WW-36
< SERVICE INFORMATION >
REAR WIPER AND WASHER SYSTEM
1. Connect BCM connectors and rear wiper motor connector.
2. Turn ignition switch ON.
3. Turn rear wiper switch ON, then to OFF when wiper arm
reaches mid sweep.
4. Check voltage between rear wiper motor connector D704 termi-
nal 6 and ground.
OK or NG
OK >> Replace rear wiper motor. Refer to WW-37, "Rear Wiper
Motor".
NG >> Replace BCM. Refer to BCS-24, "
BCM".
Only Rear Wiper Does Not OperateINFOID:0000000003533579
1.CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make
sure "RR WIPER ON" turns ON-OFF according to operation of wiper
switch.
OK or NG
OK >> Replace BCM. Refer to BCS-24, "BCM".
NG >> Check the wiper switch. Refer to BCS-3, "
System
Description".
Only Rear Wiper Intermittent Does Not OperateINFOID:0000000003533580
1.CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make
sure "RR WIPER INT" turns ON-OFF according to operation of wiper
switch.
OK or NG
OK >> Replace BCM. Refer to BCS-24, "BCM".
NG >> Check the wiper switch. Refer to BCS-3, "
System
Description".
Wiper Does Not Wipe When Rear Washer OperatesINFOID:0000000003533581
1.CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make
sure "RR WASHER SW" turns ON-OFF according to operation of
rear washer switch.
OK or NG
OK >> Replace BCM. Refer to BCS-24, "BCM".
NG >> Check the wiper switch. Refer to BCS-3, "
System
Description". Battery voltage should exist on the reverse wipe un-
til arm is seated in the stop.
WKIA2098E
When rear wiper switch is in
ON position: RR WIPER ON ON
SKIA4248E
When rear wiper switch is in
INT position: RR WIPER INT ON
SKIA4249E
When rear wiper switch is in
WASHER position: RR WASHER SW ON
SKIA4250E
WW-42
< SERVICE INFORMATION >
POWER SOCKET
1. Disconnect battery negative terminal.
2. Remove inner socket from the ring, while pressing the hook on
the ring out from square hole.
3. Disconnect power socket connector.
4. Remove ring from power socket finisher while pressing pawls.
Installation
Installation is in the reverse order of removal.
Front Power Socket RH (For Cigarette Lighter), Console Power SocketINFOID:0000000003533592
REMOVAL AND INSTALLATION
Removal
1. Remove inner socket from the ring, while pressing the hook on
the ring out from square hole.
2. Disconnect power socket connector.
3. Remove ring from power socket finisher while pressing pawls.
Installation
Installation is in the reverse order of removal.
WKIA1035E
WKIA1035E
