
INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS
2-8 C130A04P-GAT
INDICATION AND WARNING LAMPS
INDICATION AND WARNING LAMPS INDICATION AND WARNING LAMPS
INDICATION AND WARNING LAMPS
INDICATION AND WARNING LAMPS 
1. A/T Oil temperature warning light (If installed) 
2. 4WD high indicator light
3. Fuel filter warning light (Diesel only) 
4. 4WD low indicator light 
5. POWER mode indicator light (A/T only)
6. Charge warning light
7. Brake warning and parking brake indicator
light
8. SRS (Airbag) warning light (If installed)   9. Diesel preheat indicator light
10. Overdrive off indicator light (A/T only)
11. Door-ajar warning light
12. Automatic transmission position indicator
light (A/T only)
13. High-beam indicator light 
14. Turn-signal indicator light 
15. HOLD mode indicator light (A/T only) 16. Oil pressure warning light
17. Low fuel warning light
18. Immobilizer warning indicator light/
Seat belt reminder light (If installed)
19. ABS Service reminder indicator light (SRI) (If installed)
20. Malfunction indicator light (MIL) (If installed)
2
C130A01P-3
14
13 678 1 618 19 20
17
12
111091 345
15   

INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS
2-10 C130P01P-GAT
A/T (AUTOMATIC TRANSMIS-
A/T (AUTOMATIC TRANSMIS- A/T (AUTOMATIC TRANSMIS-
A/T (AUTOMATIC TRANSMIS-
A/T (AUTOMATIC TRANSMIS-
SION) OIL TEMPERATURE
SION) OIL TEMPERATURE SION) OIL TEMPERATURE
SION) OIL TEMPERATURE
SION) OIL TEMPERATURE
WARNING LIGHT
WARNING LIGHT WARNING LIGHT
WARNING LIGHT
WARNING LIGHT
 (If installed)
 (If installed)  (If installed)
 (If installed)
 (If installed)
The A/T oil temperature warning light comes on when the automatic transmission oil tempera-ture  goes up to the temperature that may resultin serious damage of automatic transmission. If the A/T oil temperature warning light comes on while driving, park your vehicle in at a safeplace as soon as possible and with the selectorlever is shifted into "P" position, and allow theengine to idle until the warning light goes off.And when the warning light goes off, the vehiclecan be driven normally. If the warning light doesn't go off or it lights up frequently, have the vehicle checked by yourHyundai dealer.
A/TA/T
A/TA/T
A/T
TEMPTEMP
TEMPTEMP
TEMP
NOTE:
NOTE: NOTE:
NOTE:
NOTE:
If the engine were not started within 10
If the engine were not started within 10 If the engine were not started within 10
If the engine were not started within 10
If the engine were not started within 10 seconds after the preheating is completed,
seconds after the preheating is completed, seconds after the preheating is completed,
seconds after the preheating is completed,
seconds after the preheating is completed,
turn the ignition key once more to the
turn the ignition key once more to the turn the ignition key once more to the
turn the ignition key once more to the
turn the ignition key once more to the
"LOCK" position, and then to the "ON" po-
"LOCK" position, and then to the "ON" po- "LOCK" position, and then to the "ON" po-
"LOCK" position, and then to the "ON" po-
"LOCK" position, and then to the "ON" po-
sition, in order to preheat again.
sition, in order to preheat again. sition, in order to preheat again.
sition, in order to preheat again.
sition, in order to preheat again. B260E02A-GAT
SEAT BELT REMINDER LIGHT
SEAT BELT REMINDER LIGHT SEAT BELT REMINDER LIGHT
SEAT BELT REMINDER LIGHT
SEAT BELT REMINDER LIGHT
(If installed)
(If installed) (If installed)
(If installed)
(If installed)
The seat belt reminder light comes on until your seat belt is fastened when the ignition key isturned from the "OFF" position to "ON" or"START". C130O01P-GAT
ENGINE WARNING LIGHT
ENGINE WARNING LIGHT ENGINE WARNING LIGHT
ENGINE WARNING LIGHT
ENGINE WARNING LIGHT
(If installed)
(If installed) (If installed)
(If installed)
(If installed)
This light illuminates when there is a malfunc-
tion of an exhaust gas related component, andthe system is not functioning properly so thatthe exhaust gas regulation values are not satis-fied. This light will also illuminate when theignition key is turned to the "ON" position, andthen it will go out in a few seconds. If it illumi-nates while driving, or does not illuminate whenthe ignition key is turned to the "ON" position,take your car to your nearest authorized Hyundaidealer and have the system checked.
