Page 718 of 1897
DI6NR-01
Inspector 's
Name:
Customer 's Name
Date Vehicle
Brought InRegistration DataRegistration No.
Frame No.
Odometer Reading/ /
/ /
Date Problem First Occurred
Frequency Problem Occurs/ /
ContinuousIntermittent ( times a day)
Remains ONDoes not Light Up
DTC Check1st Time
2nd TimeNormal Code
Malfunction Code (Code )
Normal CodeMalfunction Code (Code )
Symptomskm
miles
Check ItemNormal
ABS does not operate.
ABS does not operate efficiently.
Does not Light Up
ABS & BA & VSC Check Sheet
BA does not operate. VSC does not operate. (Wheels spin when starting rapidly.)
ABS Warning Light
Abnormal
Remains ON
Does not Light Up
Remains ONDoes not Light Up
Remains ONDoes not Light Up
Remains ONDoes not Light Up
VSC OFF Indicator
Light Abnormal
SLIP Indicator
Light AbnormalVSC Warning
Light Abnormal
BRAKE Warning
Light Abnormal
Malfunction
Indicator Light
TRAC does not operate.
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
DI-251
407 Author: Date:
2001 AVALON (RM808U)
CUSTOMER PROBLEM ANALYSIS CHECK
Page 720 of 1897
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
DI-259
415 Author: Date:
2001 AVALON (RM808U)C1300 / 62
(DI-305)
Malfunction in ABS & BA & TRAC & VSC ECUABS & BA & TRAC & VSC ECU
Always ON
(DI-319)Malfunction in ABS & BA & TRAC & VSC ECU
Open circuit in ABS warning light circuitCharging system
ABS warning light circuit
*: As the DTC cannot be erased only by replacing parts, do either of the following operations.
(1) Clear DTC (See page DI-252).
(2) At a vehicle speed of 20 km/h (12 mph), drive the vehicle for 30 sec. or more.
DTC chart of VSC system:
DTC No.
(See Page)Detection ItemTrouble Area
C1225 / 25
(DI-273)Open or short circuit in brake actuator solenoid circuit (SMC1
circuit)Brake actuator
SMC1 circuit
C1226 / 26
(DI-273)Open or short circuit in brake actuator solenoid circuit (SMC2
circuit)Brake actuator
SMC2 circuit
C1227 / 27
(DI-273)Open or short circuit in brake actuator solenoid circuit (SRC1
circuit)Brake actuator
SRC1 circuit
C1228 / 28
(DI-273)Open or short circuit in brake actuator solenoid circuit (SRC2
circuit)Brake actuator
SRC2 circuit
C1301 / 42*Malfunction in communication with the translate ECU
Brake fluid level warning switch circuit
Translate ECU
Translate ECU circuit
ECM
ECM circuit
C0365 / 43
(DI-285)Malfunction in deceleration sensor (combined in yaw rate sen-
sor)Deceleration sensor
Deceleration sensor circuit
C1202 / 44
(DI-290)Brake fluid level low
Open circuit in brake fluid level warning switch circuitBrake fluid level
Brake fluid level warning switch
Brake fluid level warning switch circuit
C1350 / 51
(DI-306)Pump motor is locked
Open circuit in pump motor groundBrake actuator pump motor
Brake actuator pump motor circuit
C1351 / 52
(DI-308)VSC pump motor is locked
Open or short circuit in VSC pump motor circuitPrecharge pump motor
Precharge pump motor circuit
C1246 / 53
(DI-300)Malfunction in master cylinder pressure sensorMaster cylinder pressure sensor
Master cylinder pressure sensor circuit
C1208 / 54
(DI-292)Malfunction in steering angle sensorSteering angle sensor
Steering angle sensor circuit
C0371 / 55
(DI-287)Malfunction in yaw rate sensor circuitYaw rate sensor
Yaw rate sensor circuit
Always ON
(DI-322)Malfunction in ABS & BA & TRAC & VSC ECU
Open circuit in VSC warning light circuitCharging system
VSC warning light circuit
*: Troubleshoot according to the DTC chart of the translate ECU.
Page 721 of 1897
DI-260
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
416 Author: Date:
2001 AVALON (RM808U)
DTC chart of translate ECU(output NG code DTC of VSC system C1301/42 only):
DTC No.
