Page 228 of 969
4010X-04
D25831
SST
D25832
SST
D25833
SST
- AUTOMATIC TRANSMISSION / TRANSFRONT DIFFERENTIAL OIL SEAL (U151E)
40-29
2544 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
FRONT DIFFERENTIAL OIL SEAL (U151E)
REPLACEMENT
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. REMOVE FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-8)
5. REMOVE FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-8)
6. REMOVE TRANSAXLE HOUSING OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER
OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
8. INSTALL DIFFERENTIAL SIDE BEARING RETAINER
OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09316-6001 1 (09316-00011)
Oil seal drive in depth:
0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
SST 09316-6001 1 (09316-00011)
Page 229 of 969
D25834
SST 40-30
- AUTOMATIC TRANSMISSION / TRANSFRONT DIFFERENTIAL OIL SEAL (U151E)
2545 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
9. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09223-15020, 09950-70010 (09951-07150)
Oil seal drive in depth:
0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
10. INSTALL FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-8)
11. INSTALL FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-8)
12. INSTALL FRONT WHEELS
13. ADD AUTOMATIC TRANSAXLE FLUID
14. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-1)
15. CHECK ABS SPEED SENSOR SIGNAL
w/ VSC (SEE PAGE 05-471)
w/o VSC (SEE PAGE 05-420 )
Page 230 of 969
40067-09
C63995IG
E STP
- AUTOMATIC TRANSMISSION / TRANSSHIFT LOCK SYSTEM
40-31
2546 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
SHIFT LOCK SYSTEM
ON-VEHICLE INSPECTION
1. CHECK SHIFT LOCK OPERATION
(a) Shift the shift lever to P position.
(b) Turn the ignition switch to LOCK.
(c) Check that the shift lever cannot be shifted to any other positions other than P.
(d) Turn the ignition switch to ON, depress the brake pedal and check that the shift lever can be shifted
to any other positions.
2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION
(a) Using a small screwdriver, remove the shift lock release cover.
(b) When operating the shift lever with the shift lock release button pressed, check that the lever can be
shifted to any position other than P.
3. CHECK KEY INTERLOCK OPERATION
(a) Turn the ignition switch to ON.
(b) Depress the brake pedal and shift the shift lever to any other position other than P.
(c) Check that the ignition key cannot be turned to LOCK.
(d) Shift the shift lever to P position, turn the ignition key to LOCK and check that the ignition key can be
removed.
4. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY
(a) Using a voltmeter, measure the voltage at each terminal.
HINT:
Do not disconnect the shift lock control unit assembly connec-
tor.
TerminalMeasuring ConditionVoltage (V)
3 (STP) - 1 (E)Depress brake pedal10 - 14
3 (STP) - 1 (E)Release brake pedal0
5 (IG) - (E)Ignition switch ON10 - 14
5 (IG) - (E)Ignition switch OFF0
Page 231 of 969
C93272E
40-32
- AUTOMATIC TRANSMISSION / TRANSSHIFT LOCK SYSTEM
2547 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(b) Using an ohmmeter, measure the resistance at terminal
E (1) and body ground.
HINT:
Do not disconnect the shift lock control unit assembly connec-
tor.
