2007 ISUZU KB P190 BATTERY

ELECTRICAL-BODY AND CHASSIS 8A-543



RUW 580SH001101

Remove Transmitter (Remote Key)
Replacing the battery in the transmitter (remote key)
Replace the battery(2) as soon as the range of the remote
control starts to become reduced.
Open the underside of the transmitter (remote key) by
removing the battery cover(1) with a screwdriver as shown in
the illustration.
Replace the battery, ensuring that it is inserted correctly.
Replace the battery cover so that it engages audibly. Make
sure that you dispose of old batteries in accordance with
environmental protection regulations.


RUW 580SH003901




BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-545
Power Door Lock System
General Description
The circuit consists of the door lock (& power window)
switch, door lock actuator for the front and rear door,
tailgate lock actuator and the door lock key switch.
The front door lock switch ‐RH is always provided with
the battery voltage.
The key or the inside lock button on both driver's and
front passenger's door can activate the lock mechanism
of all the doors (including the tailgate).
W hen the driver's door lock switch or the front
passenger's door lock switch is turned on, current flows
for about one second to the door lock actuator of each
door connected in parallel with the front door lock (&
power window) switch ‐LH to activate the actuator to
lock and unlock the doors.

Door Lock Key Switch
Removal and Installation
・ Refer to the Front Door Lock Assembly removal
and installation steps in this section.
Front Door Lock Actuator
Removal and Installation
・ Refer to the Front Door Lock Assembly removal
and installation steps in this section.
Rear Door Lock Actuator
Removal and Installation
・ Refer to the Rear Door Lock Assembly removal
and installation steps in this section.
Tailgate Lock Actuator
Removal and Installation
・ Refer to the Tailgate Lock Assembly removal and
installation steps in this section.

BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-547
Pin-outs









RUW 580SF000301

No. Pin Function
1 Door ajar switch
2 Door ajar indicator light
3 Tailgate switch
4 Test pin (Internal use only)
5 Key switch remote
6 Ignition switch
7 Battery
8 Hazard battery
9 Unlock
10 Lock
11 Front map light
12 Hazard-RH
13 Hazard-LH
14 Ground

BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-577
ANTI THEFT INDICATOR


Removal
1. Disconnect the battery ground cable.



RTW 78ASH001801
2. Remove the side ventilation grille (1).



RTW 78ASH001701
3. Disconnect the indicator connector and screw from the
backside of the side ventilation grille to remove the anti theft
indicator (1).


Installation
To install, follow the removal steps in the reverse order, noting
the following point.
1. Push in the switch with your fingers until it locks securely.


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-579
Remote key
Remove Key Assembly
Replacing the battery in the remote control unit
Replace the battery as soon as the range of the remote control
starts to become reduced.
Open the underside of the remote control unit by removing the
battery cover with a screwdriver as shown in the illustration.
Replace the battery, ensuring that it is inserted correctly.
Replace the battery cover so that it engages audibly. The
battery change must be performed within 3 minutes, otherwise
the remote control will have to be reprogrammed. Make sure
that you dispose of old batteries in accordance with
environmental protection regulations.
604RW 055




BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-625


No. Connector face No. Connector face
H1



White
Battery (+) ~ Engine room H7



WhiteEngine room ~ INST
H2


NOT USED H7
(4JJ1-TC)


White
Engine room ~ INST
H3
(HFV6
4JH1-TC)

Gray
Battery (+) ~ Engine room H8



NOT USED
H3
(4JA1T- (L))

Battery (+) ~ Engine room H9



WhiteEngine room ~ Chassis
H4
(HFV6)
(C24SE)
White
Engine room ~ Mission H10

~
H11 NOT USED
H4
(4JH1-TC)


White
Engine ~ Engine room H12



WhiteINST ~ Roof
H4
(4JJ1-TC)


White
Engine ~ Engine room H13



NOT USED
H5
(HFV6
4JH1-TC)

White
Engine room ~ Mission H14



WhiteRear body ~ Rear door-LH
H5
(4JJ1-TC
4JA1T-(L))


White
Engine ~ Engine room H15
(HFV6
4JH1-TC)

Black
Engine room ~ Chassis
H6


White
Engine room ~ INST H15
(4JJ1-TC,
4JA1T-(L))

Black
Engine room ~ Chassis


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-626 ELECTRICAL-BODY AND CHASSIS


No. Connector face No. Connector face
H16



White
Rear body ~ Rear door-RH H29
(C24SE)

Battery (+) ~ Engine room
H17


Gray
Chassis ~ License plate light H30



NOT USED
H18



White
Engine room ~ INST H31
(C24SE)

Engine room ~ Mission
H19
~
H22 NOT USED H32
(C24SE)


Engine room ~ Rear body
H23


White
Engine ~ Engine room B H33



WhiteEngine ~ Engine room
H23
(4JA1T- (L))
White
Engine room B ~ T/misson H34



BlackEngine ~ Engine room
H24
~
H25 NOT USED H35



Gray
Trailer hitch
H26


Black
INST ~ Rear body H36



WhiteINST ~ Front door-RH
H27


NOT USED H37



White
INST ~ Front door-LH
H28


White
Sub harness connector H38



WhiteINST ~ Front door-RH


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-630 ELECTRICAL-BODY AND CHASSIS


No. Connector face No. Connector face
P1



Silver
Battery (+) P9
(4JA1T- (L))
SilverACG (B)
P2


Silver
Relay & Fuse box P9
(4JH1-TC)


Silver
ACG (B)
P3


Black
Starter (S) P10



SilverEngine ground
P4
(HFV6)

Silver
Starter (B) P11



SilverFuse & relay box
P4


Silver
Starter (B) P12



NOT USED
P5



Silver
Battery (-) P13



Gray Shift on the fly actuator
P6


Silver
Body earth (Ground) P14



NOT USED
P7




Battery (ALT) P15



Silver2nd battery (+)
P8


Green
ACG (L)

P9
(HFV6)

Silver
ACG (B)



BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007