(See Page)Detection ItemTrouble Area
Normal code*
(DI-317)Malfunction in ECM control system
ECM circuit
ECM
Brake fluid level
Brake fluid level warning switch circuit
Steering angle sensor
ABS & BA & TRAC & VSC ECU
42
(DI-31 1)Malfunction in communication with the ABS & BA & TRAC &
VSC ECUVSC+ or VSC- circuit
Translate ECU
ABS & BA & TRAC & VSC ECU
44
(DI-313)Open or short circuit in NEO circuit
NEO circuit
ECM
Translate ECU
53
(DI-315)Malfunction in communication with the ECM
TRC+ or TRC- circuit
ENG+ or ENG- circuit
ECM
Translate ECU
Non code
(DI-318)Malfunction in translate ECU
Tc terminal circuit
BRAKE warning light circuit
Translate ECU
*: Translate ECU is normal.
HINT:
The BRAKE warning light does not turn on due to an error in VSC.
If it is on, check that the parking brake pedal is released, the brake fluid level is normal and no malfunction
is identified in the fluid level warning switch system.
Page 722 of 1897
DI6NQ-01
Vehicle Brought to Workshop
Customer Problem Analysis
P. DI-251
Check and Clear DTC (Precheck)
P. DI-252Items inside
are titles of pages in this manual,
with the page number in the bottom portion. See
the pages for detailed explanations.
Problem Symptom ConfirmationSymptom Simulation
P. IN-20
Symptom
does not occur
Symptom
occurs
DTC Check
P. DI-252
Sensor CheckCircuit Inspection
P. DI-267 - DI-344
DTC Chart
P. DI-258 Malfunction codeProblem Symptoms Table
P. DI-266
Check for Fluid Leakage
P. DI-346
Identification of Problem
Normal code
Repair
Confirmation Test
End
1
2
3
4
5
67
89
10
11
Fail safe function:
When a failure occurs in the ABS & BA & TRAC & VSC system, the respective warning light (ABS, VSC) is lit and
the operation of ABS & BA & TRAC & VSC is prohibited. In addition to this, when the failure which disables the EBD
operation occurs, the brake warning light is lit as well and the EBD operation is prohibited.Step 2, 5, 8, 9, 11:Diagnostic steps permitting the use of the
TOYOTA hand-held tester or TOYOTA
break-out-box. DI-250
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
406 Author: Date:
2001 AVALON (RM808U)
ABS WITH EBD & BA & TRAC & VSC SYSTEM
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshoot in accordance with the procedure on the following pages.
Page 723 of 1897
DI6NU-01
F07883
ABS Warning Light
VSC Warning Light
VSC OFF Indicator Light
SLIP Indicator Light
BRAKE Warning Light
DLC2Rear Speed Sensor
Sensor Rotor
Brake Actuator
ABS & BA & TRAC & VSC ECU
VSC OFF Switch Front Speed Sensor
DLC1
ABS Solenoid RelayABS Motor Relay
Room R/B No. 8 Engine
Precharge PumpMaster Cylinder
Pressure Sensor
Parking Brake Switch
Stop Light Switch
Translate ECU
Front Speed Sensor
Sensor Rotor
Sensor Rotor
Rear Speed Sensor
DLC3
Steering Angle Sensor
Yaw Rate Sensor
(Including Deceleration Sensor)
Active Lamp Relay
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
DI-261
417 Author: Date:
2001 AVALON (RM808U)
PARTS LOCATION
Page 724 of 1897
F07880
DI6NS-01
F02201Tc E
1DLC1
DI-252
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
408 Author: Date:
2001 AVALON (RM808U)
PRE-CHECK
1. DIAGNOSIS SYSTEM
(a) Check the warning lights.
(1) Release the parking brake pedal.
(2) When the ignition switch is turned ON, check that
the ABS warning light, VSC warning light, VSC OFF
indicator light, BRAKE warning light and SLIP indi-
cator light goes on for approx. 3 seconds.
HINT:
When the parking brake is applied or the level of the brake
fluid is low, the BRAKE warning light is lit.
