2003 DAEWOO MATIZ brake

9G –16 INTERIOR TRIM
DAEWOO M-150 BL2
D109E578
Installation Procedure
1. Install the parking brake cable cover with the screw.
D109E581
FLOOR CARPET
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front seats. Refer to Section 9H, Seats.
3. Remove the rear seat cushion. Refer to Section 9H,
Seats.
4. Remove the floor console. Refer to “Floor Console”
in this section.
5. Pry off the front rocker trim panel. Refer to “Front
Rocker Trim Panel” in this section.
6. Pry off the rear rocker trim panel. Refer to “Rear
Rocker Trim Panel” in this section
7. Pry off the lower B–pillar trim panel. Refer to “Lower
B–pillar Trim Panel” in this section.
8. Remove the parking brake cable cover. Refer to
“Parking Brake Cable Cover” in this section.
9. Remove the clips under the front seats.
D109E582
11. Remove the floor carpet.
a. Floor carpet.

INTERIOR TRIM 9G–17
DAEWOO M-150 BL2
D109E583
Installation Procedure
1. Install the floor carpet.
2. Install the clips.
3. Install the parking brake cable cover. Refer to “Park-
ing Brake Cable Cover” in this section.
4. Install the lower B–pillar trim panel. Refer to “Lower
B–pillar Trim Panel” in this section.
5. Install the rear rocker trim panel. Refer to “Rear
Rocker Trim Panel” in this section.
6. Install the front rocker trim panel. Refer to “Front
Rocker Trim Panel” in this section.
7. Install the floor console. Refer to “Floor Console” in
this section.
8. Install the rear seat cushion. Refer to Section 9H,
Seats.
9. Install the front seats. Refer to Section 9H, Seats.
10. Connect the negative battery cable.
D109E584
LUGGAGE COMPARTMENT
WHEELHOUSE TRIM PANEL
Removal Procedure
1. Pry off the luggage compartment wheel house trim
panel.

Remove the screws (1).

Pry off the trim panel (2).
D109E585
Installation Procedure
1. Install the luggage compartment wheelhouse trim
panel with the plastic screws.

DAEWOO M-150 BL2
SECTION 9K
SQUEAKS AND RATTLES
TABLE OF CONTENTS
Diagnostic Information and Procedures 9K-1. . . . .
Squeak and Rattle Diagnosis 9K-1. . . . . . . . . . . . . . . Repair Instructions 9K-3. . . . . . . . . . . . . . . . . . . . . . . . .
On-Vehicle Service 9K-3. . . . . . . . . . . . . . . . . . . . . . . . . .
Squeak and Rattle Repair 9K-3. . . . . . . . . . . . . . . . . .
DIAGNOSTIC INFORMATION AND PROCEDURES
SQUEAK AND RATTLE DIAGNOSIS
ConditionProbable CauseCorrection
Rattle Coming From the
Side Rail
Improperly connected brake
lines.
Tap lightly on the brake lines and listen for a
rattle.

Install plastic tie straps to secure the brake
lines tightly together.
Rattle Under Vehicle at
Higher RPM
The heat shield contacts with
the underbody.
Raise the vehicle and perform a visual
inspection.

Bend the heat shield slightly to gain
clearance from the underbody.
Squeak From the Front
of the Vehicle in Cold
Weather
Poor front stabilizer shaft
insulators taping.
While the vehicle is cold, perform a test drive
and achieve full front suspension travel by
driving through a dip in the road.

Remove the insulators and wrap teflon tape
around the stabilizer shaft. Reinstall the
insulators over the tape.
Thump From Rear of
Vehicle on Bumps
Improperly secured spare tire in
the rear compartment.
Open the rear compartment and perform a
visual inspection of the spare tire and the
tools.

Tightly secure the spare tire and all tools.

Perform a road test to verify that the noise is
eliminated.
Glass Knock Coming
From the Rear of the
Vehicle When Driving
Over Bumps
An out-of-adjustment hatchback
latch.
Test drive the vehicle in order to verify this
condition.

Loosen the latch nuts and adjust the latch
downward.
Rattle Coming From
Door
The door lock solenoid is loose.
Remove the door trim panel and check if the
solenoid is loose.

Tighten the solenoid bolts.

Rattling electrical connectors
inside the door trim panel.
Tap on the trim panel and listen for a rattle.

Remove the trim panel and wrap foam
padding around the connectors as required.
Squeak When
Operating Doors
A lack of lubrication of the door
hinge pins.
Operate the doors and listen for squeaks.

Lubricate the door hinge pins with light oil
and coat with lithium grease.

A lack of lubrication of the door
hold open link arm.
Lubricate the door hold open link arm with
light oil and coat with lithium grease.