2002 Hyundai Grandeur child seat

FEATURES OF YOUR HYUNDAI 1- 25
B235G01Y-GAT Installation on Center Rear Seats
B235G01Y-1
Use the center seat belt for the rear to secure the child restraint system asillustrated. After installation of thechild restraint system, rock the child seat back and forth, and side to side to ensure that it is properly secured bythe seat belt.If the child seat moves, readjust thelength of the seat belt. Then, ifequipped, insert the child restraint tether strap hook into the child re- straint hook holder and tighten to se-cure the seat. Always refer to the childrestraint system manufacturer's rec-ommendation before installing the childrestraint system in your vehicle.
On outboard rear seats
B230G01A-GAT Installation on the Outboard Rear Seats To install a child restraint system on the outboard rear seats, extend theshoulder/lap belt from its retractor.Buckle the seat belt and allow the seatbelt to take up any slack. Make sure that the lap portion of the belt is tight around the child restraint system andthe shoulder portion of the belt is posi-tioned so that it cannot interfere withthe child's head or neck. After installa-tion of the child restraint system, try to move it in all directions to be sure the child restraint system is securely in-stalled. B230G01L
If you need to tighten the belt, pullmore webbing toward the retractor.When you unbuckle the seat belt andallow it to retract, the retractor willautomatically revert back to its normal seated passenger emergency locking usage condition. NOTE:
o Before installing the child re-
straint system, read the instruc- tions supplied by the child re-straint system manufacturer.
o If the seat belt does not operate
as described, have the systemchecked immediately by yourauthorized Hyundai dealer.
WARNING:
Do not install any child restraint system in the front passenger seat. Should an accident occur and causethe passenger's side airbag to de-ploy, it could severely injure or killan infant or child seated in an infantor child seat. Therefore, only use a child restraint system in the rear seat of your vehicle.
!

1- 26 FEATURES OF YOUR HYUNDAI
Tether anchor cover
B230C03Y
Child restraint hook holder
REAR SEAT PACKAGE TRAY
B230C02A-E
Front of Vehicle Child restraint hook holders
Tether strap hook
Spacer (2mm), Child Restraint Hook Holder
B230B01TB
Attachment Bolt (5/16"-30 mm) Washer, Conical Spring Holder, Child Restraint Hook
B230B01E-GAT Using a Child Restraint System With "Tether Anchorage" Sys- tem For small children and babies, the use of a child seat or infant seat is stronglyrecommended. This child seat or in-fant seat should be of appropriate sizefor the child and should be installed in accordance with the manufacturer's instructions. It is further recommendedthat the seat be placed in the vehicle'srear seat since this can make an im-portant contribution to safety. Yourvehicle is provided with three child restraint hook holders for installing the child seat or infant seat. B230C03A-GAT Securing a Child Restraint Sys- tem With "Tether Anchorage" System Three child restraint hook holders are located on the rear seat package tray.
2. Route the child restraint seat strapover the seatback.For vehicles with adjustable head-rests, route the tether strap underthe headrest and between the head-rest posts, otherwise route the tetherstrap over the top of the seatback.
1. Open the tether anchor cover on the
rear seat package tray.
Retainer Washer

FEATURES OF YOUR HYUNDAI 1- 27
ISOFIX Anchor
B230C03E-GAT Securing a Child Restraint Sys- tem With "ISOFIX" System and"Tether Anchorage" System B230D02L
ISOFIX Anchor Position Indicator
On each side of the rear seat, between the cushion and backrest, are locateda pair of ISOFIX anchorage pointstogether with a top tether mounting onthe luggage compartment. During the installing, the seat has to be engaged at the anchorage-points in a way youcan hear it clicking (check by pulling!)and has to be fixed with the TopTether-belt on the belonging point in the lug-gage-compartment. The installing and the use of a child-seat has to be done according to the installing-manual,which is added to the ISOFIX-seat.
An ISOFIX-seat can only be installed ifit has vehicle-specific approval in ac-cordance with the requirements ofECE-R44. For your Hyundai, theHyundai ISOFIX GR 1 / Hyundai Duo/ Römer ISOFIX GR1 and the Römer Duo ISOFIX / Britax Duo ISOFIX isapproved according to the requirementECE-R44. This seat has been testedextensively by Hyundai and is recom-mended for your Hyundai. NOTE: At present, this seat is the only one complying with that provision. Incase that other manufacturers willfurnish proof of a respective certifi-cation, Hyundai is going to evalu-ate this seat carefully and will give a recommendation provided that seat complies to the law. Please askyour Hyundai dealer in this respect.
3. Connect the tether strap hook to the
child restraint hook holder andtighten to secure the seat.
ISOFIX is a standardised method offitting child seats that eliminates theneed to use the standard adult seatbelt to secure the seat in the vehicle. This enables a much more secure and positive location with the added benefitof easier and quicker installation.
B230D01L

