2005 Hyundai Azera Owner's Manual

1FEATURES OF YOUR HYUNDAI
24
!
B090B01NF-GAT Adjusting Seat Forward and Rearward Pull the control knob forward or back- ward to move the seat forward or back-ward to the desired position. Release the control knob and the seat will re- main at that position. HTG2037B080F01NF-GAT Seat Cushion Height Adjustment (Driver's Seat Only) (If Installed) To raise or lower the seat, raise or lower the control lever to the desired seatheight.
HTG2035B090A01TG-AAT FRONT POWER SEATS (If Installed) The front seats can be adjusted appro- priately by using the control knob of theseat. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, pedals andswitches on the instrument panel.
CAUTION:
Do not operate two knobs at thesame time.
WARNING:
o Never attempt to adjust the seat while the vehicle is moving. Thiscould result in loss of control, or an accident causing death, seri- ous injury, or property damage.
o Do not sit or lean unnecessarily close to the airbag.
!

1
FEATURES OF YOUR HYUNDAI
25
!
B090D01NF-GAT Adjusting Seatback Angle Pull the upper portion of the control knob forward or backward to recline the seatback to the desired position.Release the control knob and the seatback will remain in that position. HTG2040WARNING:
To minimize the risk of personalinjury in the event of a collision or a sudden stop, both the driver'sand passenger's seatback should remain in an upright position while the car is in motion. The protectionprovided by the seat belts and airbags may be reduced signifi- cantly when the seatbacks are re-clined. There is a greater risk that the seat occupants will slide under the belt resulting in serious injuryif a crash occurs when the seatbacks are reclined. The seat belt cannot provide full protection to an occu-pant if the seatback is reclined.B090C01Y-AAT Seat Cushion Height Adjustment (Driver's seat only) Move the front portion of the control knob up or down to raise or lower the front part of the seat cushion. Move therear portion of the control knob up or down to raise or lower the rear part of the seat cushion. HTG2041

1FEATURES OF YOUR HYUNDAI
26
NOTE:
o If the battery has been rechargedor disconnected, the driving posi- tion memory will be lost.
o The buzzer sounds 10 times if there is a malfunction of theintergrated memory system. Havethe I.M.S checked by an autho- rized Hyundai dealer.
I.M.S control switch It is located on the driver's door trim and will function as follows; SET : When the button is pressed, the
system will memorize the posi- tion with a beep sound.
1,2 : It indicates that the system can
memorize positions up to 2 occu-pants.
B090E01TG-AAT Lumbar Support Control (Driver's seat only) To adjust the lumbar support, press the control switch the outboard side of the seat cushion. To increase the amount of lumbar support, press the front por-tion of the switch. To decrease it, press the rear portion of the switch. HTG2042-2
I.M.S (INTEGRATED MEMORY SYSTEM)
B090E01TG-GAT (If Installed) The Integrated Memory System con- trols are located on the driver's door trim. After adjusting the position of thedriver's seat and steering wheel col- umn (with electric tilt and telescopic type), use the I.M.S to memorize them.Two different driving position profiles can be entered in the I.M.S. If you turn the ignition key to the "ON" position, thememorized position is adjusted auto- matically. B090E01TG

1
FEATURES OF YOUR HYUNDAI
27
CAUTION:
In the following conditions, the I.M.S will not activate.
1. When the key is in the "OFF" posi- tion.
2. When the vehicle is running above 3 km/h.
3. When the seat is being adjusted.
4. When the shift lever is positioned in other than "P" position.
! CAUTION:
In the following conditions, the I.M.S will not memorize.
1. When the "1" or "2" button is not pushed within five seconds.
2. When the seat is being adjusted.
3. When the key is not in the "ON"
position.
4. When the shift lever is positioned in other than "P" position. To activate the memorized posi- tion
1. Place the shift lever into "P" while
the ignition switch is ON.
2. When you push button "1" or "2", the driving position will be automatically adjusted to the position recorded forthat button.
!
To memorize driving position
1. Place the shift lever into "P" while
the ignition switch is ON.
2. Adjust the driver's seat and steering wheel column (with electric tilt and telescopic type) to the desired posi-tion.
3. Push the "SET" button on the I.M.S
until the signal beeps.
4. Within five seconds, push button "1" or "2" until the signal beeps twice.The beep sounds mean that the po-sitions are memorized in the I.M.S. Reverse Parking Aid Function While the vehicle is moving backward, the outside rearview mirror(s) will movedownward to aid reverse parking safely. According to the position of the outside rearview mirror switch knob, the out-side rearview mirror(s) will operate as follows.B090E02TG

