2006 HONDA ACCORD COUPE Owners Manual

Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
To replace the battery: If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616 Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover. Separate the transmitter by prying
its middle seam with your
f ingernail.
1. 2.
3.
CONT INUED
Remote Transmitter CareReplacing the Transmitter
Battery
Remote Transmitter
Inst rument s and Cont rols
79
SCREW
TAB
BATTERY
——y
y
(%yy

´
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same ( side f acing down), then
insert it into the back of the cover.
Install the parts in reverse order.
4.
5.
Remote Transmitter
80
——y
y
(%yy

Keep the trunk lid closed at all times
while driving to avoid damaging the
lid, and to prevent exhaust gas from
getting into the interior. See
on page .
To protect items in the trunk when
you need to give the key to some one
else: Lo ck the trunk release handle
with the master key.
Give the person the valet key. As
a safety feature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened from the
inside. To open the trunk, push the
release lever to the left.
Parents should decide if their
children should be shown how to use
this feature. For more information
about child safety, see page .
Youcanopenthetrunkintwoways:
Pull the trunk release handle to
the lef t of the driver’s seat.
Press and hold the trunk release
button on the remote transmitter.
To close the trunk, press down on
the trunk lid. 1.
2.50
36
Carbon
Monoxide Hazard Emergency T runk Opener
Trunk
Inst rument s and Cont rols
81
Pull
TRUNK RELEASE HANDLE MASTER
KEY
——y
y
(%yy

µ
The 4-cylinder EX model has a
power seat bottom height
adjustment. All other driver’s seat
adjustmentsinthismodelare
manual.
The 4-cylinder LX model has manual
driver’s seat adjustments (see next
column). All V6 models and the 4-cylinder
EX-L models have a power
adjustable driver’s seat.
The front passenger’s seat in all
models adjusts manually. Make
all seat adjustm ents before
you start driving.
To adjust the seat forward or
backward, pull up on the bar under
the seat cushion’s front edge. Move
the seat to the desi red position, and
releasethebar.Trytomovetheseat
to make sure it is locked in position. To
change the seat-back angle of the
front seat, pull up on the lever on the
outside of the seat bottom.
Once your seat is adjusted correctly,
rock it back and f orth to make sure it
is locked in position.
See pages f or important saf ety inf ormation and warnings about how toproperly position the seats and seat-backs. 1311
Seats
Manual Seat Adjustments
82
——y


y
(%yy

The height of your driver’s seat is
power adjustable. Pull up on the
switch to raise the seat. Push it down
to lower the seat.
Make sure to pull the lever upward
or downward to its f ull range.
Make all seat adjustments bef ore
you start driving.
Make all seat adjustments bef ore
you start driving.
The height of your driver’s seat is
adjustable. To raise the seat,
repeatedly pull up the lever on the
outside of the seat cushion. To lower
the seat, push the lever down
repeatedly.
On 4-cylinder EX model
On 4-cylinder LX model
Driver’s Seat Power Height
Adjustment
Driver’s Seat Manual Height
Adjustment
Seats
Inst rument s and Cont rols
83
——y


y
(%yy

µ
See pages for important safety
inf ormation and warnings about how to properly position the seats and seat-backs. 11 13
On all V6 models, and the 4-cylinder
EX-L model
Raises or lowers the
seat.
Adjusts the seat-
back angle f orward
or backward.
Moves the f ront of
the seat up or down
and the rear of the
seat up or down. Moves the seat
forward and
backward.
The controls f or the power
adjustable driver’s seat are on the
outside edge of the seat bottom. You
can adjust the seat with the ignition
switch in any position. Make all seat
adjustments before you start driving.
Moving the long horizontal switch
adjusts the seat bottom in several
directions. The seat bottom adjusts
in the direction you move the switch.
The short vertical switch adjusts the
seat-back angle. Power Seat A djustments
Seats
84
——y

y
(%yy

To use the console lid as an armrest,
slide it to the desired position.
Make sure your passenger’s hands
orfingersareawayfromthearmrest
bef ore moving it.To get into the rear seat on the
driver’s side, open the door and pull
the release lever up on the side of
the seat-back. The seat-back will tilt
f orward to allow easier entry to the
rear seat.
To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position.
CONT INUED
On EX, EX-L, and EX-V6 models
On all V6 models and the 4-cylinderEX-L model
Driver’s L umbar Support A rmrest Rear Seat A ccess
Driver’s Side
Seats
Inst rument s and Cont rols
85
RELEASE LEVER
——y

y
(%yy

To get into the rear seat on the
passenger’s side, push downward on
the release lever at the base of the
seat-back. The seat-back will tilt
f orward and the entire seat will move
f orward to allow easier entry to the
rear seat.
To get into the rear seat on the
driver’s side, open the door and pull
up on the seat-back adjustment lever.
The seat-back will tilt f orward to
allow easier entry to the rear seat. Af ter a passenger gets into the rear
seat, push the seat-back to the
upright position and push the whole
seat backwards until it latches. Make
sure the seat is f ully latched bef ore
sitting in it.
On LX and EX models
Passenger’s Side
Seats
86
SEAT-BACK ADJUSTMENT LEVER
RELEASE LEVER
To avoid damaging the seat-back angle
adjustment motor, do not operate the
seat-back angle switch when the seat-
back is tilted f orward.
——y

y
(%yy