2007.5 Citroen C5 DAG Owner's Manual

157
V
T A B L E O F F U S E S
Fuses under the bonnet
Ref.RatingFunction
F120AEngine control unit
F215AHorn
F310AScreen wash pump
F410AHeadlamp wash pump
F515AStarter
F610AAir fl ow meter - Directional headlamps - Diagnostic socket
F710AAutomatic gearbox lever lock - Power steering
F825AStarter
F910AClutch switch - STOP switch
F1030AStarter
F1140AAir conditioning blower
F1230AWipers
F1340ABSI supply (ignition on)
F1430A-
F1510ARight-hand main beam
F1610ALeft-hand main beam
F1715ARight-hand dipped beam
F1815ALeft-hand dipped beam
F1915AStarter
F2010AStarter
F215AStarter

158
V
F U S E S O N T H E B A T T E R Y
A L L E N G I N E S E X C E P T V 6 H Di
Fuses on the battery
To access the fusebox located on the battery, detach and remove the cover.
Ref.RatingFunction
F625ARear 12V socket
F715AFoglamps
F820AAdditional burner (Diesel)
F930AElectric parking brake
After a repair, take care to reclose the cover.
If the cover is not correctly posi-tioned or not properly closed, this could cause serious prob-lems on your vehicle. For the same reason, take care not to spill any liquid in the fusebox.

159
VI
A
F U E L
If you should put in fuel that is not suitable for your vehicle's engine type, it is imperative to have the tank drained be fore you start the engine again.
While you are refuelling, the engine must be stopped and the ignition switched off.
For a petrol engine with a cata-lytic converter, unleaded fuel is compulsory.
The fi ller neck is narrower to ensure that only unleaded petrol can be put in.
When you are seeking to fi ll your tank, do not persist after the third cut-off ; that could cause your vehicle to malfunction.
Fuel fl ap
To open, press at the top left-hand corner, then pull open from the left.
Locking fi ller cap*
Turn the key a quarter turn to lock and unlock the fi ller cap.
When refuelling, place the cap on hook A.
Fuel quality
A label inside the fi ller fl ap tells you which type of fuel to use.
The petrol engines are designed to run on RON 95.
However, for better perform-ance (petrol engine), we recom-mend RON 98.
Tank capacity
The tank has a capacity of approxi-mately 71 litres.

160
VI
BC
D
EFA
C H A N G I N G B U L B S
H E A D L A M P S
Front headlamp unit with Xenon bulbs (D1S)
Bulbs:A Sidelamp: W5WB Dual-function Xenon lamp (dipped/main): D1SC Angular lighting: HP19D Daytime-running lamp: HP24
For the maintenance of the front headlamp unit and the changing of HP19, D1S and HP24 bulbs, con-tact a CITROËN dealer, bulbs, .
Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to contact a CITROËN dealer if there is any problem.Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to Front headlamps fi tted with Xenon bulbs: Because of risks of electrocution, we advise you to
You are advised to change the D1S bulbs at the same time, if one of them has failed.
Sidelamp1 Lift up the pegs E to remove the cover on the headlamp.2 Remove the protective cap F.3 Pull the bulb holder to remove it.4 Replace the bulb and replace the bulb holder.
5 Replace the protective cap F.6 Replace the cover and fi x it in place using the pegs E.

161
VI
E
ADCBGF
C H A N G I N G B U L B S
H E A D L A M P S
Main beam1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap G.3 Disengage the retaining spring.4 Remove the bulb and replace it, paying attention to the direc-tion of fi tting.5 Replace the retaining spring.6 Replace the protective cap G.7 Replace the cover and fi x it in place using the pegs F.
Sidelamp1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap G.3 Pull the bulb holder to remove it.4 Replace the bulb and replace the bulb holder.5 Replace the protective cap G.6 Replace the cover and fi x it in place using the pegs F.
HEADLAMP UNIT
Bulbs:A Main beam: H1B Sidelamp: W5WC Dipped beam: H7D Bend lighting: H7E Daytime-running lamp: HP24
For the maintenance of the front headlamp unit and the changing of HP24 bulbs, contact a CITROËN headlamp unit and the changing of changing of
dealer.
Halogen bulbs must not be changed until they have been off for a few minutes (risk of serious burns).
Do not touch the bulb directly with your fi ngers, use a lint-free cloth.
It is essential that only anti-U.V. type bulbs are used in order not to damage the headlamp.

162
VI
HI
Dipped beam1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap H.3 Disconnect the connector by pressing it between the thumb and index fi nger.4 Free the bulb from its two metal clamps.5 Take out the bulb.6 Replace the bulb, exerting a slight axial force.7 Reconnect the connector, until it is all the way in.8 Replace the protective cap H.9 Replace the cover and fi x it in place using the pegs F.
Bend lighting1 Lift up the pegs F to remove the cover on the headlamp.2 Remove the protective cap I.3 Disconnect the connector by pressing it between the thumb and index fi nger.4 Free the bulb from its two metal clamps.5 Take out the bulb.6 Replace the bulb, exerting a slight axial force.7 Reconnect the connector, until it is all the way in.8 Replace the protective cap I.9 Replace the cover and fi x it in place using the pegs F.
C H A N G I N G B U L B S
H E A D L A M P S

163
VI
ABD1C
2
C H A N G I N G B U L B S
H E A D L A M P S
Front direction indicator1 Remove the fi xing screw of cover A, tip the cover over and remove.2 Remove the fi xing screw of lamp B and pull the headlamp unit to remove it from the bumper.3 Detach the bulb C by pressing on bars 1 and 2.4 Disconnect the connector (pull whilst pressing on the grey tongue using a fl at screwdriver).5 Replace the bulb.6 Connect the connector (push the grey tongue in well).7 Replace the headlamp unit in the bumper.8 Screw the headlamp unit in.9 Position the cover using its guides and screw in.
Bulbs: HP24W
When replacing, be careful not to pinch the electrical cables.
Front foglamp1 Remove the fi xing screw of cover A using a torx tool, tip the cover over and remove.2 Remove the fi xing screw of lamp B using a torx tool and pull on the unit to remove it from the bumper.3 Disconnect the connector.4 Remove the bulb by performing a quarter of a turn.5 Replace the bulb.6 Connect the connector.7 Replace the headlamp unit in the bumper.8 Screw the headlamp unit in.9 Position the cover using its guides and screw in.
Bulbs: H8

164
VIB
C
A
E
D
F
G
G
C H A N G I N G B U L B S
R E A R L A M P S
Rear lamp unit
Identify the failed bulb.
Bulbs:A Stop-lamps and sidelamps: P 21 W / 5 WB Sidelamp: R 5 WC Reversing lamp: H 21 WD Foglamp: H 21 WE Direction indicator: P 21 W
Rear lamp on boot1 Open the boot.2 Using a fl at screwdriver, remove the 3 clips which fi x the trim in the lamp area.3 Partially remove the trim F.4 Disconnect the connector.5 Detach the bulb holder G.6 Replace the bulb.7 Replace the bulb holder G.8 Connect the connector.9 Replace and fi x the trim F with its clips.
In some climatic conditions, mist may appear on the headlamp / indicator lenses. This is normal and will disappear (e.g. after the lamps have been on for a few minutes). If not, contact a CITROËN dealer. some climatic conditions, mist may appear on the h eadlamp / indicator lenses. This is normal and is no