2004 MITSUBISHI ENDEAVOR air conditioning

Fig. 310: Removing And Installing Refrigerant Line

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

REMOVAL SERVICE POINT << A >> HOSE/PIPE DISCONNECTION To prevent the entry of other foreign bodies, plug the condenser, compressor, and
expansion valve nipples. << B >> SUCTION PIPE AND SUCTION FLEXIBLE HOSE DISCONNECTION
CAUTION: As the compressor oil and receiver are highly
moisture absorbent, use a non-porous material to
plug the hose and nipples.
CAUTION: As the compressor oil and receiver are highly

2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

To disconnect the suction hose from the suction flexible hose, lift the lug on the
suction pipe and twist the suction flexible hose union counterclockwise.
Plug the hose nipple to prevent entry of dust and dirt. Fig. 311: Disconnecting Suction Pipe

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

INSTALLATION SERVICE POINT >> A << SUCTION HOSE INSTALLATION When replacing the suction hose, refill them with a specified amount of compressor
oil, and then install them.
moisture absorbent, use a non-porous material to
plug the hose and nipples.

2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

Compressor oil: SUN PAG 56

Quantity:

Suction hose:
10 cm
3 (0.3 fl.oz)
VENTILATORS REMOVAL AND INSTALLATION
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

Fig. 312: Removing And Installing Ventilators (1 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

Fig. 313: Removing And Installing Ventilators (2 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS FASTENER TIGHTENING TORQUE SPECIFICATIONS

ITEM
SPECIFICATION
Liquid pipe mounting nut (heater unit side)
4.9 +/- 0.9 N.m
(43 +/- 8 in-

2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

GENERAL SPECIFICATIONS Fig. 314: General Specifications Chart

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

SERVICE SPECIFICATIONS Fig. 315: Service Specifications Chart

Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.
lb)
Liquid pipe mounting bolt (condenser side)
4.9 +/- 0.9 N.m (44 +/- 8 in-
lb)
Suction flexible hose mounting nut (compressor
side)
25 +/- 4 N.m (18 +/- 3ft-lb)
Suction pipe mounting nut (heater unit side)
4.9 +/- 0.9 N.m (43 +/- 8 in-
lb)
Discharge flexible hose mounting bolt
(compressor side)
25 +/- 4 N.m (18 +/- 3 ft-lb)
Discharge flexible hose mounting nut (condenser
side)
4.9 +/- 0.9 N.m (43 +/- 8 in-
lb)

2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

LUBRICANTS Lubricants Specifications

ITEM
SPECIFIED
LUBRICANT
QUANTITY
Each connection of refrigerant line
SUN PAG 56
As required
Compressor refrigerant unit lubricant
cm
3 (fl.oz)
SUN PAG 56
140 (4.7)

2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor

2004 HVAC
Automatic Air Conditioning - Endeavor
GENERAL DESCRIPTION For the heater and air conditioning system, the heater and cooling units are
combined in a single unit, which, with the a mode film damper and flow rate control
valve in the heater unit, reduces ventilation resistance, increases fan power, and
decreases noise. AUTOMATIC AIR CONDITIONING GENERAL DESCRIPTION

SAFETY PRECAUTIONS Because R-134a refrigerant is a hydro fluorocarbon (HFC) which contains
hydrogen atoms in place of chlorine atoms, it will not cause damage to the ozone
layer.
Ozone filters out harmful radiation from the sun. To assist in protecting the ozone
layer, Mitsubishi Motors Corporation recommends an R-134a refrigerant recycling
device.
Refrigerant R-134a is transparent and colorless in both the liquid and vapor state.
Since it has a boiling point of -29.8°C (-21.64°F) at atmospheric pressure, it will be
a vapor at all normal temperatures and pressures. The vapor is heavier than air, non-
flammable, and no
n-ex
plosive. The followin
g precautions must be observed when
ITEM
SPECIFICATION
Heater control assembly
dial type
Compressor
MSC105CA
Compressor Model
Scroll type
Refrigerant and quantity g
(oz)
R-134a (HFC-134a), Approximately 560 - 600
(19.75 - 21.16)
WARNING:Wear safety goggles and gloves when servicing the
refrigeration system to prevent severe damage to
eyes and hands.

2004 Mitsubishi Endeavor LS
2004 HVAC Automatic Air Conditioning - Endeavor


2004 Mitsubishi Endeavor LS
2004 HVAC Automatic Air Conditioning - Endeavor