2003 MAZDA MODEL PROTÉGÉ Owners Manual (in English)

8-36
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G

Replacing a Bulb (Rear)
Rear bulb access
(Sedan)
To replace the turn signal light, brake
light/taillight, side-marker light or reverse
light bulb, the trunk end trim must be
removed and the inside cover must be
partially opened.
1. Pull the center section of the plastic
retainer and remove the retainers and
the trunk end trim.
2. Remove the inside cover’s plastic
retainers and partially open the inside
cover.(Hatchback)
To replace the turn signal light, brake
light/taillight or reverse light bulb, remove
the caps and the cover.
Jack cover
J39L_EA.book Page 36 Saturday, June 8, 2002 5:35 PM

8-37
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
Brake lights/Taillights
Rear side-marker lights
Reverse lights
Taillights
Rear turn signal lights
High-mount brake light (Sedan) License plate lights
Trunk light (Sedan)
Sedan
Sedan
Hatchback
Hatchback Brake lights/Taillights
Rear turn signal lights
Reverse lights
Sedan
To replace the high-
mount brake light bulb,
contact an Authorized
Mazda Dealer.
J39L_EA.book Page 37 Saturday, June 8, 2002 5:35 PM

8-38
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
Yo u r v e h i c l e’s electrical system is
protected by fuses.
If any lights, accessories, or controls don’t
work, inspect the appropriate circuit
protector. If a fuse has blown, the inside
element will be melted.
If the same fuse blows again, avoid using
that system and consult an Authorized
Mazda Dealer as soon as possible.

Fuse Replacement
If the electrical system doesn’t work, first
inspect fuses on the driver’s side.
1. Turn off the ignition switch and other
switches.
2. Open the fuse panel cover.3. Pull the fuse straight out with the fuse
puller provided on the fuse panel.
4. Inspect it and replace if it’s blown.
5. Push in a new fuse of the same rating,
and make sure it fits tightly. If it
doesn’t, have an Authorized Mazda
Dealer install it.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the RADIO circuit.
Fuses
Fuse panel cover
Always replace a fuse with one of the
same rating. Otherwise you may
damage the electric system.
Fuse puller
Normal Blown
CAUTION
J39L_EA.book Page 38 Saturday, June 8, 2002 5:35 PM

8-39
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
If the headlights or other electrical
components don’t work and the fuses in
the cabin are OK, inspect the fuse block
under the hood. If a fuse is blown, it must
be replaced. Follow these steps:
1. Turn off the ignition switch and all
other switches.
2. Remove the fuse block cover.
3. If a fuse is blown, replace it with a new
one of the same rating.
NOTE
To replace the MAIN fuse, contact an
Authorized Mazda Dealer (page 8-40).
Ta b
Fuse block
cover
Normal Blown
J39L_EA.book Page 39 Saturday, June 8, 2002 5:35 PM

8-40
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G

Fuse Panel Description
Fuse block (Engine compartment)
DESCRIPTIONFUSE
RATINGPROTECTED
COMPONENT
1HEATER 40 A Heater
2 ABS 60 AAntilock brake
system, For
protection of
various circuits
3 IG KEY 60 AFor protection of
various circuits
4 PTC 30 A—
5GLOW 40 A—
6—— —
7COOLING
FA N30 A Cooling fan
8 BTN 40 AInterior lights,
Power door lock
9 AD FAN 30 AAdditional
cooling fan for air
conditioner
10INJ OR
FIP30 AEngine control
unit
11 A/C 10 A Air conditionerDESCRIPTIONFUSE
RATINGPROTECTED
COMPONENT
12 ST.SIG 10 A Starter signal
13 HORN 15 A Horn
14 HAZARD 15 AHazard warning
flashers
15 TAIL 15 A Taillights
16HEAD
C/U7.5 AFor protection of
various circuits
17 FOG 15 A—
18 FOG 15 A Fog lights
19 STOP 15 A Brake lights
20 HEAD-R 15 A Headlight-right
21 HEAD-L 15 A Headlight-left
22—— —
23 HEAD HI 15 A—
24 MAIN 100 AFor protection of
all circuits
J39L_EA.book Page 40 Saturday, June 8, 2002 5:35 PM

