2006 MAZDA MODEL MX-5 MIATA Owners Manual

Black plate (105,1)
4. Push the unlock button and fullyrelease the top latch.
Unlock button
Top latch
5. Remove the seat belts from the belt guides.
Belt guide
6. Slide the seats forward.Refer to Seat Slide on page 2-2.
7. Fold the seatbacks forward. Refer to Seat Recline on page 2-3. 8. Pull the levers and fully release the side
latches.
Side latch
Lever
9. After the side latches are fully released,
release the lever.
10. Lift the side latches while pulling the lever. Make sure the hooks are fully
released.
Side
latch
Lever Hook
Knowing Your Mazda
Doors and Locks
3-47
MX-5_8U35-EA-05F_Edition4 Page105
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (106,1)
11. Disconnect the cord.
12. Slide the hardtop rearward whilepressing down on the rear deck
latches to unlock the latches.
Hardtop
Rear deck latch
13. Lift the hardtop straight off the bodyto prevent damage to the rear deck
latches and studs.
Hardtop
Rear deck stud
14. Set the belt guides and the seats backto their original positions.
15. Disconnect the hardtop rear window defroster coupler (A) from the coupler
(B), and remove the convertible top
rear window defroster coupler (C)
from its holder (D).
(A)
(B)
(C)
(D)
16. Connect the convertible top's rear
window defroster coupler (C) to the
coupler (B).
(C)
(B)
3-48
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page106
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (107,1)
WARNING
Windshield's Edges:
Not being careful of the windshield's
edges when getting into or out of the
vehicle is dangerous. The windshield's
edges could scratch and cause
injuries.
Be careful of the windshield's edges
when getting into or out of the vehicle.
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lUse extreme care when carrying the
hardtop to prevent scratching or
other damage to it.
NOTE
Points to remember when storing the
detachable hardtop.
lDo not place the hardtop on a hard
surface, such as concrete or asphalt.
Place it on a cushioning material,
such as an old blanket.
lBe sure the top and side latches are
locked.
lDo not lean the hardtop against a
wall or stand it in an unstable way.
lStore the hardtop in a dry clean area,
and cover it with a soft material,
such as an old blanket.
qInstalling the Detachable Hardtop
CAUTION
Do not attempt to install the hardtop
with the convertible top also up.
Lower the convertible top before
installing the hardtop, otherwise
damage will occur to the convertible
top.
NOTE
lBe sure to place the convertible top
latches in the locked position.
lMake sure the convertible top is
completely lowered before installing
the hardtop. Also confirm that the
rear window defroster coupler is
disconnected.
1. Park the vehicle on a level surface and firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Remove the antenna if it is installed. Refer to Antenna on page 6-10.
4. Remove the seat belts from the belt guides.
Belt guide
Knowing Your Mazda
Doors and Locks
3-49
MX-5_8U35-EA-05F_Edition4 Page107
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (108,1)
5. Slide the seats forward.Refer to Seat Slide on page 2-2.
6. Fold the seatbacks forward. Refer to Seat Recline on page 2-3.
7. Connect the rear window defroster coupler.
NOTE
Connect the convertible top's rear
window defroster coupler into the
holder so that it does not rattle.
8. Make sure the top latch and the sidelatches on the hardtop are unlocked.
Top latch
assembly
Side latch
assembly
9. Align the rear deck latches with therear deck studs and set the hardtop
squarely onto the body.
Hardtop
Rear deck stud
3-50
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page108
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (109,1)
10. Slide the hardtop forward whilepressing down on the rear deck
latches to lock the latches, and then
verify that they are secure by
attempting to lift the rear of the
hardtop.
Hardtop
Rear deck latch
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lThe rear defogger grid and the
defogger cord could be damaged
when removing or installing the
hardtop. Make sure the rear defogger
grid isn't folded and the defogger
cord isn't caught between the
vehicle's body and the hardtop. 11. Make sure the striker for the top latch
is securely engaged with the anchor
before pushing up the top latch lever.
Push the lever of the top latch up with
the palm of your hand until the top
latch is locked.
