2008 MITSUBISHI SHOGUN clock

General information
5
3. Open the fuel tank filler tube by slowly turning the cap
anticlockwise.
4. Insert the gun in the tank port as far as it goes. 5. When the gun stops automatically, do not fill with fuel
any more.
6. To close, turn the fuel tank filler tube cap slowly clock-
wise until you hear clicking sounds, then gently push thefuel tank filler door closed.
A- Remove B- Close
CAUTION
!●
Since the fuel system may be under pressure, remove the fuel tank fill
er tube cap slowly. This
relieves any pressure or vacuum that might have built up in the fuel tank. If you hear a hissing sound, wait until it stops before
removing the cap. Other-
wise, fuel may spray out,
injuring you or others.
CAUTION
!●
Do not tilt the gun.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 5 Wednesday, January 9, 2008 4:21 PM

2-32 Seat and seat belts
2
6. Put down the front end of the seat to the floor. In this situ-
ation, the seat locking syst
em is unlocked automatically.
7. Remove the covers (E) by turning the knob (F) anticlock-
wise.
G- Unlock H- Lock
BK-BK2008E1ENUK.en-uk-Section5.fm Page
32 Wednesday, January 9, 2008 4:28 PM

3-18 Instruments and controls
3
Type 1 Type 21- Digital clock
→ p. 3-19
Indicates the time.
2- Electronic compass*
This display shows the direction of the vehicle.
3- Frozen road warning
→ p. 3-27
Gives an indication when the outside temperature is 3 °C orlower.
4- Outside temperature
→ p. 3-26
5- Centre information display indications
Indicates details of each display.
6- Disc number
Shows the disc number. When no disc is inserted, it does notshow a disc number.
7- “INFO” button
Used to select various kinds of information for display.
8- Function buttons
Press this button to select options shown in the display.
9- “ADJ” button
Used for adjusting the clock and for selecting settings dis-plays.
10- Display for function buttons
This display shows the options available for each functionbutton.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
18 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-19
3
Adjusting the time
E00518000021
Following modes are available for clock adjustment: ●
For vehicles with MITSUBISHI genuine audio: “Automatic mode” and “Manual mode”
●
Except for vehicles with MITSUBISHI genuine audio: “Manual mode” only
Automatic mode (MITSUBISHI genuine audio)The automatic adjustment mode can set the local time automat- ically by using the signal from the local RDS stations. In this mode, “CT” (A) (Clock Time:
sent with the RDS signal) is
shown in the audio display.NOTE●
Automatic clock adjustment does not take place while a settings display is shown.
Manual modeThe manual mode is also avai
lable in case the automatic mode
shows the incorrect time when
the adjacent local RDS stations
are located in a different time zo
ne. Refer to “Radio data sys-
tem (RDS)” on page 5-27, 5-52. It is possible to manually adjust the time. Refer to “Changing the clock settings” on page 3-33.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
19 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-21
3
1- Audio information
→ p. 5-20, 5-43
2- Average fuel consumption
→ p. 3-22
3- Driving range
→ p. 3-23
4- Average speed
→ p. 3-25
5- Outside temperature
→ p. 3-26
6- Altimeter
→ p. 3-28
7- Barometer
→ p. 3-29
8- Calendar
→ p. 3-30
9- Clock-only
→ p. 3-31
10- Blank
→ p. 3-31
BK-BK2008E1ENUK.en-uk-Section6.fm Page
21 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-31
3
Clock-only
E00518900017
Only the clock is shown. The time notation can be changed to the setting you desire. (12 hour / 24 hour) Refer to “User customization” on page 3-46.
Blank
E00519000015
The whole display can be turned into blank. In this case, but- tons remain illuminated.NOTE●
If you operate the audio sy
stem, the audio display pops
up.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
31 Wednesday, January 9, 2008 4:32 PM

3-32 Instruments and controls
3
Selecting settings displays
E00519100045
Every time the “ADJ” button is pressed lightly, the display can be changed to the following:
CAUTION
!●
The driver should not opera
te the display while the
vehicle is in motion.
●
When operating the system,
stop the vehicle in a safe
area.
1- Changing the clock settings
→ p. 3-33
2- Adjusting the display brightness
→ p. 3-35
3- Correcting the compass*
→ p. 3-37
4- Changing the calendar setting
→ p. 3-42
5- User customization
→ p. 3-46
6- Adjusting the barometer
→ p. 3-54
BK-BK2008E1ENUK.en-uk-Section6.fm Page
32 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-33
3
Changing the clock settings
E00519200017
1. Press the “ADJ” butto
n to select the clock setting display.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
33 Wednesday, January 9, 2008 4:32 PM