1- 28 FEATURES OF YOUR HYUNDAI
!WARNING:
o Do not install a child restraint seat at the center of the rear seat using the vehicle's ISOFIX an-chors. The ISOFIX anchors areonly provided for the left andright outboard rear seating posi-tions. Do not misuse the ISOFIX anchors by attempting to attach a child restraint seat in the middleof the rear seat to the ISOFIXanchors. In a crash, the childrestraint seat ISOFIX attachmentsmay not be strong enough to secure the child restraint seat properly in the center of the rearseat and may break, causing se-rious injury or death.
NOTE: An ISOFIX-child-seat can only be installed if the seat has a vehicle-specific approval according to ECE-R44. Before using the ISOFIX-child-seat, which was bought for an othercar, ask your Hyundai-dealer whether this seat-type is approved and recommended for yourHyundai. To secure the child restraint seat
B230E01L
1. To engage the child restraint seat to the ISOFIX anchor, insert the child restraint seat latch into the ISOFIXanchor. Listen for the audible "click"sound. 2. Connect the tether strap hook to the
child restraint hook holder andtighten to secure the seat. Refer to"Securing a Child Restraint SystemWith Tether Anchorage System" on page 1-26. o Do not mount more than one
child restraint to a child restraint lower anchorage point. The im-proper increased load may causethe anchorage points or tetheranchor to break, causing seriousinjury or death.
o Attach the ISOFIX or ISOFIX-com-
patible child restraint seat onlyto the appropriate locationsshown in the illustration.
o Always follow the installation and
use instructions provided by the manufacturer of the child re- straint.

FEATURES OF YOUR HYUNDAI 1- 29
HXG229
B180B01HP-GAT Pre-tensioner Seat Belt Your Hyundai vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose ofthe pre-tensioner is to make sure that the seat belts fit tightly against the occupant's body in certain frontal col-lisions.The pre-tensioner seat belts can beactivated alone or, where the frontalcollision is severe enough, together with the airbags. The pre-tensioner seat belt operatesin a similar way as an Emergency Locking Retractor (ELR) type of seatbelt. When the vehicle stops suddenly,or if the occupant tries to lean forwardtoo quickly, the seat belt retractor willlock into position. However, in certain frontal collisions, the pre-tensioner will activate and pull the seat belt intotighter contact against the occupant'sbody.
Rear
Center
Age Group Seating Position
UU
F
XUU F
X U, L1 UF XU FUF
Rear
Outboard
Front
Passenger
0 : Up to 10 kg (0 ~ 9 months)0+ : Up to 13 kg(0 ~ 2 years)I : 9kg to 18kg(9 months ~ 4years)II & III : 15kg to36kg (4 ~ 12 years) X
B230H01L-GAT Child Seat Restraint Suitability For Seat Position Use child safety seats that have been officially approved and are appropriatefor your children. When using the childsafety seats, refer to the following table.
U :Suitable for "universal" category
restraints approved for use in this mass group
UF :Suitable for forward-facing "uni- versal" category restraints ap- proved for use in this mass group L1: Suitable for "Römer ISOFIX GR1"
approved for use in this mass group
(Approval No: E1 R44-03301133)
X : Seat position not suitable for chil- dren in this mass group

