2007.5 Citroen C5 DAG interior lights

23
II
R E M O T E C O N T R O L
Folding and ejecting the key
Button D is for folding and ejecting the key from its housing in the remote control.
If you do not press on button D, you could damage the key mechanism.
Changing the remote control battery
Unclip the cover to gain access to the battery.
Battery: CR 0523 de 3 V.
Re-initialisation of the remote control
After a change of battery, it is necessary to re-initialise the remote control. To do that, switch on the ignition and immediately press bu tton C of your remote control until you achieve the desired result. This may take some ten seconds.Note: Make a careful note of the numbers for the keys and for the remot e control on the ASSISTANCE card. Keep this in a safe place.
Do not throw away used batteries. Return them to a CITROËN dealer or dealertake them to an authorised recycling facility (camera shops, etc).
Except when reinitialising, the remote control cannot function while the key is in the ignition, even when switched off.
Warning: by inadvertently actioning the remote control, when for example it is in your pocket, you can unlock the vehicle without your realising it.
However, if none of the doors is opened within thirty seconds following an unlocking, the doors will automatically relock.
Warning: there is a risk of damage if the replacement batte ry is not the correct one.
Only use batteries that are identical or equivalent to those approved by CITROËN.
Guide-me-home lighting
A press on button B activates the guide-me-home lighting (lighting of the sidelamps, dipped beams, registration plate lights for around 1 minute).
A second press prior to the end of this timing cancels the guide-me-home lighting.
Locating of the vehicle
To locate the vehicle in a carpark, press button C. Locating of the vehicle is confi rmed by:The fl ashing of the direction indicators for a few seconds.The interior lighting coming on.
The vehicle remains locked.

33
II
Front passenger's airbag deactivation warning lamp
See “Airbags”.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
Front passenger's air-bag activation warn-ing lamp
See “Airbags”.
Seat belt not fastened
This warning lamp is located on the roof console, in front of the front interior lamp. It informs you of the driver and passenger seat belts which are not fastened.
The lit up locations represent the seat positions which are not fas-tened.
Driver's seat belt not fastened:The warning lamp lights up from 0 to 20 km/h (12 mph).Over 20 km/h (12 mph):
the warning lamp fl ashes,a beep is repeated for about 2 minutes with 3 progressive loudness levels.

113
III
B
A
I N T E R I O R L I G H T I N G
Ambient dashboard lighting
Your vehicle is equipped with warm and welcoming ambient lighting.
A soft orange light is emitted.
Operation
When starting the engine, lights located along the dashboard are activated.
With the ignition on and the head-lamps on, button A allows you to activate or deactivate the ambient dashboard lighting.
Ambient central console lighting
These lights are located on the roof console, near the front interior lamp. They light up the central con-sole.
Operation
These lights are activated when the instrument panel comes on. They are deactivated when the instrument panel goes out.
The intensity of the lighting var-ies along with that of the instru-ment panel. Press on button B to increase or reduce the intensity of the lighting.
Door opening controls light-ing
They are located on the front and rear interior door opening controls.
The rear door opening controls lighting is deactivated if child safety is activated.

114
III
I N T E R I O R L I G H T I N G
Pavement lighting
With the door open, this lights up the ground next to the vehicle.
Floor lighting
In the front and the rear of the vehi-cle, when a door is opened, this lights up the interior of the vehicle.
Welcome lighting
The welcome lighting is made up of:The interior (roof) lamps.
The fl oor lighting.
The pavement lighting when a door is open.