Page 244 of 969
C93149
C90581
C92829
- AUTOMATIC TRANSMISSION / TRANSTRANSMISSION CONTROL CABLE ASSY
40-45
2560 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(e) Disconnect the floor shift cable from the rod of the floor
shift assy.
(f) Remove the 2 bolts and shift cable grommet retainer
No.2.
(g) Pull out the control cable from the body.
9. INSTALL TRANSMISSION CONTROL CABLE ASSY
(a) put in the control cable to the body.
(b) Install the shift cable grommet retainer No.2 to the floor
shift cable.
(c) Install the floor shift cable, as shown in the illustration.
HINT:
Install it with the uneven surface facing up.
Page 245 of 969
C90581
C93327
D25414
D25415
40-46
- AUTOMATIC TRANSMISSION / TRANSTRANSMISSION CONTROL CABLE ASSY
2561 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(d) Install the shift cable grommet retainer No.2 with the 2
bolts.
Torque: 4.9 NVm (50 kgfVcm, 43 in.Vlbf)
(e) Connect the control cable to the control cable clamp.
(f) Temporarily install the control cable to the control shaft le-
ver with nuts.
(g) Install the control cable and a new clip to the bracket.
10. INSTALL INTAKE AIR RESONATOR SUB-ASSY
11. INSTALL AIR CLEANER HOSE NO.1
12. INSTALL AIR CLEANER ASSY
13. INSTALL AIR BAG SENSOR ASSY CENTER (SEE PAGE 60-55)
14. INSTALL AIR CONDITIONING RADIATOR ASSY (SEE PAGE 55-17)
15. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSY (SEE PAGE 71-1 1)
16. INSTALL BATTERY
17. ADJUST SHIFT LEVER POSITION (SEE PAGE40-40)
18. INSPECT SHIFT LEVER POSITION (SEE PAGE40-40)
Page 405 of 969

141J9-02
A60072
- ENGINE MECHANICALPARTIAL ENGINE ASSY (3MZ-FE)
14-29
2121 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
REPLACEMENT
1. DISCHARGE FUEL SYSTEM PRESSURE (See page 11-1)
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE FRONT WHEELS
4. REMOVE ENGINE UNDER COVER NO.1
5. REMOVE ENGINE UNDER COVER NO.2
6. REMOVE FRONT FENDER APRON SEAL RH
7. DRAIN ENGINE COOLANT (See page 16-9)
8. DRAIN ENGINE OIL (See page 17-20)
9. DRAIN AUTOMATIC TRANSAXLE FLUID (See page 30-8)
10. REMOVE V-BANK COVER SUB-ASSY (See page 10-1 1)
11. REMOVE RADIATOR LOWER AIR DEFLECTOR (See page 19-5)
12. REMOVE BATTERY
13. REMOVE BATTERY TRAY
14. REMOVE AIR CLEANER INLET ASSY (See page 19-5)
15. REMOVE AIR CLEANER ASSY (See page 19-5)
16. REMOVE AIR CLEANER BRACKET (See page 19-5)
17. REMOVE AIR CLEANER INLET NO.1 (See page 19-5)
18. REMOVE INTAKE AIR RESONATOR SUB-ASSY
(a) Remove the clip and bolt, then remove the intake air resonator.
19. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 14-5)
20. REMOVE GENERATOR ASSY (See page 19-21)
21. REMOVE ENGINE MOVING CONTROL ROD (See page 14-79)
22. REMOVE ENGINE MOUNTING STAY NO.2 RH (See page 14-79)
23. REMOVE GENERATOR BRACKET NO.2 (See page 14-79)
24. REMOVE GENERATOR BELT ADJUSTING BAR (See page 17-9)
25. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (See page 17-9)
26. SEPARATE TRANSMISSION CONTROL CABLE ASSY (See page 40-44)
27. DISCONNECT UNION TO CHECK VALVE HOSE
28. DISCONNECT FUEL VAPOR FEED HOSE NO.1
29. DISCONNECT FUEL PIPE SUB-ASSY NO.1 (See page 11-1)
30. DISCONNECT HEATER INLET WATER HOSE
31. DISCONNECT HEATER OUTLET WATER HOSE
32. DISCONNECT RADIATOR HOSE INLET
33. DISCONNECT RADIATOR HOSE OUTLET
34. DISCONNECT OIL COOLER INLET HOSE
35. DISCONNECT OIL COOLER OUTLET HOSE
36. DISCONNECT OIL RESERVOIR TO PUMP HOSE NO.1
Page 959 of 969

Lexus Supports ASE CertificationPage 1 of 3
Title:
ECM RESET MEMORY FUNCTION
Models:
'98 ± '05 Applicable Models
Technical Service
Information Bulletin
May 5, 2003
TC002-03
TSIB REVISION NOTICE:
December 20, 2004: Applicable Vehicles section has been updated and modified,
2004 and 2005 model years added; and Reset Procedure 2 has been revised.
Previous versions of this TSIB should be discarded.
Whenever an automatic transmission is replaced, overhauled or individual components
are replaced, use this procedure to erase Engine Control Module (ECM, SAE term:
Powertrain Control Module, PCM) ªLearned Valuesº and minimize subsequent
performance concerns.
CAUTION:
Failure to follow the following procedure may lengthen the time to readjust the
ªLearned Values,º potentially resulting in performance concerns.
Refer to Reset Procedure 1 for the following vehicles with Electronically Controlled
Automatic Transmissions:
1999 ± 2003 model year ES 300 and RX 300 vehicles.
2003 ± 2005 model year GX 470 vehicles.
2004 ± 2005 model year RX 330 vehicles.
Refer to Reset Procedure 2 for the following vehicles with Electronically Controlled
Automatic Transmissions:
1998 ± 2005 model year GS 430/400/300, LS 430/400, LX 470, and
SC 430/400/300 vehicles.
2001 ± 2005 model year IS 300 vehicles.
OP CODEDESCRIPTIONTIMEOFPT1T2
N/ANot Applicable to Warranty±±±±
TRANSMISSION & CLUTCH
Introduction
Applicable
Vehicles
Warranty
Information