FEATURES OF YOUR HYUNDAI 1- 33
B240B02A-GAT SRS Components and Functions
B240B01L
The SRS consists of the following com- ponents:
- Driver's Airbag Module
- Passenger's Airbag Module
- SRS Service Reminder Indicator (SRI)
- SRS Control Module (SRSCM) The SRSCM continually monitors all elements while the ignition is "ON" todetermine if a frontal or near-frontalimpact is severe enough to requireairbag deployment.
o For maximum safety protection
in all types of crashes, all occu-pants including the driver shouldalways wear their seat beltswhether or not an airbag is alsoprovided at their seating posi-tion to minimize the risk of se- vere injury or death in the event of a crash. Do not sit or leanunnecessarily close to the airbagwhile the vehicle is in motion.
o The SRS airbag system must de- ploy very rapidly to provide pro- tection in a crash. If an occupant is out of position because of notwearing a seat belt, the airbagmay forcefully contact the occu-pant causing serious or fatal in-juries.o Do not tamper with or discon-nect SRS wiring, or other com- ponents of the SRS system. Do-ing so could result in injury, dueto accidental firing of the airbagsor by rendering the SRS inopera-tive.
o Do not install a child restraint
system in the front passengerseat position. A child restraintsystem must never be placed inthe front seat. The infant or childcould be severely injured or killed by an airbag deployment in case of an accident.
o Do not allow children to ride in
the front passenger seat. If olderchildren (teenagers and older)must ride in the front seat, make sure they are always properly belted and that the seat is movedback as far as possible.

1- 36 FEATURES OF YOUR HYUNDAI
WARNING:
o The side impact airbag is supple- mental to the driver's and the passenger's three point seat beltsystems and is not a substitutefor them. Therefore your seatbelts must be worn at all timeswhile the vehicle is in motion. The airbags deploy only in cer- tain side impact conditions se-vere enough to cause significantinjury to the vehicle occupants. HXGS261
Side airbag sensor
B990B04Y-GAT Side Impact Airbag (If installed)
Your Hyundai is equipped with a side airbag in each front seat. The purposeof the airbag is to provide the vehicle'sdriver and/or the front passenger with additional protection than that offered by the seatbelt alone. The side impactairbags are designed to deploy onlyduring certain side impact collisions,depending on the crash severity, angle,speed and point of impact. The air bags are not designed to deploy in all side impact situations. B990B02Y
!
WARNING:
The Passenger Presence Detection system is not intended to preventairbag deployment while a child isin the front passenger's seat. It is intended only as a means to reduce unnecessary collision damage re-pair expense by preventing airbagand seat belt pretensioner deploy-ment when the right front passen-ger seat is unoccupied. Deployment is still possible if only a few pounds are placed upon the seat. There-fore, children must not be trans-ported in the front seat. All childrenmust be seated in the rear seat andproperly restrained with the vehicle's restraint system or a child restraint system appropriate for thechild's size and weight.!

1- 38 FEATURES OF YOUR HYUNDAI
o Modification to SRS components
or wiring, including the addition of any kind of badges to the pad covers or modifications to the body structure, can adverselyaffect SRS performance and leadto possible injury.
o For cleaning the airbag pad cov- ers, use only a soft, dry cloth or one which has been moistened with plain water. Solvents orcleaners could adversely affectthe airbag covers and properdeployment of the system.
o No objects should be placed over
or near the airbag modules onthe steering wheel, instrumentpanel, and the front passenger'spanel above the glove box, be-cause any such object could cause harm if the vehicle is in a crash severe enough to causethe airbags to inflate.
o If the airbags inflate, they must be replaced by an authorizedHyundai dealer. o Do not tamper with or discon-
nect SRS wiring, or other com-ponents of the SRS system. Do- ing so could result in injury, due to accidental firing of the airbagsor by rendering the SRS inopera-tive.
o If components of the airbag sys- tem must be discarded, or if the vehicle must be scrapped, cer- tain safety precautions must beobserved. Your Hyundai dealerknows these precautions and cangive you the necessary informa- tion. Failure to follow these pre- cautions and procedures couldincrease the risk of personal in-jury.
o If you sell your vehicle, make certain that this manual is trans- ferred to the new owner.
o If your car was flooded and has
soaked carpeting or water on flooring, you shouldn't try to startengine; have the car towed toauthorized Hyundai dealer.
B240C02L
WARNING:
o Extreme Hazard! Do not use a rearward facing child restraint on a seat protected by an airbag in front of it!
o Do not install a child restraint system in the front passenger seat position.A child restraint system mustnever be placed in the front seat. The infant or child could be se- verely injured by an airbag de-ployment in case of an accident.
!