B260B01S-GAT SRS (AIRBAG) SERVICE
SRS (AIRBAG) SERVICE SRS (AIRBAG) SERVICE
SRS (AIRBAG) SERVICE
SRS (AIRBAG) SERVICE
REMINDER INDICATOR
REMINDER INDICATOR REMINDER INDICATOR
REMINDER INDICATOR
REMINDER INDICATOR  (SRI)
 (SRI)  (SRI)
 (SRI)
 (SRI)
(If installed)
(If installed) (If installed)
(If installed)
(If installed)
The SRS service reminder indicator (SRI)
comes on and flashes for about  6 secondsafter the ignition key is turned to the "ON"
position or after the engine is started, afterwhich it will go out.
This light also comes on when the SRS is not
working properly. If the SRI does not come on,or continuously remains on after flashing forabout 6 seconds when you turned the ignition
key to the "ON" position or started the engine,or if it comes on while driving, have the SRSinspected by an authorized Hyundai Dealer.
C130N01P-GAT
ANTI-LOCK BRAKE WARNING
ANTI-LOCK BRAKE WARNING ANTI-LOCK BRAKE WARNING
ANTI-LOCK BRAKE WARNING
ANTI-LOCK BRAKE WARNING
LIGHT (If installed)
LIGHT (If installed) LIGHT (If installed)
LIGHT (If installed)
LIGHT (If installed)
When the key is turned to the "ON" position, the
ABS light will come on and then go off in a fewseconds. If the ABS light remains on, comes on while
driving, or does not come on when the key isturned to the "ON" position, this indicates thatthere may be a problem with the ABS.
If this occurs, have your vehicle checked by
your Hyundai dealer as soon as possible. Thenormal braking system will still be operational,but without the assistance of the anti-lock brakesystem.
AIRAIR
AIRAIR
AIR
BAGBAG
BAGBAG
BAG
B270B02O-GATPARKING START WARNING SOUND
PARKING START WARNING SOUND PARKING START WARNING SOUND
PARKING START WARNING SOUND
PARKING START WARNING SOUND
(If installed)
(If installed) (If installed)
(If installed)
(If installed)
If the vehicle driven at over 10km/h(6mph) more 2~3 seconds, the warning chime will soundcontinuously when the parking brake engaged.   

  3-9
STARTING & OPERATING
STARTING & OPERATING STARTING & OPERATING
STARTING & OPERATING
STARTING & OPERATING
D090A01P-GAG
D090A01P-GAT
FOUR-WHEEL DRIVE (4WD)
FOUR-WHEEL DRIVE (4WD) FOUR-WHEEL DRIVE (4WD)
FOUR-WHEEL DRIVE (4WD)
FOUR-WHEEL DRIVE (4WD)
(Minibus, Van) (If installed)
(Minibus, Van) (If installed) (Minibus, Van) (If installed)
(Minibus, Van) (If installed)
(Minibus, Van) (If installed) You can send your engine power to all front and rear wheels for maximum power. 4WD is usefulwhen you drive in snow, mud, ice, mountainousor sandy areas where good traction is required,or when your wheels lose traction using two-wheel drive.
Switch position
Switch position Switch position
Switch position
Switch position
2H(Rear-wheel drive)
2H(Rear-wheel drive) 2H(Rear-wheel drive)
2H(Rear-wheel drive)
2H(Rear-wheel drive) When driving on normal roads and highway. 4H(High range 4-wheel drive)
4H(High range 4-wheel drive) 4H(High range 4-wheel drive)
4H(High range 4-wheel drive)
4H(High range 4-wheel drive)
When driving deep snow, sand or rough roads
with normal speed. The 4WD indication light(HI) will be turned on to remind you that you are inthe 4H mode.
4L(Low range 4-wheel drive)
4L(Low range 4-wheel drive) 4L(Low range 4-wheel drive)
4L(Low range 4-wheel drive)
4L(Low range 4-wheel drive)
When driving up or descending steep slopes or
rough roads such as muddy road. Especiallywhen increased drive power is required.
