2001 TOYOTA SEQUOIA airbag off

DIDGK±01
A08841
Hand±held Tester
DLC3
DI±1128
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
1322 Author: Date:
2005 SEQUOIA (RM1146U)
INITIALIZATION
ZERO POINT CALIBRATION AND SENSITIVITY CHECK
NOTICE:
Make sure that the seat is not occupied before performing
the operation.
HINT:
Perform the zero point calibration and sensitivity check if any of
the following conditions occur.

The occupant classification ECU is replaced.

Accessories (seatback tray and seat cover, etc.) are
installed.

The passenger seat is removed from the vehicle.

The passenger airbag ON/OFF indicator (ºOFFº) comes
on when the passenger seat is not occupied.

The vehicle is brought to the workshop for repair due to
an accident or a collision.
Zero point calibration and sensitivity check procedures.
HINT:
Make sure that zero point calibration has finished normally, and
then perform the sensitivity check.
(1) Adjust the seat position according to the table be-
low.
Adjustment ComponentPosition
Slide DirectionRearmost position
Reclining AngleUpright position
Headrest HeightLowest position
Lifter HeightLowest position
(2) Connect the hand±held tester to the DLC3.
(3) Turn the ignition switch to the ON position.
(4) Perform the zero point calibration by following the
prompts on the tester screen shown in 2 pages lat-
er.
HINT:
Refer to the hand±held tester operator's manual for further de-
tails.
OK:
The ºCOMPLETEº is displayed.

DI6P2±15
DI±1132
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
1326 Author: Date:
2005 SEQUOIA (RM1146U)
PROBLEM SYMPTOMS TABLE
Proceed with troubleshooting of each circuit in the table below.
SymptomSuspected AreaSee page

The front passenger seat condition differs from the indication by
the passenger airbag ON/OFF indicator (DTC is not output).
Trouble in indication of Passenger airbag ON/OFF indica-
torDI±1485

With the ignition switch is in ON position, the SRS warning light
sometimes comes on after approximately 6 seconds.
SRS warning light circuit (Always comes on, when DTC is
not output)DI±1491

The SRS warning light always comes on even when DTC is not
output.
SRS warning light circuit (Always comes on, when DTC is
not output)DI±1491

With the ignition switch is in the ON position, the SRS warning
light does not come on.
SRS warning light circuit (Does not come on, when igni-
tion switch is turned to the ON position)DI±1496

Although an SRS warning light operates normally, DTC or a
normal system code is not display.
TC terminal circuitDI±1498

Although terminals TC and CG of DLC3 are not connected, DTC
or a normal system code is display.
TC terminal circuitDI±1498

DI±1134
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
1328 Author: Date:
2005 SEQUOIA (RM1146U)A20±16
SILDLC3
A20±17P±ABIntegration control and panel (Passenger airbag ON/OFF indi-
cator)
A20±18GSWBody ECU
A20±19 (*1)RMSWRSCA cutoff switch
A20±20 (*1)RMILCombination meter (RSCA OFF indicator)
A20±21IG2IGN1 Fuse (Power source)
A20±22GSW2ECM
A20±23PAONIntegration control and panel (Passenger airbag ON/OFF indi-
cator)
A20±25E1Ground
A20±26E2Ground
A20±27±SRFront airbag sensor RH
A20±28±SLFront airbag sensor LH
A20±29+SRFront airbag sensor RH
A20±30+SLFront airbag sensor LH
A21±3PR±Front seat outer belt RH (P/T squib RH)
A21±4PR+Front seat outer belt RH (P/T squib RH)
A21±5 (*1)ICR+Curtain shield airbag assembly RH (Curtain shield airbag RH
squib)
A21±6 (*1)ICR±Curtain shield airbag assembly RH (Curtain shield airbag RH
squib)
A21±7 (*1)SFR±Side airbag assembly RH (Side squib RH)
A21±8 (*1)SFR+Side airbag assembly RH (Side squib RH)
A21±16FSR+Occupant classification ECU
A21±19 (*1)ESCRCurtain shield airbag sensor assembly RH
A21±20 (*1)ESRSide airbag sensor assembly RH
A21±21 (*1)VUCRCurtain shield airbag sensor assembly RH
A21±22 (*1)VUPRSide airbag sensor assembly RH
A21±24FSR±Occupant classification ECU
*1: w/ Side and curtain shield airbag

H23984
6 seconds
Ignition Switch
SRS Warning
Light (*1)
SRS Warning
Light (*2)
*1: SRS airbag system is normal
*2: SRS airbag system has trouble ON
OFF
ON
OFF
ON
OFF
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DI±1139
1333 Author: Date:
2005 SEQUOIA (RM1146U)
3. FUNCTION OF SRS WARNING LIGHT
(a) Primary check.
Turn the ignition switch to the LOCK position. Wait for at least 2 seconds, then turn the ignition switch
to the ON position. The SRS warning light comes on for approximately 6 seconds and the SRS airbag
system diagnosis (including the seat belt pretensioner and occupant classification system) is per-
formed.
HINT:
If trouble is detected during the primary check, the SRS warning light remains on even after the primary
check period (for approximately 6 seconds) has elapsed.
(b) Constant check.
After the primary check, the airbag sensor assembly constantly monitors the SRS airbag system for
trouble.
HINT:
If trouble is detected during the constant check, the airbag sensor assembly functions as follows:

The SRS warning light comes on.

The SRS warning light goes off, and then comes on. This blinking pattern indicates the source voltage
drop. The SRS warning light goes off 10 seconds after the source voltage returns to normal.

DI±1140
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
1334 Author: Date:
2005 SEQUOIA (RM1146U)
(c) Review.
(1) When the SRS airbag system is normal:
The SRS warning light comes on only during the primary check period (for approximately 6 se-
conds after the ignition switch is turned to the ON position).
(2) When the SRS airbag system has trouble:

The SRS warning light remains on even after the primary check period has elapsed.