8-41
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
Fuse panel (Driver’s side)
DESCRIPTIONFUSE
RATINGPROTECTED
COMPONENT
1 S/WRM 15 AFor protection of
various circuits
2 H/CLN 20 AFor protection of
various circuits
3 RADIO 15 A Audio system
4 A/C 15 A Air conditioner
5 R.WIPER 10 AFor protection of
various circuits
6—— —
7—— —
8 ROOM 10 AInterior lights,
Trunk light,
Luggage
compartment light
9MIRR DEF 10 A—
10—— —
11DOOR
LOCK30 A Power door lock
12 P/WIND 30 A—DESCRIPTIONFUSE
RATINGPROTECTED
COMPONENT
13 WIPER 20 AWindshield wiper
and washer
14 ENGINE 10 AEngine control
unit
15 METER 10 A Instrument cluster
16—— —
17 P/WIND 30 A Power windows
J39L_EA.book Page 41 Saturday, June 8, 2002 5:35 PM

8-42
Maintenance and Care
Form No. 8Q94-EA-02G
Appearance Care
The paintwork on your Mazda represents
the latest technical developments in
composition and methods of application.
Environmental hazards, however, can
harm the paint’s protective properties, if
proper care is not taken.
Here are some examples of possible
damage, with tips on how to prevent them.

Etching Caused by Acid Rain or
Industrial Fallout
Occurrence
Industrial pollutants and vehicle
emissions drift into the air and mix with
rain or dew to form acids. These acids can
settle on a vehicle’s finish. As the water
evaporates, the acid becomes concentrated
and can damage the finish.
And the longer the acid remains on the
surface, the greater the chance is for
damage.
Prevention
It is necessary to wash and wax your
vehicle to preserve its finish according to
the instructions in this section. These
steps should be taken immediately after
you suspect that acid rain has settled on
your vehicle’s finish.

Damage Caused by Bird
Dropping, Insects, or Tree Sap
Occurrence
Bird droppings contain acids. If these
aren’t removed they can eat away the clear
and color base coat of the vehicle’s
paintwork.
When insects stick to the paint surface
and decompose, corrosive compounds
form. These can erode the clear and color
base coat of the vehicle’s paintwork if
they are not removed.
Tree sap will harden and adhere
permanently to the paint finish. If you
scratch the sap off while it is hard, some
vehicle paint could come off with it.
Prevention
It is necessary to have your Mazda
washed and waxed to preserve its finish
according to the instructions in this
section. This should be done as soon as
possible.
Bird droppings can be removed with a soft
sponge and water. If you are traveling and
these are not available, a moistened tissue
may also take care of the problem. The
cleaned area should be waxed according
to the instructions in this section.
Insects and tree sap are best removed with
a soft sponge and water or a commercially
available chemical cleaner.
Another method is to cover the affected
area with dampened newspaper for one to
two hours. After removing the newspaper,
rinse off the loosened debris with water.
How to Minimize
Environmental Paint
Damage
J39L_EA.book Page 42 Saturday, June 8, 2002 5:35 PM

8-43
Maintenance and Care
Appearance Care
Form No. 8Q94-EA-02G

Water Marks
Occurrence
Rain, fog, dew, and even tap water can
contain harmful minerals such as salt and
lime. If moisture containing these
minerals settles on the vehicle and
evaporates, the minerals will concentrate
and harden to form white rings. The rings
can damage your vehicle’s finish.
Prevention
It is necessary to wash and wax your
vehicle to preserve its finish according to
the instructions in this section. These
steps should be taken immediately after
you find water marks on your vehicle’s
finish.

Paint Chipping
Occurrence
Paint chipping occurs when gravel thrown
in the air by another vehicle’s tires hits
your vehicle.
How to avoid paint chipping
Keeping a safe distance between you and
the vehicle ahead reduces the chances of
having your paint chipped by flying
gravel.
NOTE
•The paint chipping zone varies with
the speed of the vehicle. For
example, when traveling at 90 km/h
(56 mph), the paint chipping zone is
50 m (164 ft).
•In low temperatures a vehicle’s
finish hardens. This increases the
chance of paint chipping.
•Chipped paint can lead to rust
forming on your Mazda. Before this
happens, repair the damage by using
Mazda touch-up paint according to
the instructions in this section.
Failure to repair the affected area
could lead to serious rusting and
expensive repairs.
J39L_EA.book Page 43 Saturday, June 8, 2002 5:35 PM