1FEATURES OF YOUR HYUNDAI
28
!
NOTE:
o The seat warmer may not operate
if ambient temperature is warm enough.
o If the seat warmer doesn't work when the ambient temperature islower than 24°C, it must bechecked at an authorized dealer.
WARNING:
Be very careful not to injure by lowtemperature burn or an attack offever as following occupants; infants, children, old man, drunken man, people who is taken sleeping drug orcold remedy.B100A01TG-GAT SEAT WARMER (If Installed) The front seats can be electrically heated individually when the ignition switch is ON. When the switch is ON, anumber ranging from 1 to 5 is displayed on the switch (5 = warmest setting). To turn off the seat warmer, set theswitch to 0. B100A01TG
L
: When the remote control outside
rearview mirror switch knob is se-lected to the "L" position, both ofthe outside rearview mirrors will move downward.
R : When the remote control outside
rearview mirror switch knob is se-lected to the "R" position, only thepassenger's outside rearview mir- ror will move downward.
Neutral :When the remote control out-
side rearview mirror switchknob is placed in the middle position, the outside rearviewmirrors will not operate while the vehicle is moving back- ward.
NOTE: When the ignition key is in the "LOCK" position, the shift lever is moved to any position except "R"position, or the remote control out- side rearview mirror switch knob is placed in the middle position, theoutside rearview mirrors will auto- matically revert to original position.

1
FEATURES OF YOUR HYUNDAI
29
!WARNING:
The purpose of the folding rear seatbacks is to allow you to carry longer objects than could other-wise be accommodated. Do not al- low passengers to sit on top of the folded down seatback, while thecar is moving as this is not a proper seating position and no seat belts are available for use. This couldresult in serious injury or death in case of an accident or sudden stop. Objects carried on the folded downseatback should not extend higher than the top of the front seats. This could allow cargo to slide forwardand cause injury or damage during sudden stops.
B110A01NF-GAT REAR SEAT FOLDING REAR SEATBACKS
o To unlock the seatback, pull the seatback release lever, then pull for- ward on the seatback panel.
o When you return the seatback to its
upright position, always be sure ithas locked into position by pulling and pushing on the top of the seatback. B110A01TGB085D01TG-AAT Adjustable Headrests
Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. Tolower it, push it down while pressing the lock knob. To remove the head- rest, raise it as far as it can go thenpress the lock knob while pulling up- ward. This should only be done when the seat is not occupied. B080D01TG-1
Lock knob

1FEATURES OF YOUR HYUNDAI
30
B140A01S-AAT REAR SEAT WARNING For the safety of all passengers, lug- gage or other cargo should not be piled higher than the top of the seatback. Inaddition, do not place objects on the rear shelf as they may move forward during braking or in an accident andstrike vehicle passengers. B140A01TGB120A01NF-GAT REAR SEATBACK SAFETY LOCK (If Installed) If the rear seatback lock knob (located on the backside of the rear seatback)is in the "LOCK" position when the rear seatbacks are closed, it will not be possible to fold the rear seatback byusing the seatback release lever. In this instance, move the lock knob to the "UNLOCK" position and fold therear seatback. The rear seatback lock knob is designed to provide protection from unauthorized entry into the trunk. B120A01TG
!WARNING:
B080D02TG-1
o For maximum effectiveness in case of an accident the headrest should be adjusted so the middle of the headrest is at the same height as the top of the occupant's eyes. Forthis reason, the use of a cushion that holds the body away from the seatback should not be recom-mended.
o Do not operate vehicle with the
headrests removed as injury tothe occupants may occur in the event of an accident. Headrests may provide protection againstneck injuries when properly ad- justed.

1
FEATURES OF YOUR HYUNDAI
31SEAT BELTS
B150A02A-GAT SEAT BELT PRECAUTIONS All occupants of the vehicle should wear their seat belts at all times. In-deed, your province's laws may re- quire that some or all occupants of the vehicle use seat belts.The possibility of injury or the severity of injury in an accident will be de- creased if this elementary safety pre-caution is observed. In addition, the following recommendations are made: B150B01Y-GAT Infant or Small Child Some countries require the use of child restraint systems for infants and small children. Whether this is requiredby law or not, it is strongly recom- mended that a child restraint seat or infant restraint system be used forinfants or small children weighing less than 18 kilograms (40 pounds). NOTE: Small children are best protected in an accident when properly re- strained by a child restraint sys- tem. B150C02A-AAT Larger Children Children who are too large for child restraint systems should always oc-cupy the rear seat and use the avail- able lap/shoulder belts. The lap por- tion should be fastened snug on thehips and as low as possible. Check belt fit periodically. A child's squirming could put the belt out of position. Chil-dren are afforded the most safety in the event of an accident when they are restrained by a proper restraint sys-tem in the rear seat. If a larger child (over age 13) must be seated in the front seat, the child should be securelyrestrained by the available lap/shoul- der belt and the seat should be placed in the rearmost position. Children un-der the age of 13 should be restrained securely in the rear seat. NEVER place a child under the age of 13 in the frontseat. NEVER place a rear facing child seat in the front seat of a vehicle.
B150D01A-AAT Pregnant Women The use of a seat belt is recommended for pregnant women to lessen thechance of injury in an accident. When a seat belt is used, the lap belt portion should be placed as low and snugly aspossible on the hips, not across the abdomen. For specific recommenda- tions, consult a physician. B150E01A-AAT Injured Person A seat belt should be used when an injured person is being transported.When this is necessary, you should consult a physician for recommenda- tions.
B150F01A-AAT One Person Per Belt Two people (including children) should never attempt to use a single seat belt.This could increase the severity of injuries in case of an accident.