2008 MITSUBISHI SHOGUN engine

5-6 For pleasant driving
5
Temperature control dial
E00703000403
Turn the temperature control di
al clockwise or anticlockwise.
The selected temperature will be
shown by the temperature dis-
play (A).NOTE●
While the engine coolant temp
erature is low, the tempera-
ture of the air from the heater will be cool/cold until the engine warms up, even if you have selected warm air withthe dial.
Air selection switch
E00703400436
To change the air selection,
simply press the air selection
switch. ●
Outside air: Indication lamp (A) is OFF Outside air is introduced into the passenger compartment.
●
Recirculated air: Indication lamp (A) is ON Air is recirculated inside the passenger compartment.
BK-BK2008E1ENUK.en-uk-Section8.fm Page 6 Wednesday, January 9, 2008 4:41 PM

5-8 For pleasant driving
5
Air conditioning switch
E00703500886
Push the switch to turn the air conditioning on, indication lamp (A) will come on. Push the switch again to switch it off.
NOTE●
If a problem is detected in
the air conditioning compres-
sor, the air conditioning operation indication lamp (A) blinks. Stop the vehicle in a sa
fe place, turn off the engine,
then restart the engine. If the air conditioning operationindication lamp does not blink, there is no problem. If it does brink, we recommend you to have it checked.
●
Sometimes, for example afte
r using a high-pressure car
wash, the condenser can get we
t, and the operation indica-
tion lamp (A) blinks temporarily. In this case there is nothing wrong. Stop the vehicl
e in a safe place, turn off
the engine, then restart the
engine. Once the water evapo-
rates, the blinking will stop.
CAUTION
!●
When using the air condit
ioning, the idling speed
may slightly increase as
the air conditioning com-
pressor is switched on/off
automatically. While the
vehicle with an A/T is st
ationary, fully depress the
brake pedal to prevent th
e vehicle from creeping.
BK-BK2008E1ENUK.en-uk-Section8.fm Page 8 Wednesday, January 9, 2008 4:41 PM

For pleasant driving
5-15
5
For quick demisting

1. Push the demister switch (A) to change to the “ ” posi-
tion.
2. Set the blower to the maximum speed. 3. Set the temperature to the highest position.NOTE●
When the demister switch is
pressed, the air conditioning
will operate automatically and the outside air position will also be selected automatically. (In this case, the air conditioning indication lamp will not change.)
●
To demist effectively, direct
the air flow from the side
ventilators towards the door windows.
●
Do not set the temperature control dial to the max. cool position. Cool air will blow against the window glassesand prevent demisting.
Rear heater* / Rear air conditioning
*E00704600015
The rear heater can be operated when the ignition switch is in the “ON” position. The rear air conditioning can only be used while the engine isrunning and the front air conditioning is switched on. When the front air conditioning is
not switched on, only blower
operation without cooling is possible.Control panel
E00704700016
1- Blower speed selection dial 2- Main switch 3- Temperature control dial
Ty p e A Ty p e B
BK-BK2008E1ENUK.en-uk-Section8.fm Page
15 Wednesday, January 9, 2008 4:41 PM

For pleasant driving
5-17
5
Blower speed selection dial
E00705300019
The blower has 3 different speeds.
Select the best speed to fit
your needs.
Temperature control dial
E00705500011
Ty p e A When the temperature is low and
you wish to increase the heat-
ing performance, turn the dial to the “ON” position.NOTE●
To avoid draining of the battery, only use it while the engine is running.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
17 Wednesday, January 9, 2008 4:41 PM

