2007 KIA CARNIVAL sensor

2007 > 2.7L V6 GASOLINE >
DESCRIPTION
Output shaft speed sensor
- Type: Hall sensor
- Current consumption: 22mA (MAX.)
- Sensor body and sensor connector have been unified as one.
Hall type sensor: specification
Air gap (mm) Output shaft speed sensor 0.85
Coil Resistance Output shaft speed sensor over 1MΩ
Peak- Peak Voltage High
4.8~5.2V
Low 0.8V
Wave Form With High-scan
Hall Type Sensor: Structure & Interface

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove the battery and air cleaner. (see "Transaxle range switch replacement")
2. Remove the output shaft speed sensor(A).
(1) Disconnect the output shaft speed sensor connector(B).
(2) Remove the bolt(C).
(3) Inspect the output shaft speed sensor bore.
3. Apply a light coat of automatic transaxle fluid to the O - ring seal before installation.
4. Installation is the reverse of removal.

Transaxle Oil Temperature Sensor

2007 > 2.7L V6 GASOLINE >
DESCRIPTION
Oil Temperature Sensor
The oil temperature sensor is of the thermistor type, and senses the automatic transaxle fluid temperature. Using the
signal from this sensor, TCM(PCM) controls the shift pattern optimally during shift. In order to operate the damper
clutch, this signal is also referred.
- Range of temperature : - 40°C~145°C
- Type: Separated type (High / Low temperature)
- Standard value of internal resistance
Temp.[°C(°F)] Resistance(kΩ) Temp.[°C(°F)]Resistance(kΩ)
- 40(- 40) 139.580(176) 1.08
- 20(- 4) 47.7100(212) 0.63
0(32) 18.6120(248) 0.38
20(68) 8.1140(284) 0.25
40(104) 3.8160(320) 0.16
60(140) 1.98

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove the automatic transaxle assembly.
2. Remove the valve body cover(refer to the overhaul manual).
3. Disconnect the oil temperature sensor connector.
4. Remove the oil temperature sensor(B), loosening the mounting bolt(A).
5.Replace the sensor with the new one and reassemble the rest of the parts.
INSPECTION
1.Remove the oil temperature sensor(A).
2.Measure the resistance between the terminal 1 and 2 of the sensor connector.
Temp.[°C(°F)] Resistance(KΩ)
0(32)
100(212) 18.6
0.63
3.
If the value is out of the specfication, replace the oil temperature sensor.

5.Disconnect the vehicle speed sensor connector (A) and the back up lamp switch(B).
6.Disconnect the shift cable assembly(A) after remaing the clips(B) and pins(C).
7.Remove the wire harness bracket(A).

26.Install the wire harness bracket(b).
27.Install the shift cable assembly (A) with the clips(B) and pins(C).
28.Install the vehicle speed sensor connector (A) and the back up lamp switch(B).
29.Install the battery tray(B) by removing the four mounting bolts(A).

30.Install the air cleaner assembly(B) by tightening the two mounting bolts(A).
31.Reassemble the air cleaner filter, install the air cleaner upper body(B) and connect the air flow sensor
connector(A).
32.Install the battery(A).