(#'
")
Pre-operation Check Set-up After Replacing Front Passenger’s Seat
Component(s)
24-28SRS
ODS Unit Operation Check
A
Check the ODS operation after any of these actions.
Replacement of front passenger’s seat component(s) (except ODS unit and/or weight sensors)
After a vehicle collision
SRS unit replacement
Make sure all the components of the front passenger’s seat are correctly installed.
Position the front passenger’s seat to the rearmost position.
Adjust the seat-back to the forwardmost position.
Do not move the seat from this position.
Make sure nothing is on or under the front passenger’s seat.
Make sure there is nothing in the front passenger’s seat-back pocket.
Keep the windows and moonroof closed.
Do all calibration procedures, except test-driving, in the service bay.
Make sure the vehicle is on level gr ound.
Turn the heater and the A/C off.
Do not touch the front passenger’s seat during the calibration, unless you are prompted to or until you
have completed the operation check.
Do not expose the front passenger’s seat to sudden temperature changes.
Make sure all aftermarket devices such as amplifiers, fluorescent lights, air purifies, CB or HAM radios, etc.
are turned off. 1. Make sure the ignition switch is in LOCK (0).
2. Connect the HDS to the data link connector (DLC)
(A).
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate,
troubleshoot the DLC circuit (see page 11-204).
5. Drive the vehicle, accelerate to 20 mph (36 km/h), then stop on level ground.
6. From the HDS Main Menu, select SRS, then Inspection. In the HDS Inspection Menu, select
SEAT OUTPUT CHK and follow the prompts until
the ODS unit operation check is complete.
08/08/21 13:54:23 61SNR030_240_0028
ProCarManuals.com
DYNOMITE -2009-
