2003 Hyundai H-1 (Grand Starex) recommended oil

STARTING & OPERATING
STARTING & OPERATING STARTING & OPERATING
STARTING & OPERATING
STARTING & OPERATING
3-16 D180H01P-GAT
Parking brake
Parking brake Parking brake
Parking brake
Parking brake
If the atmospheric temperature is below freez- ing, park the vehicle with the gearshift lever in1st or reverse and do not engage the parkingbrake. If the parking brake is engaged and thereis moisture on the brake linings, the liningscould become frozen to the brake drums, mak-ing it impossible to release the parking brake.
C160G02A-AAT
To Keep Locks from Freezing
To Keep Locks from Freezing To Keep Locks from Freezing
To Keep Locks from Freezing
To Keep Locks from Freezing
To keep the locks from freezing, squirt anapproved de-icer fluid or glycerine into the keyopening. If a lock is covered with ice, squirt itwith an approved de-icing fluid to remove theice. If the lock is frozen internally, you may beable to thaw it out by using a heated key.Handle the heated key with care to avoid burn-ing your fingers.
NOTE:
NOTE: NOTE:
NOTE:
NOTE:
The proper temperature for using the immo-
The proper temperature for using the immo- The proper temperature for using the immo-
The proper temperature for using the immo-
The proper temperature for using the immo-
bilizer key is from -40°C to 80°C. If you heat
bilizer key is from -40°C to 80°C. If you heat bilizer key is from -40°C to 80°C. If you heat
bilizer key is from -40°C to 80°C. If you heat
bilizer key is from -40°C to 80°C. If you heat
the immobilizer key over 80°C to open the
the immobilizer key over 80°C to open the the immobilizer key over 80°C to open the
the immobilizer key over 80°C to open the
the immobilizer key over 80°C to open the
frozen lock, it may cause damage to the
frozen lock, it may cause damage to the frozen lock, it may cause damage to the
frozen lock, it may cause damage to the
frozen lock, it may cause damage to the
transponder in its head.
transponder in its head. transponder in its head.
transponder in its head.
transponder in its head. D180G01P-GAT
Door locks
Door locks Door locks
Door locks
Door locks
To prevent the door locks from freezing up, the lock cylinders should be masked with tape,etc., when washing the vehicle in cold weatherto prevent the entrance of water.
D180E01P-GAT
Wiper blades
Wiper blades Wiper blades
Wiper blades
Wiper blades
Before operating the wipers, check the wiperblades to confirm that they are not frozen to thewindshield or tailgate. If the blades are frozen tothe windshield or tailgate, do not operate thewipers until the ice has melted and the bladesare freed. D180F01P-GAT
Ventilation slots
Ventilation slots Ventilation slots
Ventilation slots
Ventilation slots
The ventilation slots in the headlight housing on the assistant seat side should be brushed clearafter a heavy snowfall so that the operation ofthe heating and ventilation systems will not beimpaired.
anyway, will only deliver a fraction of the startercurrent which is normally available. It is recommended that you have the battery checked by an authorized HYUNDAI dealerbefore the start of cold weather and, if neces-sary, have it charged. This not only ensures reliable starting, but a battery which is kept fully charged also has alonger life. D180D01P-GAT
Washer fluid
Washer fluid Washer fluid
Washer fluid
Washer fluid
To ensure proper operation of the windshield or rear window at low temperatures, anti-freezeshould be added to the washer fluid at a rate ofone part antifreeze to one part water.
D180A01P-GAT
DURING COLD WEATHER
DURING COLD WEATHER DURING COLD WEATHER
DURING COLD WEATHER
DURING COLD WEATHER
Engine oil
Engine oil Engine oil
Engine oil
Engine oil
The engine oil can become very thick at low
temperatures, thus making it difficult to start theengine.
Change to a thinner oil designed for winter use
before the start of cold weather; for the appro-priate oil viscosity, refer to the "Consumer Infor-mation" section.
D180B01P-GATEngine coolant
Engine coolant Engine coolant
Engine coolant
Engine coolant
If the temperature in your area drops below
freezing, there is the danger that the coolant inthe engine or radiator could freeze and causesevere damage to the engine and/or radiator. Be sure to add a sufficient amount of antifreeze
to the coolant to prevent it from freezing.
The engine coolant mixture used at the factory
is intended to be left in the cooling system andprovides protection against freezing for tem-perature as low as approximately -30°C (-20°F).The concentration should be checked beforethe start of cold weather and anti-freeze addedto the system if necessary
D180C01P-GATBattery
Battery Battery
Battery
Battery
The capacity of the battery is reduced at low
temperatutes.
