Page 304 of 317

Service products and capacities
301
Even small amounts of diesel result in dam-
age to the injection system. Damage result-
ing from adding diesel is not covered by the
warranty.
More information about refuelling and fuels
can be found in the "Operation" section. Introduction to fuel consumption
The vehicle will use more fuel than usual in
the following situations:
R at very low temperatures
R in urban traffic
R on short trips
R in mountainous terrain
The consumption figures have been deter-
mined according to EU Directive
RL 80 /1268 /EEC.
i Onlyfor certai ncountries :the respective
current consumption and emission values
of your vehicl ecan be found in the COC
papers (EC-CERTIFICATE OF CONFORM-
ITY). Thes edocuments ar esupplie dwhen
the vehicl eisdelivered.
! Do not us eany special additives ,asthey
can cause malfunctions and engine dam- age. Damag
eresulting fro mthe us eofsuch
additives is not covered by the Mercedes-
Benz warranty. H
Environmental note
CO 2(carbo
ndioxide )ist he ga swhich sci-
entists believe to be principally responsible
for global warming (th egreenhouse effect).
Your vehicle' sCO
2emissions ar
edirectly
relate dtofuelconsumption and therefore
depend on:
R efficient us eofthe fuel by the engine
R driving style
R other non-technical factors ,suc hase nvi-
ronmenta linfluence sorroadc onditions
Yo uc an minimis eyourvehicle' sCO
2emis-
sions by driving carefull yand having it serv-
ice dregularly. Technica
ldata
230_AKB; 5; 4, en-GB
bjanott,
Version: 2.9.6 2008-04-08T15:09:54+02:00-Seite 301 ZDateiname: 6515_3089_02_buchblock.pdf; preflight
Page 306 of 317

Service products and capacities
303SL 280 SL 350 SL 500 SL 600 SL 63 AMG SL 65 AMG
Overall
(NEDC) 9.4 l/100 km 9.9 l/100 km 11.9 l/100 km 13.9 l/100 km 13.9 l/100 km 15.1 l/100 km
CO
2emis-
sions 224 g/km 236 g/km 284 g/km 330 g/km 330 g/km 362 g/km
Engine oil
Al ist of engine oils tested and approved in accordanc ewith the Mercedes-Benz Specification sfor Service Products is available from any
Mercedes-Benz Service Centre. Oils approved by Mercedes-Benz are indicated by the MB Sheet Number on the oil container. The table shows
which MB Sheet Number appliestow hich engine: SL 280
SL 350
SL 500 SL 600 SL 63 AMG SL 65 AMG
MB Sheet Number 229.3/229.5 229.5
229.5
37 229.5
37 i
In the event that the
R engine oil brand
R grade (MB sheet number)
R SAE classification (viscosity) of the oil currently in your vehicle is not
available, you can use another mineral or
synthetic engine oil which has been
approved by Mercedes-Benz.
Mixing oils reduces the benefits of high-
grade engine oil. !
Do not use lubricant additives, since they
can lead to increased wear and damage to
the mechanical assemblies. The use of
lubricant additives will result in arestriction
of your warranty.
37 Restriction :only SAE 0W-40 engine oils may be used. Technical data
230_AKB; 5; 4, en-GB
bjanott
,V ersion: 2.9.6
2008-04-08T15:09:54+02:00
-Seite 303 ZDateiname: 6515_3089_02_buchblock.pdf; preflight
Page 307 of 317

Service products and capacities
304
Capacities The following values refer to an oil change including the oil filter.
Engine with oil fil-
ter SL 280
SL 350 SL 500 SL 600 SL 63 AMG SL 65 AMG
Replacement
amount 8.0 l 8.5 l 8.0 l 8.0 l 8.0 l
Coolant
The coolant is amixture of water and anti-
freeze/corrosion inhibitor. It performs the
following tasks:
R anti-corrosion protection
R antifreez eprotection
R raising the boiling point
i When the vehicle is first delivered, it is
topped up with acoolant that will ensure
adequate antifreez eand corrosion protec-
tion.
! Only top up with coolant that has been
premixed with the desired antifreez epro-
tection. You could otherwise damage the
engine. There is more information about coolant
and topping it up on Mercedes-Benz Spec-
ifications for Service Products Sheet
310.1.
! Always use asuitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the cooling system will not be
sufficiently protected from corrosion ,and
the boiling point will be too low.
If antifreeze/corrosion inhibitor is present in
the correctc oncentration, the boiling point of
the coolant will be around 130 °C.
The antifreeze/corrosion inhibitor concentra-
tion in the cooling system should: R
be at least 50%. This will protect the cooling
system against freezingd own to around
–37 °C.
R not exceed 55% concentration (antifreeze
protection down to –45 °C), otherwise heat
will not be effectively dissipated.
If the vehicle has lost coolant, top it up with
equal amounts of water and antifreeze/cor-
rosion inhibitor. Mercedes-Benz recom-
mends using an antifreeze/corrosion inhibi-
tor which has been approved for Mercedes-
Benz.
! The cooling system contains afilling
which must be renewed after 15 years, or
after 250, 000 km at the latest. Have the
renewal confirmed in the Service Booklet.
The warranty is only valid if you top up with
an antifreeze/corrosion inhibitor which Technical data
230_AKB; 5; 4, en-GB
bjanott
,V ersion: 2.9.6
2008-04-08T15:09:54+02:00
-Seite 304 Dateiname: 6515_3089_02_buchblock.pdf; preflight
Page 309 of 317

Service products and capacities
306
Capacities The following values indicate the total cooling system capacities.
SL 280 SL 350 SL 500 SL 600 SL 63 AMG SL 65 AMG
Coolant 11.0 l 10.8 l 11.6 l 15 l 11.3 l 17.2 l
Amount of antifreeze/corrosion inhibitor required for antifreeze protection
Downto
–37 °C
(approx. 50%) 5.5 l 5.4 l 5.8 l 7.5 l 5.6 l 8.6 l
Downto
–45 °C
(approxi-
mately 55%) 6.0 l 5.9 l 6.4 l 8.3 l 6.2 l 9.5 l
Brake fluid
Over aperiod of time, the brake fluid absorbs
moisture from the air; this lowers its boiling
point. G
Risk of accident
If the boiling point of the brake fluid is too
low, vapour pocketsm ay form in the brake
system when the brakes are appliedh ard
(e.g. when driving downhill). This would
impair braking efficiency. Have the brake fluid renewed every two
years with
abrake fluid that has been
approved by Mercedes-Benz and have this
confirmed in the Service Booklet.
i There is usually anotic eint he engine
compartment to remind you when the next
brake fluid change is due. Windscreen washer system
The washer fluid reservoir holds approxi-
mately 7litres.
The headlamp cleaning system* and the
windscreen washer system are both supplied
from the washer fluid reservoir.
X At temperatures above freezing point:
top up the washer fluid reservoir with a
mixture of water and windscreen washer
concentrate (Y page 181).
X At temperatures below freezing point: Technical data
*optional
230_AKB; 5; 4, en-GB
bjanott
,V ersion: 2.9.6
2008-04-08T15:09:54+02:00
-Seite 306 Dateiname: 6515_3089_02_buchblock.pdf; preflight