2003 DAEWOO MATIZ wipers

WIPERS/WASHER SYSTEMS 9D–5
DAEWOO M-150 BL2
WINDSHIELD/REAR WINDOW WIPER AND WASHER SYSTEM(Cont’d)
ConditionProbable CauseCorrection
Rear Wiper Does Not Work
The open or a short in the power
supply circuit to the fuse F9.
Repair or Replace the open or a
short in the power supply circuit to
the fuse F8.

Fuse F9 is blown.
Replace the fuse F9.

The circuit between the fuse F9
and the wiper/washer switch is the
open circuit or a short circuit.
Repair or Replace the wiring
harness.

Faulty wiper/washer switch.
Replace the wiper/washer switch.

The circuit between the
wiper/washer switch and the rear
window wiper motor is the open
circuit or a short circuit.
Repair or Replace the wiring
harness.

The circuit between the fuse F9
and the rear window wiper motor
is the open circuit or a short
circuit.
Repair or Replace the wiring
harness.

Faulty rear window wiper motor.
Replace the rear window wiper
motor.

Poor ground G403.
Repair or Replace the wiring
harness.
Rear Window Washer Does Not
Work, Rear Window Wiper OK
The open or a short in the power
supply circuit to the fuse F9.
Repair or Replace the open or a
short in the power supply circuit to
the fuse F9.

Fuse F9 is blown.
Replace the fuse F9.

The circuit between the fuse F9
and wiper/washer switch is the
open circuit or a short circuit.
Repair or Replace the wiring
harness.

Faulty wiper/washer switch.
Replace the wiper/washer switch.

The circuit between the
wiper/washer switch and the
windshield washer pump is the
open circuit or a short circuit.
Repair or replace the wiring
harness.

Faulty windshield washer pump.
Replace the windshield washer
pump.

Poor ground G102.
Repair or Replace the wiring
harness.

9D –6 WIPERS/WASHER SYSTEMS
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON–VEHICLE SERVICE
D109D519
WINDSHIELD WIPER ARM
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Remove the wiper arm.

Remove the cap (1).

Remove the nut (2).

Remove the wiper arm (3).
D109D520
Installation Procedure
1. Install the wiper arm with the nut.
2. Install the cap.
D109D521
REAR WINDOW WIPER ARM
Removal Procedure
1. Remove the washer nozzle from the wiper arm. Refer
to “Rear Washer Nozzle” in this section.
2. Remove the wiper blade. Refer to “Windshield Wiper
Blade” in this section.
3. Remove the wiper arm.

Remove the cap (1).

Remove the nut (2).

Remove the wiper arm (3).

WIPERS/WASHER SYSTEMS 9D–7
DAEWOO M-150 BL2
D109D522
Installation Procedure
1. Install the rear wiper arm with the nut.
2. Install the cap.
3. Install the wiper blade. Refer to “Windshield Wiper
Blade” in this section.
4. Install the washer nozzle to the wiper arm. Refer to
“Rear Washer Nozzle” in this section.
D109D523
WINDSHIELD WIPER MOTOR
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the windshield wiper arm. Refer to “Wind-
shield Wiper Arm” in this section.
3. Remove the cowl vent grille. Refer to Section 9R,
Body Front End.
4. Separate the wiper motor from the wiper linkage.

Remove the wiper linkage ball from the wiper linka-
ge (1).
D109D524
5. Remove the wiper motor from the engine room.

Disconnect the electrical connector (1).

Remove the bolts (2).

Remove the wiper motor assembly (3).
D109D525
Caution: Because the wiper motor link plate is
fixed, do not separate the wiper motor from the
bracket.

9D –8 WIPERS/WASHER SYSTEMS
DAEWOO M-150 BL2
D109D526
Installation Procedure
1. Install the wiper motor to the engine room with the
bolts.
a. Wiper motor assembly bolt.
2. Connect the electrical connector.
D109D527
3. Install the wiper linkage to the wiper motor linkage
ball.
b. Wiper linkage ball.
D109D528
4. Install the cowl vent grille. Refer to Section 9R, Body
Front End.
5. Install the windshield wiper arm. Refer to “Windshield
Wiper Arm” in this section.
6. Connect the negative battery cable.
D19D529A
REAR WINDOW WIPER MOTOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the wiper arm from the tailgate. Refer to
“Windshield Wiper Arm” in this section.
3. Remove the tailgate inside trim. Refer to Section 9G,
Interior Trim.
4. Remove the rear wiper motor assembly.