This is an inevitable result of its chemical and
physical properties. This is why a very coldbattery, particularly one that is not fully charged

6-9
PREVENTIVE MAINTENANCE
PREVENTIVE MAINTENANCE PREVENTIVE MAINTENANCE
PREVENTIVE MAINTENANCE
PREVENTIVE MAINTENANCE
G080F01P-GAToo
oo
o
Fuel hose, vapor hose and fuel
Fuel hose, vapor hose and fuel Fuel hose, vapor hose and fuel
Fuel hose, vapor hose and fuel
Fuel hose, vapor hose and fuel
filler cap
filler cap filler cap
filler cap
filler cap
The fuel hose, vapor hose and fuel filler cap
should be inspected at those intervals specified in the maintenance schedule. Make sure that anew fuel hose, vapor hose or fuel filler cap iscorrectly replaced. Consult your Hyundai dealerif you have any questions.
G080G01P-GAToo
oo
o Air cleaner filter
Air cleaner filter Air cleaner filter
Air cleaner filter
Air cleaner filter
A genuine Hyundai part is recommended forreplacement of the air cleaner filter. G080H01P-GAT
oo
oo
o Spark plugs
Spark plugs Spark plugs
Spark plugs
Spark plugs
Make sure to install new spark plugs of the correct heat range. G080I01P-GAT
oo
oo
o
Drive belts
Drive belts Drive belts
Drive belts
Drive belts
Inspect all drive belts (water pump and alterna- tor) for evidence of cuts, cracks, excessivewear or oiliness, and replace if necessary.Drive belts should be checked periodically forproper tension and adjusted as necessary.
G080D01P-GAT
oo
oo
o Fuel filter
Fuel filter Fuel filter
Fuel filter
Fuel filter
A clogged filter can limit the speed at which the
vehicle may be driven, damage the emissionsystem and cause hard starting. If an exces-sive amount of foreign matter accumulates inthe fuel tank, the filter may require replacementmore frequently.
After installing a new filter, run the engine for
several minutes, and check for leaks at theconnections.
G080A01P-GAT
EXPLANATION OF SCHEDULED
EXPLANATION OF SCHEDULED EXPLANATION OF SCHEDULED
EXPLANATION OF SCHEDULED
EXPLANATION OF SCHEDULED
MAINTENANCE ITEMS
MAINTENANCE ITEMS MAINTENANCE ITEMS
MAINTENANCE ITEMS
MAINTENANCE ITEMS
oo
oo
o
Engine oil and filter
Engine oil and filter Engine oil and filter
Engine oil and filter
Engine oil and filter
The engine oil and filter should be changed at
those intervals specified in the maintenanceschedule. If the vehicle is being driven in se-vere conditions, more frequent oil and filterchanges are required.
G080B01P-GAT oo
oo
o Valve clearances (DIESEL)
Valve clearances (DIESEL) Valve clearances (DIESEL)
Valve clearances (DIESEL)
Valve clearances (DIESEL)
An incorrect valve clearance will not only result
in rough engine operation, but will also causeexcessive noise and reduced engine output.
Inspect valve clearance and adjust as required
while the engine is hot.
Valve-to-rocker arm clearance:
Valve-to-rocker arm clearance: Valve-to-rocker arm clearance:
Valve-to-rocker arm clearance:
Valve-to-rocker arm clearance: DIESEL:
Hot ............................ 0.25 mm (0.0098 in.) Cold ............................ 0.15 mm (0.0059 in.)
G080C01P-GAT oo
oo
o Fuel lines and connections
Fuel lines and connections Fuel lines and connections
Fuel lines and connections
Fuel lines and connections
Check the fuel lines and connections for leak-
age and damage. Replace any damaged or leaking parts immediately. G080E01P-GAT
oo
oo
o Vacuum and crankcase
Vacuum and crankcase Vacuum and crankcase
Vacuum and crankcase
Vacuum and crankcase
ventilation hoses
ventilation hoses ventilation hoses
ventilation hoses
ventilation hoses
Inspect the surface of hoses for evidence of
heat and/or mechanical damage. Hard andbrittle rubber, cracking, tears, cuts, abrasions,and excessive swelling indicate deterioration.Particular attention should be paid to examiningthose hose surfaces nearest to high heatsources, such as the exhaust manifold.
