2001 TOYOTA SEQUOIA washer fluid

I01279
Warning Light
Ignition
Switch
Battery
I19428
21OFF
ON
N01212
BE1217
Warning Light
Ignition
Switch
Battery
± BODY ELECTRICALCOMBINATION METER
BE±57
3461 Author: Date:
2005 SEQUOIA (RM1146U)
7. INSPECT BRAKE WARNING LIGHT OPERATION
(a) Disconnect the connector from the brake fluid warning
switch.
(b) Release the parking brake pedal.
(c) Connect the terminals on the harness side of the level
warning switch connector.
(d) Start the engine and check that the warning light comes
on.
If the warning light does not come on, test the bulb or wire har-
ness.
8. INSPECT BRAKE FLUID LEVEL WARNING SWITCH
CONTINUITY
(a) Remove the reservoir tank cap and strainer.
(b) Disconnect the connector.
(c) Check that no continuity exists between the terminals with
the switch OFF (float up).
(d) Use siphon, etc. to drain fluid out of the reservoir tank.
(e) Check that continuity exists between the terminals with
the switch ON (float down).
(f) Pour the fluid back in the reservoir tank.
If continuity is not as specified, replace the switch.
9. INSPECT PARKING BRAKE SWITCH CONTINUITY
(a) Check that continuity exists between the terminal and
switch body with the switch ON (switch pin released).
(b) Check that no continuity exists between the terminal and
switch body with the switch OFF (switch pin pushed in).
If operation is not as specified, replace the switch or inspect
ground point.
10. INSPECT WASHER LEVEL WARNING LIGHT OPERA-
TION
(a) Disconnect the connectors from the combination meter.
(b) Connect the negative (±) lead from the battery to terminal
16.
(c) Turn the ignition switch ON and check that the warning
light comes on.
If the warning light does not come on, test the bulb.

H16692
H16693H17630
2 jet type:
3 jet type:AHI
J
BAC
DE DF
FDEEDF
JJ
HI
B G
G
G
BO460±01
BO±36
± BODYFRONT WIPER AND WASHER
3589 Author: Date:
2005 SEQUOIA (RM1146U)
INSPECTION
INSPECT WASHER NOZZLE
While operating the washer, check whether the point where the
washer fluid hits the windshield and the surge area are within
the range indicated by hatched line.
A: Approx. 50 mm (1.97 in)
B: Approx. 40 mm (1.57 in)
C: Approx. 10 mm (0.39 in)
D: Approx. 150 mm (5.91 in)
E: Approx. 110 mm (4.33 in)
F: Approx. 180 mm (7.09 in)
G: Approx. 60 mm (2.36 in)
H: Approx. 310 mm (12.20 in)
I: Approx. 298 mm (11.69 in)
J: Approx. 455 mm (17.91 in)

BO461±01
BE3367
2.0 ± 2.5 mm
(0.079 ± 0.098 in.)
0.7 ± 0.75 mm
(0.028 ± 0.0295 in.)
± BODYFRONT WIPER AND WASHER
BO±37
3590 Author: Date:
2005 SEQUOIA (RM1146U)
ADJUSTMENT
ADJUST WASHER NOZZLE
Using a tool like the one shown in the illustration, change the
direction of the nozzle hole to adjust the point where washer
fluid hits the windshield.

H16695
BA
C
D
BO465±01
± BODYREAR WIPER AND WASHER
BO±43
3596 Author: Date:
2005 SEQUOIA (RM1146U)
INSPECTION
INSPECT REAR WASHER NOZZLE
While operating the washer, check it the point where the washer
fluid hits the back door glass is within the range indicated by the
hatched line.
A: Approx. 156 mm (6.14 in)
B: Approx. 180 mm (7.09 in)
C: Approx. 33 mm (1.30 in)
D: Approx. 292 mm (11.50 in)

BO466±01
BE3367
2.0 ± 2.5 mm
(0.079 ± 0.098 in.)
0.7 ± 0.75 mm
(0.028 ± 0.0295 in.) BO±44
± BODYREAR WIPER AND WASHER
3597 Author: Date:
2005 SEQUOIA (RM1146U)
ADJUSTMENT
ADJUST WASHER NOZZLE
Using a tool like the one shown in the illustration, change the
direction of the nozzle hole to adjust the point where washer
fluid hits the back door glass.

