2008 FORD C MAX lock

Downloaded from www.Manualslib.com manuals search engine Vehicles without keyless entrysystem
Press the upper part of the switchnext to the driver’s door handle.
Vehicles with keyless entrysystem
Press the lower part of the switchnext to the driver’s door handle.
DISARMING THE ALARM
The anti-theft alarm system can bedeactivated at any time – even whenthe alarm is sounding – by unlockingthe vehicle from the outside.
The anti-theft alarm system for thetailgate is deactivated if the tailgateis unlocked using the button on theremote control or passive key. Onvehicles with the Key Free System, itis deactivated if a passive key islocated within the tailgate detectionrange when the tailgate is opened.
After closure, the alarm is once againarmed.
Britain and Ireland only
If the vehicle is unlocked using thekey or the spare key for the keylessentry system, a 12 second delaychime starts as soon as the driver’sdoor is opened. The alarm should bedeactivated during this period.
Vehicles without keyless entrysystem
To deactivate the alarm, insert thekey into the ignition and turn it toposition II.
Vehicles with keyless entrysystem
The alarm should be deactivated inone of the following ways:
•If a valid passive key is locatedwithin the vehicle interior, depressthe clutch pedal (manualtransmission) or brake pedal(automatic transmission), pushthe ignition switch in and turn it toposition II.
•Insert the spare key into theignition switch, push the ignitionswitch in and turn it to position II.
•Press the unlock button on thepassive key.
54
AlarmE80555 E80556

Downloaded from www.Manualslib.com manuals search engine ADJUSTING THE
STEERING WHEEL
WARNING
Never adjust the steering wheelwhen the vehicle is moving.
Note:Make sure that you are sittingin the correct position. See Sittingin the correct position (page 120).
WARNING
Make sure that you fully engagethe locking lever when returningit to its original position.
HORN
The horn can also be operated whenthe ignition is off.
AUDIO CONTROL
Select radio, CD or cassette modeon the audio unit.
The following functions can beoperated with the remote control:
55
Steering wheel122E95178 3E95179 E78023

Downloaded from www.Manualslib.com manuals search engine INTERIOR LAMPS
Courtesy lamp
OffA
Door contactB
OnC
If you set the switch to position B, thecourtesy lamp will come on when youunlock or open a door or the luggagecompartment lid. If you leave a dooropen with the ignition switch off, thecourtesy lamp will go offautomatically after some time toprevent the vehicle battery fromdischarging. To switch it back on,switch on the ignition for a short time.
The courtesy lamp will also come onwhen you switch off the ignition. It willgo off automatically after a short timeor when you start or restart theengine.
If you set the switch to position Cwith the ignition switch off, thecourtesy lamp will come on. It will gooff automatically after a short time toprevent the vehicle battery fromdischarging. To switch it back on,switch on the ignition for a short time.
Reading lamps
If you switch off the ignition, thereading lamps will go off automaticallyafter some time to prevent thevehicle battery from discharging. Toswitch them back on, switch on theignition for a short time.
Vanity mirror lamps
OffA
OnB
72
LightingCBAE71945 E71946 ABE72900

Downloaded from www.Manualslib.com manuals search engine Disconnect the wiring connector.
Install in the reverse order.
Front direction indicators
PY21 watt spherical bulb, orange
•Turn the bulb holder anticlockwiseand pull out.
•Turn the bulb under slightpressure anticlockwise andremove it.
•Replace the bulb.
When installing, pay attention to theguide tabs.
Opening the headlampassembly (Type 1)
Note:When replacing the cover,ensure that no wires are trapped atthe seals and that the clips engagewith a distinct click.
Release the clips and remove thecover.
Opening the headlampassembly (Type 2)
Remove the rubber caps.
Headlamps – dipped beam(Type 1)
H7, 55 watt halogen bulb
75
LightingE78108 E78109 E91732

Downloaded from www.Manualslib.com manuals search engine •Disconnect the wiring connector.
•Release the wire clip, swivel it tothe side and pull out the bulb.
Install in the reverse order.
Headlamps – dipped beam(Type 2)
H7, 55 watt halogen bulb
•Turn the bulb holder anticlockwiseand pull it out.
•Pull out the bulb and replace it.
Install in the reverse order.
Headlamps – main beam
H1, 55 watt halogen bulb
•Disconnect the wiring connector.
•Release the wire clip, swivel itdown and pull out the bulb.
Install in the reverse order.
Side lamps
5 watt wedge base bulb
76
LightingE78110 E91734 E78111

Downloaded from www.Manualslib.com manuals search engine •Squeeze the clips on either sideof the bulb holder and pull it out.
•Carefully remove the bulb fromthe holder.
Install in the reverse order.
Side repeaters
5 watt spherical bulb
1.Carefully remove the siderepeater.
2.Hold the bulb holder, turn thehousing anti-clockwise andremove it.
3.Remove the bulb.
Side repeater indicator onexterior mirrors
WY5 watt wedge base bulb, orange
WARNING
The retainer tabs on the edgeof the scull cap are verydelicate. When removing andreinstalling the scull cap, take carenot to break them off.
Remove the scull cap by prising it outat the lower edge.
Insert your finger (or a screwdriver)into the hole and unhook theretaining clip. Remove the lampassembly.
77
LightingE78112 213E78869 E78114 E78115

Downloaded from www.Manualslib.com manuals search engine Remove the bulb holder from theassembly. Remove and replace thebulb.
Install in the reverse order. Whenreinstalling the scull cap, first insert itat the top and then press it down atthe bottom until it clicks into place.
Approach lamps
5 watt wedge base bulb
Carefully prise out the lamp assemblyat the outer edge and pull it out.
Turn the lamp housing anticlockwiseand remove it. Pull the bulb out.
Install in the reverse order.
Front fog lamps (Type 1)
H8, 35 watt halogen bulb
78
LightingE78116 E78117 E78118 E78119

Downloaded from www.Manualslib.com manuals search engine Brake lamp P21 wattA
Direction indicator PY21 watt(orange)B
Reversing lamp P21 wattC
Rear fog lamp/tail lampP21/4 WattD
Note:Vehicles may not have a taillamp if an LED board is fitted. TheLED board is not a serviceable item,please consult your dealer if this fails.
Turn the bulb anticlockwise underslight pressure and remove it.Replace the bulb.
Install in the reverse order. Afterinstallation, check that the lightsoperate correctly.
Central brake lamp
Consult an expert.
Number plate lamp
5 watt festoon
Loosen the two screws, and removethe lamp assembly.
Install in the reverse order.
Interior and reading lamps
Switch off the lights.
Insert a flat-bladed screwdriver intothe recess between the body of theunit and the lens at the opposite sideto the switches. Gently prise out thelens a short way. Take hold of theside of the lens and lift it off the unit.
81
LightingE78126 E72556 E7812812