The indication light(LO) will be turned on to
remind you that you are in the 4L mode.
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
Do not select 4WD mode on dry paved roads.
Do not select 4WD mode on dry paved roads. Do not select 4WD mode on dry paved roads.
Do not select 4WD mode on dry paved roads.
Do not select 4WD mode on dry paved roads. Especially on dry high way, never select the
Especially on dry high way, never select the Especially on dry high way, never select the
Especially on dry high way, never select the
Especially on dry high way, never select the
4WD(4H or 4L).
4WD(4H or 4L). 4WD(4H or 4L).
4WD(4H or 4L).
4WD(4H or 4L).
Four-wheel driving on dry paved roads for a
Four-wheel driving on dry paved roads for a Four-wheel driving on dry paved roads for a
Four-wheel driving on dry paved roads for a
Four-wheel driving on dry paved roads for along period will increase the fuel consump-
long period will increase the fuel consump- long period will increase the fuel consump-
long period will increase the fuel consump-
long period will increase the fuel consump-
tion with possible noise generation and ear-
tion with possible noise generation and ear- tion with possible noise generation and ear-
tion with possible noise generation and ear-
tion with possible noise generation and ear-
ly tire wear. In addition, differential oil tem-
ly tire wear. In addition, differential oil tem- ly tire wear. In addition, differential oil tem-
ly tire wear. In addition, differential oil tem-
ly tire wear. In addition, differential oil tem-
perature increases with possible driving
perature increases with possible driving perature increases with possible driving
perature increases with possible driving
perature increases with possible driving
system part wear.
system part wear. system part wear.
system part wear.
system part wear.
D090D02P-GAT
Transfer shift switch operation
Transfer shift switch operation Transfer shift switch operation
Transfer shift switch operation
Transfer shift switch operation
By selecting the transfer shift switch(4H, 4L),
the both axles of the vehicle are rigidly connect- ed with each other. This improves the tractioncharacteristics.
2H 2H 
2H 2H 
2H 
 4H 4H
 4H 4H
 4H
Select the 4H mode switch at speed below
60~70 km/h. It is not necessary to depress theclutch pedal (Manual Transmission) or put theshift lever into "N(neutral)" position (AutomaticTransmission). Perform this operation whendriving straight.
4H 4H 
4H 4H 
4H 
 2H 2H
 2H 2H
 2H
Select the 2H mode switch. This can be done at
any speed, and it is not necessary to depressthe clutch pedal (Manual Transmission) or putthe shift lever into "N(neutral)" position (Auto-matic Transmission). Perform this operationwhen driving straight.
NOTE:
NOTE: NOTE:
NOTE:
NOTE:
If the transfer shift is switched into 2H mode,
If the transfer shift is switched into 2H mode, If the transfer shift is switched into 2H mode,
If the transfer shift is switched into 2H mode,
If the transfer shift is switched into 2H mode, while the vehicle is making a sharp turn or
while the vehicle is making a sharp turn or while the vehicle is making a sharp turn or
while the vehicle is making a sharp turn or
while the vehicle is making a sharp turn or
performing abrupt maneuver, the 4H indica-
performing abrupt maneuver, the 4H indica- performing abrupt maneuver, the 4H indica-
performing abrupt maneuver, the 4H indica-
performing abrupt maneuver, the 4H indica-
tor light in the instrument panel will turn off.
tor light in the instrument panel will turn off. tor light in the instrument panel will turn off.
tor light in the instrument panel will turn off.
tor light in the instrument panel will turn off.
However, the vehicle will still be in 4H mode.
However, the vehicle will still be in 4H mode. However, the vehicle will still be in 4H mode.
However, the vehicle will still be in 4H mode.
However, the vehicle will still be in 4H mode.This condition is normal.
This condition is normal. This condition is normal.
This condition is normal.
This condition is normal.
When the vehicle returns to normal driving
When the vehicle returns to normal driving When the vehicle returns to normal driving
When the vehicle returns to normal driving
When the vehicle returns to normal drivingcondition, the 4WD system will automatical-
condition, the 4WD system will automatical- condition, the 4WD system will automatical-
condition, the 4WD system will automatical-
condition, the 4WD system will automatical-
ly transfer to the 2H mode.
ly transfer to the 2H mode. ly transfer to the 2H mode.
ly transfer to the 2H mode.
ly transfer to the 2H mode.