Disconnect the electrical connector (1).

Remove the screws (2).

Remove the rear wiper motor assembly (3).

WIPERS/WASHER SYSTEMS 9D–9
DAEWOO M-150 BL2
D19D530A
Caution: Because the wiper motor link plate is
fixed, do not separate the wiper motor from the
bracket.
D19D531A
Installation Procedure
1. Install the wiper motor assembly to the tailgate with
the screws.
2. Connect the electrical connector.
3. Install the tailgate inside trim. Refer to Section 9G, In-
terior Trim.
4. Install the wiper arm. Refer to “Windshield Wiper
Arm” in this section.
5. Connect the negative battery cable.
D109D523
WINDSHIELD WIPER LINKAGE
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Remove the windshield wiper arms. Refer to ”Wind-
shield Wiper Arm” in this section.
2. Remove the cowl vent grille. Refer to Section 9R,
Body Front End.
3. Separate the wiper linkage from the wiper motor.

Separate the wiper linkage from the wiper motor
linkage ball (1).
D109D532
4. Remove the wiper linkage.

Remove the wiper linkage nuts (1).

Remove the wiper linkage (2).

9D –10 WIPERS/WASHER SYSTEMS
DAEWOO M-150 BL2
D19D533A
1.5–2.0 Nm
Installation Procedure
1. Install the wiper linkage with the wiper linkage nuts.
Tighten
Tighten the wiper linkage nuts to 1.5–2.0 Nm (13–18
lb-in).
a. Wiper linkage nut.
2. Install the wiper motor linkage ball.
3. Install the cowl vent grille. Refer to Section 9R, Body
Front End.
4. Install the windshield wiper arms. Refer to ”Wind-
shield Wiper Arm” in this section.
D109D534
WINDSHIELD WIPER BLADE
Removal Procedure
1. Pull the wiper blade off the arm by pushing the wiper
blade retaining clip (1).
D109D535
Installation Procedure
1. Install the wiper blade to the arm.
D109D536
WASHER RESERVOIR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the washer reservoir inlet.

Remove the bolt (1).

Remove the washer reservoir inlet (2).

WIPERS/WASHER SYSTEMS 9D–11
DAEWOO M-150 BL2
D19D537A
3. Raise and suitably support the vehicle.
4. Remove the front RH wheelhouse splash shield.

Remove the screws (1).

Remove the clips (2).

Remove the wheelhouse splash shield (3).
D109D538
5. Remove the washer reservoir assembly.

Drain the washer fluid.

Disconnect the washer hose connector (1).

Disconnect the washer pump electrical connector
(2).

Remove the bolts (3).

Remove the washer reservoir assembly (4).
D109D539
Installation Procedure
1. Install the washer reservoir assembly with the bolts.
2. Connect the washer pump electrical connector.
3. Connect the washer hose connector.
4. Install the front RH wheelhouse splash shield with the
screws and the clips.
5. Lower the vehicle.
6. Install the washer reservoir with the bolt.
7. Connect the negative battery cable.
D109D540
WASHER PUMP
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the washer reservoir assembly. Refer to
“Washer Reservoir” in this section.
3. Drain the washer fluid.
4. Remove the wiper motor from the washer reservoir
assembly.
a. Washer pump.

9D –12 WIPERS/WASHER SYSTEMS
DAEWOO M-150 BL2
D109D539
Installation Procedure
1. Install the wiper motor to the washer reservoir assem-
bly.
2. Install the washer reservoir assembly.
Refer to “Washer Reservoir” in this section.
3. Connect the negative battery cable.
4. Fill the washer reservoir.
D109D541
WINDSHIELD WASHER NOZZLE
Removal Procedure
1. Remove the cowl vent grille. Refer to Section 9R,
Body Front End.
2. Remove the washer nozzle from the cowl vent grille.

Disconnect the washer nozzle hose (1).

Remove the washer nozzle (2).
D109D542
Installation Procedure
1. Install the washer nozzle to the cowl vent grille.
2. Install the washer nozzle hose to the washer nozzle.
3. Install the cowl vent grille. Refer toSec-
tion 9R, Body Front End.
D109D543
REAR WINDOW WASHER NOZZLE
Removal Procedure
1. Remove the washer nozzle from the wiper arm.

Disconnect the washer nozzle hose (1).

Remove the washer nozzle (2).