2006 SUZUKI SX4 PPL

Downloaded from www.Manualslib.com manuals search engine 9L-2 Paint / Coatings:
Plastic Parts FinishingS6RW0D9C01002
Painting
Rigid or hard ABS plastic needs no primer coating.
General acrylic lacquers can be painted properly over hard ABS plastic in terms of adherence.
1) Use cleaning solvent for paint finish to wash each part.
2) Apply conventional acrylic color lacquer to part surface.
3) Follow lacquer directions for required drying time. (Proper drying temperature range is 60 – 70 °C (140 – 158 °F)).
Reference
Plastic parts employ not only ABS (Acrylonitrile Butadiene Styrene) plastic but also polypropylene, vinyl, or the like
plastic. Burning test method to identify ABS plastic is described below.
1) Use a sharp blade to cut off a plastic sliver from the part at its hidden backside.
2) Hold sliver with pincers and set it on fire.
3) Carefully observe condition of the burning plastic.
4) ABS plastic must raise readily distinguishable back smoke while burning with its residue suspended in air
temporarily.
5) Polypropylene must raise no readily distinguishable smoke while burning.

Downloaded from www.Manualslib.com manuals search engine Paint / Coatings: 9L-3
Component Location
Sealant Application AreasS6RW0D9C03001
I7RW019C0007-01

Downloaded from www.Manualslib.com manuals search engine 9L-4 Paint / Coatings:
I7RW019C0002-01
[A]: RH side “B”: Wipe off excess sealant after application. “E”: Never fill up drain holes with sealant.
[B]: LH side “C”: Smooth out sealant with a brush. “F”: Fill gap / hole with sealant.
“A”: Apply sealant. “D”: Do not apply sealant. “G”: R end

Downloaded from www.Manualslib.com manuals search engine Paint / Coatings: 9L-5
I7RW019C0008-01
“A”: Apply sealant. “D”: Do not apply sealant.
“B”: Fill gap / hole with sealant. “E”: Wipe off excess sealant after application.
“C”: Smooth out sealant with a brush.

Downloaded from www.Manualslib.com manuals search engine 9L-6 Paint / Coatings:
I7RW019C0004-01
“A”: Apply sealant. “C”: Never fill up drain holes (“a” to “f”) with sealant.
“B”: Wipe off excess sealant after application. “D”: Apply sealant covering flange end.

Downloaded from www.Manualslib.com manuals search engine Paint / Coatings: 9L-7
I6RW0C9C0004-01
“A”: Apply sealant. “D”: Smooth out sealant with a brush. “G” Apply sealant covering flange end.
“B”: Wipe off excess sealant application. “E”: Smooth out sealant with a brush.
Do not fill hole with sealant.
“C”: Fill gap / hole with sealant. “F”: Do not apply sealant.

Downloaded from www.Manualslib.com manuals search engine 9L-8 Paint / Coatings:
I5RW0C9C0005-01
“A”: Apply sealant. 1. Hole

Downloaded from www.Manualslib.com manuals search engine Paint / Coatings: 9L-9
I5RW0C9C0006-01
“A”: Apply sealant covering flange end.