2008 DODGE SPRINTER Owners Manual

207 Controls in detail
Automatic transmission
3
Trailer towing
\1
Run the engine in the moderate en-
gine speed range on steep uphill gra-
dients.
\1
Depending on the uphill or downhill
gradient, shift down to shift range
3
or
2 (\2
page 204), even if cruise
control* is switched on.
Working on the vehicleWarning
G
Apply the handbrake before working on
the vehicle and shift the automatic trans-
mission into parking positionP.
The vehicle could otherwise roll away.
nf_BA.book Page 207 Friday, January 25, 2008 3:53 PM

208 Controls in detailGood visibility
3
\3 Good visibilityBefore starting off, adjust the rear-view
mirror and the exterior mirrors in such a
way that you can get a good overview of
road and traffic conditions.Rear-view mirror*
\1
Adjust the rear-view mirror manually.
Setting the rear-view mirror to anti-
dazzle mode1Anti-dazzle lever\1
Flick anti-dazzle lever
1
to the rear.
Exterior mirrors
\1
Adjust the exterior mirrors manually.
Mirrors
Warning
G
The exterior mirrors reduce the size of the
image. Objects therefore appear further
away than they really are. You could
therefore cause an accident if you only
observe traffic in the exterior mirrors.
For this reason, you should pay attention
to traffic behind you by also using the
main exterior mirror and, if necessary, the
rear-view mirror, especially while maneu-
vering or overtaking.
nf_BA.book Page 208 Friday, January 25, 2008 3:53 PM

209 Controls in detail
Good visibility
3
Adjusting the exterior mirrors
electrically*The switch and button for adjusting the
exterior mirrors are located in the interi-
or trim of the driver’s door.
1Exterior mirror on the left-hand side
2Exterior mirror on the right-hand side
3Sets the mirror position\1
Switch on the ignition (
\2
page 111).
\1
Press left-hand side
1
of the switch
for the left-hand mirror or press
right-hand side
2
of the switch
for
the right-hand mirror.
\1
Press button
3
at the top or bot-
tom, right or left until you have ad-
justed the mirror to the correct
position.
nf_BA.book Page 209 Friday, January 25, 2008 3:53 PM

210 Controls in detailGood visibility
3
The combination switch is located on
the left of the steering wheel.1Single wipe
2To switch the windshield wipers on
Switching on the windshield wipers
\1
Turn key to position
1 in the ignition
lock (
\2
page 111).
\1
Turn the combination switch to the
required position in the direction of
arrow
2
depending on how heavy
the rain is:
0
Windshield wipers off
I
Intermittent wipe
II
Normal wipe
III
Rapid wipe
Windshield wipers
N54.25-2923-31
!
CAUTION
Vehicles with rain sensor*:
Switch off the windshield wipers in
dry weather conditions, otherwise
dirt on the surface of the rain sensor
or optical effects can cause inadvert-
ent wiper sweeps. This could dam-
age the wiper blades or scratch the
windshield.
iCanada only:
The speed of the windshield wipers is
automatically reduced if the vehicle
comes to a halt with the windshield
wipers switched on.
nf_BA.book Page 210 Friday, January 25, 2008 3:53 PM

211 Controls in detail
Good visibility
3
Single wipe
\1
Push the combination switch briefly
to the pressure point in the direction
of arrow
1
.
The windshield wipers wipe once
without washer fluid.
Wiping with washer fluid
\1
Press the combination switch be-
yond the pressure point in the direc-
tion of arrow
1
.
The windshield wiper will wipe with
windshield washer fluid.
Vehicles with headlamp cleaning
system*:
If the low-beam headlamps have
been switched on, a high-pressure
water jet also cleans the headlamps. For example, if you have selected
speed
II and stop the vehicle,the wip-
ers wipe at intermittent speed until
you pull away again. The wipe intervals
are longer in intermittent mode.
Vehicles with rain sensor*:
You can use speed
I as the universal
speed. The rain sensor adjusts the
wiping frequency according to how
heavy the rain is. If you stop the vehi-
cle, speeds
III and
II are automatical-
ly switched down to speed
I.
The original speed of the windshield
wipers is resumed when you drive
faster than 5 mph (8 km / h) again.
iWipe with windshield washer fluid even
when it is raining. By doing so you can
prevent smears on the windshield.
nf_BA.book Page 211 Friday, January 25, 2008 3:53 PM

212 Controls in detailGood visibility
3
Intermittent wipeOnly switch on intermittent wipe in
damp weather conditions or when it is
raining.
Vehicles with rain sensor*:
The a rain sensor is activated when you
switch on intermittent wipe. The appro-
priate wiping frequency is set automati-
cally according to the rain falling on the
sensor.The switch is in the combination switch
on the left of the steering wheel.
1Switch
2To wipe with windshield washer fluid
3Intermittent wipe
4To switch off the wiper
5To wipe with windshield washer fluid
\1
Turn key to position
1 in the ignition
lock (
\2
page 111).
Switching on intermittent wipe
\1
Turn switch
1
to
3
.
Switching off intermittent wipe
\1
Turn switch
1
to
4
.
Rear window wiper*
N54.25-2924-31
iThe rear window wiper switches on
automatically if you engage reverse
gear and the windshield wipers are
on.
nf_BA.book Page 212 Friday, January 25, 2008 3:53 PM

213 Controls in detail
Good visibility
3
Wiping with washer fluid
\1
Turn switch
1
to
5
or
2
and keep
it pressed until the window is clean.
The windshield heating is operational
while the engine is running.
The windshield heating consumes a lot
of energy. You should therefore switch
the heating off as soon as the windshield
is clear.
The heating switches off automatically
after approximately 5 minutes.The switch for the windshield heating is
on the center console.
1To switch on / off
Windshield heating*
Warning
G
Clear ice or snow from the windshield be-
fore commencing a journey. Iced-up win-
dows restrict your view. You could cause
an accident and endanger yourself and
others. Do not start the vehicle if the win-
dows are iced up, fogged up or covered in
snow.
N54.25-2920-31
nf_BA.book Page 213 Friday, January 25, 2008 3:53 PM

214 Controls in detailGood visibility
3
\1To switch on:
press upper part of
the
P
switch.
The indicator lamp in the switch
comes on.
\1To switch off:
press upper part of
the
P
switch again.
\1
The indicator lamp in the switch goes
out.
The rear window heating is operational
while the engine is running.
The rear window heating consumes a lot
of energy. You should therefore switch
the rear window heating off as soon as the window is clear. The heating switch-
es off automatically after a maximum of
12 minutes.
The switch for the rear window heating
is on the center console.
1To switch on / off
\1To switch on:
press upper part of
the
F
switch.
The indicator lamp in the switch
comes on.
\1To switch off:
press upper part of
the
F
switch again.
The indicator lamp in the switch goes
out.
Rear window heating*
N54.25-2921-31
nf_BA.book Page 214 Friday, January 25, 2008 3:53 PM