a.When pressing the rod, use a vertical vice certainly.
b. There is a high possibility for air to get in the high pressure chamber, when using a horizotal vice.
c. Do not apply more load than 400N on the rod.
d. Do not press the rod until its position is below 2.5mm from the body surface.
e. The projection of the rod is secured more than 2.5mm.
a.Repairing orders when disassembling the auto tensioner and reassembling it to the engine, or pulling
the pin out before its installation ;
a. Stand it vertically for about five minutes.
b. Press the rod with the force, 150~200N.
c. If the rod has a stiffness, press it slowly and insert the pin into the set hole.
d. If not(the tensioner is in 'sponge' state), press the rod slowly from its maximum projection to 2.9mm
position(the meeting point with the rod and the hole of the body) two or three times.
Afterwards, if stiffness is sensed, insert the pin into the hole. However, if not, scrap the tensioner.
(2) Install the auto tensioner(A) to the front case with the set- pin inserted.
Tightening torque
19.6 ~ 26.5Nm(2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb- ft)
4.Ensure the timing marks on the camshaft and the crankshaft sprockets.
5.Install the timing belt.
Crankshaft sprocket(A) → Idler(B) → Bank 2 exhaust camsprocket(C) → Water pump pulley(D) → Bank 1 exhaust
camsprocket(E) → Tensioner pulley(F).
