2008 DODGE SPRINTER Owners Manual

175 Controls in detail
Operating system with steering wheel buttons*
3
Setting the windshield wiper
sensitivityYou can use the
Wipe sensor
function to
set the sensitivity of the rain sensor.
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
Vehicle

message in the display.
\1
Press the
j
or
k
button re-
peatedly until you see the
Wipe sen-
sor
message in the display.
The current setting is highlighted.
\1
Press the
æ
or
ç
button to
select the level of sensitivity of the
rain sensor.
\4
Level 1
: High sensitivity
Wiping beings in light rain
\4
Level 2
: Moderate sensitivity
\4
Level 3
: Low sensitivity
Wiping only begins in heavy rain
Convenience submenu
*
You can reach the
Convenience
submenu
via the
Settings
menu (
\2
page 161).
Key-dependent settingsYou can use the
Key
function to deter-
mine whether the settings in the:
\4
Instrument cluster
\4
Lighting
\4
Vehicle
submenus are stored as key-dependent
settings.
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
Conve-
nience
message in the display. N54.32-2272-31
nf_BA.book Page 175 Friday, January 25, 2008 3:53 PM

176 Controls in detailOperating system with steering wheel buttons*
3
\1
Press the
j
or
k
button re-
peatedly until you see the
Key
mes-
sage in the display.
The current setting is highlighted.
\1
Press the
æ
or
ç
button to
switch key dependence On or
Off
.The Trip computer menu displays statis-
tical data for your vehicle. N54.32-2273-31
iFor safety reasons, it is not possible
to set the
Key
function while the vehi-
cle is in motion. You will see the fol-
lowing message in the display:
Setting only possible at stand-
still
.
Trip computer menuFunction
Page
Consumption statistics after
start
177
Consumption statistics after
reset
177
Reset consumption statistics
178
iWhen you call up the trip computer
again, it always displays the con-
sumption statistics after start first.
The units of the trip computer are
country-specific and depend on the
setting in the
Instrument
submenu of
the
Settings
menu.
Function
Page
nf_BA.book Page 176 Friday, January 25, 2008 3:53 PM

177 Controls in detail
Operating system with steering wheel buttons*
3
Consumption statistics after start
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
After start
message in the display.
1Distance driven since start
2Time elapsed since start
3Average speed since start
4Average fuel consumption since start
Consumption statistics after reset
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
After start
message in the display.
\1
Press the
j
or
k
button re-
peatedly until you see the
After re-
set
message.
1Distance driven since last reset
2Time elapsed since last reset
3Average speed since last reset
4Average fuel consumption since last
reset
N54.32-2274-31
iIf you turn the key to position
0 in the
ignition lock or remove it, all the val-
ues are reset after approximately 4
hours.
The values will not be reset if you turn
the key back to position
1 or
2 during
this time.
N54.32-2275-31
nf_BA.book Page 177 Friday, January 25, 2008 3:53 PM

178 Controls in detailOperating system with steering wheel buttons*
3
Resetting the consumption statistics
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
After start
message in the display.
\1
Press the
j
or
k
button re-
peatedly until you see the statistics
that you want to reset in the display.
\1
Press and hold the reset button
until the values are reset to 0.You can operate your cell phone using
the functions in the
TEL
menu, provided
it is connected to the manufacturer’s
hands-free system*.
iThe consumption statistics after
start are automatically reset after
999 hours or 9,999 miles (kilome-
ters).
The consumption statistics after re-
set are automatically reset after
9,999 hours or 99,999 miles (kilome-
ters).
Telephone menu
*
Warning
G
You must observe the legal requirements
for the country in which you are driving
when operating a cell phone in the vehi-
cle.
Continued
nf_BA.book Page 178 Friday, January 25, 2008 3:53 PM

179 Controls in detail
Operating system with steering wheel buttons*
3
\1
Switch on the cell phone and audio
system.
See the separate operating instruc-
tions.
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
TEL
menu
in the display.
You will see different messages in
the display, depending on the status
of your cell phone:
\4
If the cell phone is switched off,
you will see the
TEL off
message
(Sound 20) .
\4
If you have not yet entered a PIN,
you will see the
TEL PIN
message
(Sound 20) .
\1
Enter the PIN code using the cell
phone, audio system.
The cell phone searches for a network. The
display remains blank during this time.As soon as the cell phone has found a
network, you will see the
Ready
message
in the display.
Once it has shown its operational readi-
ness, you can operate the cell phone us-
ing the operating system.
Warning (Continued)
G
If it is permitted to operate a cell phone
while the vehicle is in motion, you must
only operate it when road and traffic con-
ditions permit. You may otherwise be dis-
tracted from the traffic conditions, cause
an accident and injure yourself and oth-
ers.Cell phones without exterior antennas
may interfere with the vehicle electronics
and thereby jeopardize the operational
safety of the vehicle. You must therefore
only use these devices when they are con-
nected to a separate exterior antenna.
N54.32-2276-31
nf_BA.book Page 179 Friday, January 25, 2008 3:53 PM

180 Controls in detailOperating system with steering wheel buttons*
3
Rejecting a callIf you do not wish to speak to the person
who is calling, you can reject the call.\1
Press the
t
button.
The caller then hears the busy signal.
Accepting a callYou can accept a call at any time, provid-
ed the cell phone is ready to receive
calls. \1
Press the
s
button.
The call duration is shown in the dis-
play.
Ending a call
\1
Press the
t
button.
The display now shows the opera-
tional readiness symbol again.
Dialing a number from the phone
bookYou may select and dial a number from
the phone book at any time, provided
the cell phone is ready to receive calls.
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
TEL
menu
with the operational readiness sym-
bol in the display.
\1
Press the
j
or
k
button.
The operating system reads the
phone book stored on the SIM card
or in the phone. This may take more
than 1 minute.
You will see the
Processing
message
(Sound 20) in the display.
\1
Press the
j
or
k
button re-
peatedly until you see the name you
are looking for.
iIt is only possible to create new
phone number entries in the phone
book using the cell phone itself. See
the separate operating instructions.
nf_BA.book Page 180 Friday, January 25, 2008 3:53 PM

181 Controls in detail
Operating system with steering wheel buttons*
3
The stored names are displayed al-
phabetically from A to Z, or Z to A.
\1
Press the
s
button.
The operating system dials the se-
lected phone number. You will see
the
dialing
message (Sound 20) in
the display.
The operating system stores the
phone numbers in the redial memo-
ry.
If a connection is made, you will see
the name of the person you are call-
ing and the call duration.
RedialingThe operating system stores the most
recently dialed phone numbers. This
means that you do not have to search
through the entire phone book.\1
Press the
ÿ
or
è
button re-
peatedly until you see the
TEL
menu
with the operational readiness sym-
bol in the display.
\1
Press the
s
button.
The redial memory shows the most
recently dialed numbers or names.
iThe operating system scrolls through
the names rapidly if you press and
hold the
j
or
k
button for
more than one second. Releasing the
button stops the rapid scroll.
If you no longer wish to make a call,
press the
t
button.
nf_BA.book Page 181 Friday, January 25, 2008 3:53 PM

182 Controls in detailOperating system with steering wheel buttons*
3
\1
Press the
j
or
k
button re-
peatedly until the number or the
name you are looking for is dis-
played.
\1
Press the
s
button.
The operating system dials the se-
lected phone number.
If a connection is made, you will see
the call duration and name of the
person you are calling if stored in the
phone book. Otherwise, the number
you are dialing continues to be dis-
played.
iIf you no longer wish to make a call,
press the
t
button.
nf_BA.book Page 182 Friday, January 25, 2008 3:53 PM