If the indicator check result is not normal, proceed to trou-
bleshooting for the ABS warning light circuit, VSC warn-
ing light circuit, VSC OFF indicator light circuit, BRAKE
warning light circuit or SLIP indicator light circuit.
Trouble AreaSee page
ABS warning light circuitDI-325
VSC warning light circuitDI-327
VSC OFF indicator light circuitDI-336
BRAKE warning light circuitDI-330
SLIP indicator light circuitDI-333
(b) In case of not using TOYOTA hand-held tester:
Check the DTC of ABS & BA & TRAC & VSC ECU.
(1) Using SST, connect terminals Tc and E
1 of DLC1.
SST 09843-18020
(2) Turn the ignition switch ON.
(3) Read the DTC from the ABS warning light and VSC
warning light on the combination meter.
HINT:
If no code appears, inspect the diagnostic circuit, ABS
warning light circuit or VSC waning light circuit.
Trouble AreaSee page
Tc terminal circuitDI-342
ABS warning light circuitDI-325
VSC warning light circuitDI-327
Page 725 of 1897
R01346
Normal Code
0.25 sec.
0.25 sec. 2 sec.
ON
OFF
ON
OFF0.5 sec. 0.5 sec.
Code 11 and 21
4 sec.1.5 sec.
2.5 sec.
Code 11 Code 21
F02201
DLC1 E
1Tc
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
DI-253
409 Author: Date:
2001 AVALON (RM808U)
As an example, the blinking patterns for normal code and
codes 11 and 21 are shown on the left.
(4) Codes are explained in the code table on page
DI-258.
(5) After completing the check, disconnect terminals Tc
and E
1, and turn off the display.
If 2 or more malfunction codes are identified at the same time,
the lowest numbered DTC will be displayed 1st.
(c) In case of not using TOYOTA hand-held tester:
Check the DTC of translate ECU.
(1) Release the parking brake pedal.
(2) Check the brake fluid level.
(3) Using SST, connect terminals Tc and E
1 of DLC1.
SST 09843-18020
(4) Turn the ignition switch ON.
(5) Read the DTC from the BRAKE warning light.
HINT:
If no code appears, inspect the diagnostic circuit, and
BRAKE warning light circuit.
Trouble AreaSee page
Tc terminal circuitDI-342
BRAKE warning light circuitDI-330
When the parking brake is applied or the level of the brake
fluid is low, the BRAKE warning light is lit.
If every sensor is normal, a normal code is output. (A cycle
of 0.25 sec. ON and 0.25 sec. OFF is repeated.)
If 2 or more malfunction codes are identified at the same
time, the lowest numbered code will be displayed 1st.
Page 726 of 1897
Malfunction Code (Example Code 42, 44)
ON
OFF
0.5 sec.0.5 sec.
1.5 sec.2.5 sec.
4 sec.
Repeat
42
44
F07887
TOYOTA Hand-
held Tester
DLC3
BR3890
F07887
TOYOTA Hand-
held Tester
DLC3 DI-254
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
410 Author: Date:
2001 AVALON (RM808U)
(d) In case of using TOYOTA hand-held tester:
Check the DTC.
(1) Hook up the TOYOTA hand- held tester to the
DLC3.
(2) Turn the ignition switch ON.
(3) Read the DTC by following the prompts on the tes-
ter screen.
HINT:
Please refer to the TOYOTA hand-held tester operator's manu-
al for further details.
(e) In case of not using TOYOTA hand-held tester:
Clear the DTC.
(1) Using SST, connect terminals Tc and E
1 of DLC1.
SST 09843-18020
(2) Turn the ignition switch ON.
(3) Clear the DTC stored in ECU by depressing the
brake pedal 8 times or more within 5 seconds.
(4) Check that the warning light shows the normal
code.
(5) Remove the SST from the terminals of DLC1.
SST 09843-18020
HINT:
Cancellation cannot be done by removing the battery cable or
ECU-IG fuse.
(f) In case of using TOYOTA hand-held tester:
Clear the DTC.
(1) Hook up the TOYOTA hand- held tester to the
DLC3.
(2) Turn the ignition switch ON.
(3) Operate the TOYOTA hand-held tester to erase the
codes.
HINT:
Please refer to the TOYOTA hand-held tester operator's manu-
al for further details.
