F09909
Column shift:
Shift Lever
Shift Lever Housing11 (110, 8)
10 (100, 7)
Shift Lock
Control ECU
2.8 (29, 25 in.´lbf)3.4 (35, 30 in.´lbf)
Shift Lock Switch
Corrugate Tube
No. 2 Steering
Column Ring
Spring
RetainerCompression Spring
Main Shaft
Bushing
Main Shaft Collar
7.5 (75, 65 in.´lbf)
Turn Signal Bracket
Steering Column Upper Tube
Tilt Lever Lock ShaftTilt Lever Tension Spring
9.0 (90, 78 in.´lbf)
Spring Guide
Tilt Spring
No. 2 Tilt Steering Bolt
Tapered-head Bolt Key Interlock Solenoid Key Unlock
Warning SwitchColumn Upper
Bracket
Main Shaft Assembly
Transponder Key Coil
Key Cylinder
Lamp Assembly
Ignition Switch
Transponder Key
Amplifier
N´m (kgf´cm, ft´lbf) : Specified torque
Non-reusable part
Molybdenum disulfide lithium base greaseShift Lock
Solenoid Bracket
No. 2 Tilt
Steering Bolt
Column Tube Assembly
w/ Engine immobiliser system:
w/ Engine immobiliser system:
Key Cylinder
- STEERINGTILT STEERING COLUMN
SR-1 1
1474
2001 AVALON (RM808U)
SR0Z6-01
F09913
F09914
SR-18
- STEERINGTILT STEERING COLUMN
1481 Author: Date:
2001 AVALON (RM808U)
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the key cylinder.
(c) Install a new key cylinder.
HINT:
Make sure the ignition key is at the ACC position.
3. INSPECT IGNITION SWITCH (See page BE-16)
4. IF NECESSARY, REPLACE IGNITION SWITCH
(a) Remove the 2 screws and ignition switch.
(b) Install a new ignition switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page BE-16)
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide the key unlock warning switch out of the column up-
per bracket.
(b) Slide a new key unlock warning switch in the column up-
per bracket.
7. INSPECT KEY INTERLOCK SOLENOID
(See page AX-16 and AX-18)
8. IF NECESSARY, REPLACE KEY INTERLOCK SOLE-
NOID
(a) Remove the 2 screws and key interlock solenoid.
(b) Install a new key interlock solenoid with the 2 screws.
9. Column shift:
INSPECT SHIFT LOCK SOLENOID, SHIFT LOCK
SWITCH AND SHIFT LOCK CONTROL ECU
(See page AX-18)
10. Column shift:
IF NECESSARY, REPLACE SHIFT LOCK SOLENOID,
SHIFT LOCK SWITCH AND SHIFT LOCK CONTROL
ECU
11. w/ Engine immobiliser system:
INSPECT TRANSPONDER KEY COIL
(See page BE-181)
12. w/ Engine immobiliser system:
IF NECESSARY, REPLACE TRANSPONDER KEY
COIL