TerminalMeasuring ConditionSpecified Value
1 (E) - Body groundAlwaysContinuity
Page 232 of 969
400FU-02
C93015
C92370
- AUTOMATIC TRANSMISSION / TRANSFLOOR SHIFT ASSY
40-33
2548 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
FLOOR SHIFT ASSY
OVERHAUL
1. REMOVE FRONT DOOR SCUFF PLATE LH (SEE PAGE 71-1 1)
2. REMOVE FRONT DOOR SCUFF PLATE RH (SEE PAGE 71-1 1)
3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.1 (SEE PAGE 71-1 1)
4. REMOVE INSTRUMENT PANEL SUB-ASSY LOWER (SEE PAGE 71-1 1)
5. REMOVE INSTRUMENT PANEL SUB-ASSY UPPER (SEE PAGE 71-1 1)
6. REMOVE INSTRUMENT PANEL INSERT SUB-ASSY LOWER LH (SEE PAGE 71-1 1)
7. REMOVE CONSOLE BOX ASSY (SEE PAGE 71-1 1)
8. REMOVE CONSOLE BOX CARPET
9. REMOVE CONSOLE BOX ASSY (SEE PAGE 71-1 1)
10. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (SEE PAGE 71-1 1)
11. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (SEE PAGE 71-1 1)
12. REMOVE AIR DUCT REAR NO.1 (SEE PAGE 55-17)
13. REMOVE AIR DUCT REAR NO.2 (SEE PAGE 55-17)
14. REMOVE CONSOLE BOX DUCT NO.1 (SEE PAGE 55-17)
15. DISCONNECT FLOOR SHIFT PARKING LOCK CABLE
ASSY
(a) Disconnect the parking lock cable end from the lever pin
of the floor shift assembly.
(b) Using a screwdriver, disconnect the parking lock cable
from the floor shift assembly and clamp.
(c) Disconnect the cable clamp.
Page 233 of 969
C93149
C93016
C93017
C92448C92801
40-34
- AUTOMATIC TRANSMISSION / TRANSFLOOR SHIFT ASSY
2549 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
16. DISCONNECT TRANSMISSION CONTROL CABLE
ASSY
(a) Disconnect the floor shift transmission control cable from
the rod of the floor shift assy.
17. REMOVE FLOOR SHIFT ASSY
(a) Disconnect the shift lock control computer connector.
(b) Disconnect the indicator lamp wire connector.
(c) Remove the 4 bolts and transmission floor shift assy.
18. REMOVE SHIFT LEVER KNOB SUB-ASSY
(a) Remove the floor shift lever knob from the shift lever.
19. REMOVE FLOOR SHIFT POSITION INDICATOR
HOUSING SUB-ASSY
(a) Disconnect the wire harness from the clamp.
Page 234 of 969
C93018
C93019
C93020
C93021C93271
- AUTOMATIC TRANSMISSION / TRANSFLOOR SHIFT ASSY
40-35
2550 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
(b) Using a screwdriver, release the 4 claws and remove the
position indicator housing.
20. REMOVE POSITION INDICATOR LIGHT GUIDE
(a) Using a screwdriver, release the 4 claws and remove the
position indicator light guide.
21. REMOVE INDICATOR LAMP WIRE SUB-ASSY
(a) Remove the indicator lamp wire from the position indica-
tor light guide.
22. REMOVE POSITION INDICATOR LAMP CAP
(a) Remove the floor shift position indicator lamp cap from the floor shift position indicator lamp bulb.
23. REMOVE POSITION INDICATOR LAMP BULB
(a) Remove the floor shift position indicator lamp bulb from the indicator lamp wire.
24. REMOVE SHIFT LOCK RELEASE BUTTON COVER
(a) Using a screwdriver, remove the shift lock release button
cover.
Page 235 of 969
C93022
C92149
C93023
C93023
C92149
40-36
- AUTOMATIC TRANSMISSION / TRANSFLOOR SHIFT ASSY
2551 Author: Date:
2005 LEXUS ES330 REPAIR MANUAL (RM1124U)
25. REMOVE POSITION INDICATOR SLIDE COVER
(a) Remove the position indicator slide cover from the shift le-
ver.
26. REMOVE POSITION INDICATOR SLIDE COVER
(a) Remove the position indicator slide cover from the posi-
tion indicator slide cover.
27. REMOVE SHIFT LOCK RELEASE BUTTON
(a) While pressing the 2 claws, remove the shift lock release
button and shift lock release spring.
28. INSTALL SHIFT LOCK RELEASE BUTTON
(a) Apply MP grease to the shift lock release spring and shift
lock release button.
(b) Install the shift lock release button and shift lock release
spring to the shift lever.
29. INSTALL POSITION INDICATOR SLIDE COVER
(a) Install the position indicator slide cover to the position in-
dicator slide cover.