05_SEQUOIA_U (L/O 0408)
10
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
or
Driver 's seat belt reminder light*
1
Discharge warning light*
1
Low fuel level warning light*
1
Brake system warning light*
1
Malfunction indicator lamp*
1
Anti±lock brake system warning light*
1
Automatic transmission fluid temperature
warning light (four±wheel drive models)*
1
SRS warning light*
1
Open door warning light*
1
Low windshield washer fluid level warning
light*
1
Front passenger 's seat belt reminder light*
1
Vehicle stability control system/traction control
system (two±wheel drive models) or active
traction control system (four±wheel drive
models) warning light
*
1
Low tire pressure warning light*
1
Engine oil replacement reminder light*
1
Indicator symbols on the instrument panel

05_SEQUOIA_U (L/O 0408)
153
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
When all the doors are unlocked using
either the key or the wireless remote con-
trol transmitter simultaneously, the ignition
switch light will come on and remain on
for about 15 seconds before fading out.
To prevent the battery being discharged,
the light will automatically turn off when
the key is removed and the door is left
opened for 20 minutes or more.
The following adjustments can be made in
this system. For details, contact your
Toyota dealer.

Cancelling the door key or wireless re-
mote control transmitter linked opera-
tion

Changing the timing for the light turn-
ing off
To turn on the windshield wipers, move
the lever to the desired setting.
The key must be in the ªONº position.
Lever position
Speed setting
Position 1Intermittent
Position 2Slow
Position 3Fast
The ªINT TIMEº band lets you adjust the
wiping time interval when the wiper lever
is in the intermittent position (position 1).
Twist the band upward to increase the
time between sweeps, and downward to
decrease it.To squirt washer fluid, pull the lever
toward you.
If the windshield wipers are off, they will
operate a couple of times after the washer
squirts.
For instructions on adding washer fluid,
see ªAdding washer fluidº on page 444 in
Section 7±3.
In freezing weather, warm the windshield
with the defroster before using the washer.
This will help prevent the washer fluid
from freezing on your windshield, which
can block your vision.
NOTICE
Do not operate the wipers if the wind-
shield is dry. It may scratch the
glass.
Windshield wipers and washer

05_SEQUOIA_U (L/O 0408)
154
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
To turn on the back window wiper, twist
the lever knob upward.
The key must be in the ªONº position.
Lever position
Speed setting
Position 1Intermittent
Position 2Normal
To squirt washer fluid on the back window,
twist the knob upward or downward as far
as it will go (position 3 or 4).
The wiper is activated after the washer
squirts fluid if you twist the knob upward.
But, the washer only squirts fluid if you
twist the knob downward.The knob automatically returns from these
positions after you release it.
For instructions on adding washer fluid,
see ªAdding washer fluidº on page 444 in
Section 7±3.
If the back window is not fully closed, the
back window wiper and washer will not
work. Make sure the back window is fully
closed when using the back window wiper
and washer.
NOTICE
Do not operate the back window wip-
er if the back window is dry. It may
scratch the glass.To defog or defrost the back window,
push the switch with the back window
closed.
The key must be in the ªONº position.
The thin heater wires on the inside of the
back window will quickly clear the surface.
An indicator light will illuminate to indicate
the defogger is operating.
On some models, heater panels in the
outside rear view mirrors will also quickly
clear the surfaces.
Push the switch once again to turn the
defogger off.
The system will automatically shut off af-
ter the defoggers have operated about 15
minutes.
Back window wiper and
washerBack window and outside rear
view mirror defoggers