Page 89 of 319
See page for important safety
inf ormation and a warning about how to properly position the head restraints. 13
The head restraints adjust f or height.
You need both hands to adjust the
restraint. Do not attempt to adjust it
while driving. To raise it, pull upward.
To lower the restraint, push the
release button sideways, and push
the restraint down.
Your vehicle is equipped with head
restraints on the f ront seats and on
the outer rear seats.
The head restraints help protect you
and your passengers f rom whiplash
and other injuries.
Theyaremosteffectivewhenyou
adjust them so the back of the
occupant’s head rests against the
center of the restraint. Head Restraints
Seats
Inst rument s and Cont rols
87
RELEASE BUTTON
FRONT REAR
RELEASE BUTTON
——y
y
(%yy
Page 90 of 319
The back of the rear seat folds down,
giving you direct access to the trunk.
The lef t and right seat-backs of the
rear seat can be folded separately
f rom inside the vehicle or inside the
trunk.To fold down the seat-back from
inside the vehicle, insert the master
keyinthelockontherearshelf.To
f old down the driver’s side, turn the
key clockwise, pull down the top of
the seat-back, then release the key.
To f old down the passenger’s side,
turn the key counterclockwise and
perf orm the same procedure.When storing cargo, you can move
therearcentershoulderbeltoutof
the way by removing the belt from
the guide.
Folding Rear Seat
Seats
88
GUIDE
CENTER
SHOULDER BELT
MASTER KEY
——y
y
(%y
y
Page 91 of 319

To release the seat-back from inside
the trunk, pull the release under the
trunk panel. Push the seat-back
down, then let go of the release.
To lock the seat-back upright, push it
firmly against the trunk panel. Make
sure it is latched in place by pulling
on the top of the seat. Make
sure that the folded seat-back
does not interfere with the front
passenger’s seat-back. This will
cause the front passenger’s weight
sensors to work improperly (see
page ). Also check the passenger
airb ag off indicator to assu re proper
operation of the passenger’s
advanced front airbag.
Do not put any heavy items on the
seat-back when it is folded. Make
sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Looseitemscanflyforwardand
cause injury if you have to brake
hard. See on page
.
Never drive with the seat-back
folded down and the trunk lid open.
See on
page .
Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
back, and the center shoulder belt is
re-positioned in the guide whenever
the seat-back is in its upright position.
Be sure the center shoulder belt is
not twisted. 50
25
193
Seats
Carrying Cargo
Carbon Monoxide HazardInst rument s and Cont rols
89
Pull
——y
y
(%yy
Page 92 of 319
In LO, the heater runs continuously.
It does not cycle with temperature
changes. In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat temperature drops.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
Both front seats have seat heaters.
The passenger seat is only heated in
the seat bottom because of the side
airbag cutoff system. The ignition
switch must be in the ON (II)
position to use seat heaters. Push the
top of the switch, HI, to rapidly heat
up the seat. After the seat reaches a
comf ortable temperature, select LO
by pushing the bottom of the switch.
This will keep the seat warm.
On EX-L and EX-V6 models
Seat Heaters
90
SEAT
HEATER
SWITCH
——y
y
(%yy
Page 93 of 319

µ
CONT INUED
Turn the ignition switch to the ON
(II) position to raise or lower either
window. To open the window, push
the switch down and hold it. Release
the switch when you want the
window to stop. Pull back on the
switchandholdittoclosethe
window.
Thewindowsoperateforupto10
minutes after you turn off the
ignition switch. Opening either door
cancels this f unction.If the MAIN switch is off, the
passenger’s windows cannot be
raised or lowered. Keep the MAIN
switch of f when you have children in
the vehicle so they do not injure
themselves by operating the
windows unintentionally. To open or close the
driver’s window, push or pull the
window switch firmly down or up to
the second detent, and release it.
The window will automatically go
down or up all the way. To stop the
window, pull or push the window
switch brief ly.
Power Windows
AUTO
Inst rument s and Cont rols
91
MAIN SWITCH
DRIVER’S WINDOW
SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
——y
y
(%yy
Page 94 of 319

µIf your vehicle’s battery is
disconnected or goes dead, or the
driver’s window f use is removed, the
AUTO f unction will be disabled. The
power window system needs to be
reset af ter reconnecting the battery
or installing the f use.
Start the engine. Push down and
hold the driver’s window switch
until the window is f ully open. Press the UNLOCK button once
to unlock the driver’s door.
Press the UNLOCK button a
second time, and hold it. The
passenger’s door unlocks, and
both windows start to open. To
stop the windows, release the
button.
If the power windows do not operate
properly af ter resetting, have your
vehicle checked by your dealer. You can open both windows f rom the
outside with the remote transmitter.
If the driver’s
window runs into any obstacle while
it is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it. Pull and hold the driver’s window switch to close the window
completely, then hold the switch
f or about 2 seconds. To open the windows f urther,press the button again (within 10
seconds).
You cannot close the windows with
the remote transmitter.
1.
2.
1.
2.
3.
Power Windows
Opening the Windows with the
Remote Transmitter
AUTO REVERSE
92
——y
y
(%yy
Page 95 of 319
You can open and close the windows
with the key in the driver’s door lock.To close:
Insert the key in the driver’s door
lock.
Turn the key counterclockwise,
then release it.
Turn the key counterclockwise
again, and hold it. Both windows
starttoclose.Tostopthewindows,
release the key.
To close the windows f urther, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the windows stop bef ore
the desired position, repeat steps 2
and 3.
To open:
Insert the key in the driver’s door
lock.
Turn the key clockwise, then
release it.
Turnthekeyclockwiseagain,and
hold it. Both windows start to open.
To stop the windows, release the
key.
To open the windows further, turn
andholdthekeyagain(within
10 seconds).
NOTE: If the windows stop bef ore
the desired position, repeat steps 2
and 3. 1.
2.
3.
4. 3. 4.
1.
2.
Opening/Closing the Windows
with the Key
Power Windows
Inst rument s and Cont rols
93
Open
Close
UNLOCK BUTTON
——y
y
(%yy
Page 96 of 319

The moonroof can be tilted up in the
back f or ventilation, or it can be slid
back into the roof. Use the switch
under the lef t dashboard vent to
operate the moonroof . You must
turn the ignition switch to the ON
(II) position f or the moonroof to
operate.The moonroof has a key-of f delay.
You can open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition switch. The
key-of f delay cancels as soon as you
open either door.
To tilt up the back of the moonroof ,
press and hold the center part of the
switch ( ). To close the
moonroof , press and hold the upper
part of the switch ( ). To open
the moonroof , press and hold the
lower part of the switch ( ).
Release the switch when the
moonroof gets to the desired
position.
If equipped
Moonroof
94
MOONROOF SWITCH Close
Tilt MOONROOF SWITCH
Open
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
——y
y
(%yy