5-20 For pleasant driving
5
LW/MW/FM electronic tuning radio with
CD player
*
E00708500432
The audio system can be used when
the ignition switch is in the
“ON” or “ACC” position.NOTE●
To listen to the audio system while the engine is stopped, turn the ignition key to the “ACC” position.
●
If a cellular phone is used insi
de the vehicle, it may create
noise from the audio equipment. This does not mean thatanything is wrong with your audio equipment. In such a case, use the cellular phone at
a place as far as possible
from the audio equipment.
●
If foreign objects or water ge
t into the audio equipment, or
if smoke or a strange odour comes from it, immediately turn off the audio system. We recommend you to have itchecked. Never try to repair it by yourself. Avoid continu- ous usage without inspection by a qualified person.
Volume and tone control panel
E00708600114
1- PWR (On-Off) button 2- VOL (Volume control) button 3- Memory select buttons4- MENU button 5- Sound adjust button 6- Display
BK-BK2008E1ENUK.en-uk-Section8.fm Page
20 Wednesday, January 9, 2008 4:41 PM

For pleasant driving
5-43
5
LW/MW/FM electronic tuning radio with
CD autochanger
*
E00708500706
The audio system can be used when the ignition switch is in the “ON” or “ACC” position.NOTE●
To listen to the audio system while the engine is stopped, turn the ignition key to the “ACC” position.
●
If a cellular phone is used in
side the vehicle, it may create
noise from the audio equipment. This does not mean thatanything is wrong with your audio equipment. In such a case, use the cellular phone at a place as far as possible from the audio equipment.
●
If foreign objects or water get into the audio equipment, or if smoke or a strange odour comes from it, immediately turn off the audio system. We recommend you to have itchecked. Never try to repair it by yourself. Avoid continu- ous usage without inspection by a qualified person.
Volume and tone control panel
E00708600433
1- PWR (On-Off) button 2- VOL (Volume control) button 3- Memory select buttons4- MENU button 5- Sound adjust button 6- Display
BK-BK2008E1ENUK.en-uk-Section8.fm Page
43 Wednesday, January 9, 2008 4:41 PM

5-82 For pleasant driving
5
Cigarette lighter
*
E00711500713
The cigarette lighter can be used
while the ignition switch is in
the “ON” or “ACC” position. The cigarette lighter will automatically return to its original position with a “click” when ready. Pull it out for use. After use, insert the cigarette lighter to its original position inthe socket.NOTE●
Do not leave the cigarette light
er removed from its socket,
because the socket might
become clogged by foreign
material and be short-circuited.
1- Open the lid 2- Push all the way in.
CAUTION
!●
Do not touch the heating
element or the cigarette
lighter housing, hold the kn
ob only to prevent burns.
●
Do not allow children to op
erate or play with the cig-
arette lighter as burns may occur.
●
Something is wrong with th
e cigarette lighter if it
does not pop back out wi
thin approximately 30 sec-
onds of being pushed in.
We recommend you to have
it checked.
●
Do not use any electric
appliance that is not
approved by MITSUBISHI MOTORS. Doing so could damage the socket. If
you used the cigarette
lighter after damaging th
e socket, the cigarette
lighter might pop out or fail to come out after beingpushed in.
●
When the cigarette lighter so
cket is used as a power
source for an electric app
liance, be sure that the
electric appliance operates
at 12 V and has an elec-
tric capacity of 120 W or less. In addition, long use of the electric appliance
without running the engine
may run down the battery.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
82 Wednesday, January 9, 2008 4:41 PM

For pleasant driving
5-83
5
Accessory socket
E00711600701
The accessory socket can be us
ed while the ignition switch is
in the “ON” or “ACC” position.NOTE●
The two or more accessory sock
ets can be used simultane-
ously.
Ty p e 1Pull out the plug (A) in the instrument panel to uncover thesocket. Use it to plug in
an electrical device.
CAUTION
!●
Be aware that using electronic equipment with the engine off may run the battery down.
●
When you connect an electri
cal device, make sure it
is rated at 12 V and its el
ectrical capacity does not
exceed 120 W. When using some sockets at the same time, make sure the total power consumption of theelectrical accessories does
not exceed 120 W at 12 V.
●
When the accessory socket is not in use, be sure to close the cap or plug, because the socket mightbecome clogged by foreig
n material and be short-
circuited.
Instrument panel*
BK-BK2008E1ENUK.en-uk-Section8.fm Page
83 Wednesday, January 9, 2008 4:41 PM