Striker
Anchor
12. Pull the levers and fully release theside latches.
Side latch
Lever
Knowing Your Mazda
Doors and Locks
3-51
MX-5_8U35-EA-05F_Edition4 Page109
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (110,1)
13. Make sure the hooks are engaged.Lift the side latches with the palm of
your hand until the latches are locked.
Side
latch
Hook
CAUTION
After installation, verify that all latches
are secure. Operating the vehicle with
unlocked latches may cause hardtop
damage or loss.
14. Set the belt guides and the seats back to their original positions.
15. Connect the cord.
NOTE
If the hardtop rattles even when all
latches are secure, drive slowly and
contact an Authorized Mazda Dealer for
inspection.
q Detachable Hardtop Appearance
Care
Refer to Detachable Hardtop Maintenance
(page 8-53) for information on detachable
hardtop appearance care.
3-52
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition4 Page110
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (111,1)
Immobilizer System (with
Advanced Key)
The immobilizer system allows the engine
to start only with an advanced key the
system recognizes.
If someone attempts to start the engine
with an unrecognized key, the engine will
not start, thereby helping to prevent the
theft of your vehicle.
CAUTION
lRadio equipment like this is
governed by laws in the United
States.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
lTo avoid damage to the key, do not:
lDrop the key.lGet the key wet.lExpose the key to any kind of
magnetic field.
lExpose the key to high
temperatures on places such as the
dashboard or hood, under direct
sunlight.
CAUTION
Do not allow the following when
starting the engine with the auxiliary
key due to an advanced key dead
battery or other malfunction. Otherwise
the signal from the auxiliary key will
not be received correctly and the engine
may not start.
lMetal parts of other keys or metal
objects touch the key grip.
lSpare auxiliary keys or keys for
other vehicles equipped with an
immobilizer system touch or come
near the auxiliary key.
lEquipment containing electronic
components or cards with magnetic
strips such as credit cards come near
the auxiliary key.
NOTE
l(U.S.A.)
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
l(CANADA)
This device complies with RSS-210
of Industry CANADA. Operation is
subject to the following two
conditions: (1) this device may not
cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
Knowing Your Mazda
Security System
3-53
MX-5_8U35-EA-05F_Edition4 Page111
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F

Black plate (112,1)
qOperation
Arming
The system is armed when the ignition
switch is turned from the ON position to
the ACC or LOCK position. The security
indicator light in the instrument cluster
flashes every 2 seconds until the system is
disarmed.
Disarming
The system is disarmed when the ignition
switch is turned to the ON position with
the registered advanced key.
The security indicator light illuminates for
about 3 seconds and goes out.
If the engine doesn't start with the correct
ignition key, and the security indicator
light keeps illuminating or flashing, the
system may have a malfunction. Consult
an Authorized Mazda Dealer.
NOTE
lThe engine may not start and the
security indicator light may
illuminate or flash if the advanced
key is placed in an area where it is
difficult for the system to detect the
signal, such as on the dashboard, or
in the glove box. Move the advanced
key to another place, turn the
ignition switch to the LOCK
position, and then restart the engine.
lSignals from a TV or radio station, or
from a transceiver or a mobile
telephone could interfere with your
immobilizer system. If you are using
the proper advanced key and the
engine fails to start, check the
security indicator light. If the
indicator light is flashing, turn the
ignition switch to the ACC or LOCK
position and wait for a while, then
restart the engine. If it doesn't start
after 3 or more tries, contact an
Authorized Mazda Dealer.
lIf the security indicator light flashes
continuously while you are driving,
don't shut off the engine. Go to an
Authorized Mazda Dealer and have
it checked. If the engine is shut off
while the indicator light is flashing,
you won't be able to restart it.
lSince the electronic codes are reset
when repairing the immobilizer
system, the advanced key (including
auxiliary key) are needed. Bring all
the advanced keys (including
auxiliary keys) to an Authorized
Mazda Dealer.
3-54
Knowing Your Mazda
Security System
MX-5_8U35-EA-05F_Edition4 Page112
Thursday, October 6 2005 11:3 AM
Form No.8U35-EA-05F