The SRS warning light goes off after the primary check, but comes on again during the
constant check.

The SRS warning light does not come on when turning the ignition switch from the LOCK
to ON position.
HINT:
The airbag sensor assembly keeps the SRS warning light on if the airbag has been deployed.
4. FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR
The passenger airbag ON/OFF indicator function as follows:
(1) Turn the ignition switch to the ON position.
(2) The passenger airbag ON/OFF indicator (ºONº and ºOFFº) comes on for approximately 4 se-
conds, then goes off for approximately 2 seconds.
(3) Approximately 6 seconds after the ignition switch is turned to the ON position, the passenger
airbag ON/OFF indicator will be ON/OFF depending on the conditions listed below.
HINT:
If the front passenger seat condition and the indication by the passenger airbag ON/OFF indicator differ from
those shown in the table below, and the SRS warning light is off, then the DTC is not output. If this occurs,
perform troubleshooting of ºTrouble in indication of Passenger airbag ON/OFF indicatorº (see page
DI±1485).
ConditionºONº indicatorºOFFº indicator
VacantOFFOFF
Adult is seated.ONOFF
Child is seated.OFFON
Child restraint system (CRS) is set.OFFON
Occupant classification system failureOFFON

H22552
Ignition SwitchON
OFF
Passenger Airbag
ON/OFF Indicator
(ºONº)ON
OFF
ON
OFF4 sec.
ON/OFF condition depends on the
front passenger detection results. 2 sec.
4 sec. 2 sec.
Passenger Airbag
ON/OFF Indicator
(ºOFFº)
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DI±1141
1335 Author: Date:
2005 SEQUOIA (RM1146U)
HINT:

The passenger airbag ON/OFF indicator comes on or goes off based on the timing chart below in order
to check the indicator light circuit.

When the occupant classification system has trouble, both the SRS warning light and the passenger
airbag ON/OFF indicator (ºOFFº) comes on. In this case, check the DTCs in the supplemental restraint
system first. Then troubleshoot the occupant classification system if DTC B1650/32 is indicated, and
troubleshoot the passenger airbag ON/OFF indicator if DTC B1660/43 is detected.

H24023
H24021
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
DI±1143
1337 Author: Date:
2005 SEQUOIA (RM1146U)
7. CHECK PASSENGER AIRBAG ON/OFF INDICATOR
(a) Turn the ignition switch to the ON position.
(b) Check that the passenger airbag ON/OFF indicator (ºONº
and ºOFFº) comes on for approximately 4 seconds, then
goes off for approximately 2 seconds.
HINT:
Refer to the table in step 4 regarding the passenger airbag ON/
OFF indicator when the ignition switch is turned to the ON posi-
tion and approximately 6 seconds pass.
8. CHECK RSCA OFF INDICATOR
(a) Check that the RSCA OFF indicator is off when turning
the ignition switch to the ON position.
(b) Check that the RSCA OFF indicator comes on when turn-
ing the RSCA OFF switch on (press the switch for approxi-
mately 2 seconds) with the ignition switch on.
(c) Turn the ignition switch to the LOCK position with the
RSCA OFF indicator is on, and then turn the ignition
switch to the ON position. Check that the RSCA OFF indi-
cator is off.
9. RELEASE METHOD OF ACTIVATION PREVENTION MECHANISM
The activation prevention mechanism is built into the connector for the squib circuit of the SRS.
As explained in the troubleshooting section, insert a piece of paper that is the same thickness as the male
terminal between the terminal and the short spring to release it (Refer to the illustrations on the next 3 pages).
CAUTION:
Never release the activation prevention mechanism on the squib connector even when inspecting
with the squib disconnected.
NOTICE:

Do not release the activation prevention mechanism unless specially directed by the trouble-
shooting procedure.

To prevent the terminal and the short spring from being damaged, always use a piece of paper
that is the same thickness as the male terminal.

H24029
Curtain Shield Airbag
Sensor Assembly RH
(*1)
Side Airbag Sensor
Assembly RH (*1)
Front Airbag
Sensor RH
RSCA OFF Switch
(*1)
Airbag Sensor
Assembly
Front Airbag
Sensor LH
Side Airbag Sensor
Assembly LH (*1)
Curtain Shield AIrbag
Sensor Assembly LH
(*1)Spiral CableTo
Occupant
Classification ECU
Front Seat Outer
Belt RH
(P/T Squib RH)
Side Airbag
Assembly RH
(Side Squib RH) (*1)
Front Passenger
Airbag Assembly
(P Squib)
Integration Control
and Panel
(Passenger Airbag
ON/OFF Indicator)
Combination Meter
(SRS Warning Light/
RSCA OFF Indicator
(*1))
Steering Wheel
Pad (D Squib)
Side Airbag
Assembly LH
(Side Squib LH) (*1)
Curtain Shield Airbag
Assembly LH (Curtain
Shield Airbag LH
Squib) (*1)
Front Seat Outer
Belt LH
(P/T Squib LH)
Seat Position AIrbag
Sensor Assembly/
Front Seat Inner Belt LH
(Buckle Switch LH)Curtain Shield Airbag
Assembly RH
(Curtain Shield Airbag
RH Squib) (*1)
9 13
10 14
11
1512
16 15
2 6
37
4 8
25 29
26 30
27 33
28 34
1721
1822
19 23
2024
3
4
7
89
10
13
14 11
1227
28
29
30 31
32
31
32 DI±1144
± DIAGNOSTICSSUPPLEMENTAL RESTRAINT SYSTEM
1338 Author: Date:
2005 SEQUOIA (RM1146U)