Inspect the hose routing to assure that the
hoses do not come in contact with any heatsource, sharp edges or moving componentwhich might cause heat damage or mechanicalwear. Inspect all hose connections, such asclamps and couplings, to make sure they aresecure, and that no leaks are present. Hosesshould be replaced immediately if there is anyevidence of deterioration or damage.

9-3
VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS
J060A06P-GAT LUBRCATION CHART
LUBRCATION CHART LUBRCATION CHART
LUBRCATION CHART
LUBRCATION CHART
Recommended in field
SAE #30 (ABOVE 0°C) SAE 20W-40 (ABOVE -10°C)SAE 15W-40 (ABOVE -15°C)SAE 10W-30 (-20°C ~ 40°C)SAE 5W-30 (-25°C ~ 10°C)SAE 0W-30 (BELOW 10°C) *1 SAE 30 (0°C ~ 40°C)SAE 20W-40 (ABOVE -10°C)SAE 15W-40 (ABOVE -15°C)SAE 10W-30 (-20°C~ 40°C)SAE 0W-30 (BELOW 10°C) *1SAE 20W-40, 20W-50 (ABOVE -10°C) SAE 15W-40, 15W-50 (ABOVE -15°C)SAE 10W-30 (-25°C ~ 40°C)SAE 10W-40, 10W-50 (ABOVE -25°C)SAE 5W-20 (BELOW -10°C) *1, *2 SAE 5W-30 (BELOW 10°C) *1 SAE 5W-40 (BELOW 20°C) *1
NORMAL DRIVING CONDITION SEVERE DRIVING CONDITION
Items
ENGINE OIL (DIESEL) ENGINE OIL (GASOLINE)
(Minibus, Van) ENGINE OIL CONSUMPTIONQuantity (liter)
Engine Oil : 6.1 at Oil Pan : 4.9
Engine Oil : 7.4 at Oil Pan : 6.6 (MAX)
4.9 (MIN)
Engine Oil : 4.3 at Oil Pan : 4.0 (MAX)
3.0 (MIN)
at Oil Filter : 0.3
Max. 1L/ 1,500 km Max. 1L/ 1,000 km
API CF-4 or ABOVE API CF-4 or ABOVE
API CE or ABOVE API SG, SG/CD, SH or SH/CD API SE or ABOVE
2.6 N/A
2.5 4D56 T/C or TCI 2.5 CRDi TCI E.C
Except E.C
*1. Restricted by driving condition and area.
*2. SAE 5W-20 not recommended for sustained high speed vehicle operation.

VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS
VEHICLE SPECIFICATIONS
9-4 Quantity (liter)
Minibus, Van : 1.3 0.8
Minibus : 13, Van : 10, Truck : 7.2 As required As required
Minibus, Van : 2.6, Truck : 1.7
As required Diesel
2.6 N/A(long Van) : 8.5 2.6 N/A : 72.5 4D56 T/C : 8.52.5 4D56 TCI(3Van, 11/12Minibuss) : 8.52.5 4D56 TCI EURO III(3Van, 11/12Minibuss) : 7.53
2.5 4D56 TCI EURO III(6Van, 7/9Minibuss) : 7.53
2.5 4D56 TCI(4WD) : 9.832.5 CRDi TCI(2WD) : 8.32.5 CRDi TCI(4WD) : 11.7
Recommended in field
HYUNDAI GENUINE PARTS MTF 75W/90 (API GL-4) DIAMOND ATF DEXRON II, DIAMOND ATF SP I
DIAMOND ATF SP II
PSF-3 HIGH QUALITY ETHYLENE GLYCOL BASE FOR ALUMINUM RADIATORSAE J 1703 EQUIVALENTSAE J310a, MULTI-PURPOSE GREASE NLGI-2 OREQUIVALENT.
API GL-4 (MS517-15) : SAE 90, 140
API GL-5 (MS517-15) : SAE 80
Items
MANUAL TRANSMISSION OIL AUTOMATIC TRANSMISSION OIL TRANSFER CASE OIL POWER STEERING OIL COOLANT CLUTCH & BRAKE FLUIDFRONT, REAR WHEEL BEARING REAR AXLE STEERING GEAR BOX
Gasoline 2.0 Diesel
2.6 N/A : 2.0 2.5 4D56 T/C or TCI : 2.42.5 CRDi TCI : 3.2
Gasoline
7.53
J060A05P-GATLUBRCATION CHART
LUBRCATION CHART LUBRCATION CHART
LUBRCATION CHART
LUBRCATION CHART