C50950
C50205
C50206
C50207
− AUTOMATIC TRANSMISSION / TRANSFRONT DIFFERENTIAL ASSY (U151F)
40−121
U151E, U151F A/T REPAIR MANUAL (RM1021U)
(b) Hold the differential case RH by vice. Install the center dif-
ferential pinion and pinion thrust washer to the differential
spider and install them to the differential case RH.
NOTICE:
When holding the differential case RH by vise, be sure to
place an aluminum sheet between them and use a mini-
mum force.
(c) Pressing and holding the differential spider toward the dif-
ferential case RH, measure the pinion’s backlash with a
dial indicator as illustrated.
Standard backlash:
0.05−0.20 mm (0.0020−0.0079 in.)
If the backlash is not within the specified value, refer to the table
below and select a thrust washer which will ensure that the
backlash is within the specified value.
Thrust washer thickness: mm (in.)
MarkThicknessMarkThickness
MA0.80 (0.0313)MH1.15 (0.0453)
MB0.85 (0.0333)MJ1.20 (0.0472)
MC0.90 (0.0353)MK1.25 (0.0492)
MD0.95 (0.0373)ML1.30 (0.0512)
ME1.00 (0.0393)MM1.35 (0.0532)
MF1.05 (0.0413)MN1.40 (0.0552)
MG1.10 (0.0433)−−
(d) Temporarily install the differential side gear thrust washer
No.2 LH, center differential side gear conical spring wash-
er and differential case No.2 to the differential case LH.
HINT:
Ensure that the conical washers is installed correctly.
(e) Install the differential intermediate case to the above and
fix them with 4 bolts.
C50208
C50209
C50210
C51468
Differential
Case No.2
Differential
Case LH
40−122
− AUTOMATIC TRANSMISSION / TRANSFRONT DIFFERENTIAL ASSY (U151F)
U151E, U151F A/T REPAIR MANUAL (RM1021U)
(f) Remove the differential spider, 5 center differential pin-
ions and 5 center differential pinion thrust washers from
the differential case RH. Put them in the differential inter-
mediate case and fix the case.
(g) Pressing and holding the differential spider toward the dif-
ferential intermediate case, measure the pinion’s back-
lash with a dial indicator.
Standard backlash:
0.05−0.20 mm (0.0020−0.0079 in.)
If the backlash is not within the specified value, refer to the table
below and select a thrust washer which will ensure that the
backlash is within the specified value.
Thrust washer thickness: mm (in.)
MarkThicknessMarkThickness
MA0.80 (0.0313)MH1.15 (0.0453)
MB0.85 (0.0333)MJ1.20 (0.0472)
MC0.90 (0.0353)MK1.25 (0.0492)
MD0.95 (0.0373)ML1.30 (0.0512)
ME1.00 (0.0393)MM1.35 (0.0532)
MF1.05 (0.0413)MN1.40 (0.0552)
MG1.10 (0.0433)−−
(h) Remove the 4 bolts and disconnect the differential case
LH from the differential intermediate case.
(i) Remove the differential case No.2 from the differential
case LH.
