOGGER××
Warning chime BUZZER××
Interior room lamp timer INT LAMP×××
Remote keyless entry system
MULTI REMOTE ENT*
1×××
Exterior lamp HEAD LAMP×××
Wiper and washer WIPER××
Turn signal and hazard warning lamps FLASHER×××
—
AIR CONDITONER*
2
 Intelligent Key system
 Engine start systemINTELLIGENT KEY×××
Combination switch COMB SW×
Body control system BCM×
NVIS - NATS IMMU××
Interior room lamp battery saver BATTERY SAVER×××
Back door opener system TRUNK××
Vehicle security system THEFT ALM×××
RAP system RETAINED PWR×
Signal buffer system SIGNAL BUFFER××
TPMS TPMS (AIR PRESSURE MONITOR)×××

BCM (BODY CONTROL MODULE)
RF-21
< ECU DIAGNOSIS >
C
D
E
F
G
H
I
J
L
MA
B
RF
N
O
P
DOOR SW-RLRear LH door closed Off
Rear LH door opened On
DOOR SW-BKNOTE:
The item is indicated, but not monitored. Off
CDL LOCK SWOther than power door lock switch LOCK Off
Power door lock switch LOCK On
CDL UNLOCK SWOther than power door lock switch UNLOCK Off
Power door lock switch UNLOCK On
KEY CYL LK-SWNOTE:
The item is indicated, but not monitored. Off
KEY CYL UN-SWNOTE:
The item is indicated, but not monitored. Off
KEY CYL SW-TRNOTE:
The item is indicated, but not monitored. Off
HAZARD SWHazard switch is OFF Off
Hazard switch is ON On
REAR DEF SW
NOTE:
At model with BOSE au-
dio system this item is in-
dicated, but is not
monitored.Rear window defogger switch is OFF Off
Rear window defogger switch is ON On
TR CANCEL SWNOTE:
The item is indicated, but not monitored. Off
TR/BD OPEN SWTrunk lid opener switch OFF Off
While the trunk lid opener switch is turned ON On
TRNK/HAT MNTRTrunk lid closed Off
Trunk lid opened On
RKE-LOCKLOCK button of the key is not pressed Off
LOCK button of the key is pressed On
RKE-UNLOCKUNLOCK button of the key is not pressed Off
UNLOCK button of the key is pressed On
RKE-TR/BDTRUNK OPEN button of the key is not pressed Off
TRUNK OPEN button of the key is pressed On
RKE-PANICNOTE:
The item is indicated, but not monitored. Off
RKE-P/W OPENNOTE:
The item is indicated, but not monitored. Off
RKE-MODE CHGLOCK/UNLOCK button of the key is not pressed and held simulta-
neouslyOff
LOCK/UNLOCK button of the key is pressed and held simulta-
neouslyOn
OPTICAL SENSORBright outside of the vehicle Close to 5 V
Dark outside of the vehicle Close to 0 V
REQ SW -DRDriver door request switch is not pressed Off
Driver door request switch is pressed On
REQ SW -ASPassenger door request switch is not pressed Off
Passenger door request switch is pressed On Monitor Item Condition Value/Status