PP2EQ-01
PP-32
- PREPARATIONSUSPENSION AND AXLE
82 Author: Date:
2001 AVALON (RM808U)
SUSPENSION AND AXLE
SST (Special Service Tools)
09238-47012Water Pump Bearing Remover &
ReplacerFront suspension
09240-00020Wire Gauge SetFront drive shaft
09309-36010Transmission Rear Bearing
ReplacerFront drive shaft
09310-35010Countershaft Bearing ReplacerFront axle
09316-2001 1Transfer Bearing ReplacerFront drive shaft
09316-6001 1Transmission & Transfer Bearing
ReplacerFront axle
Front suspension
(09316-0001 1)Replacer Pipe
(09316-00041)Replacer ºCº
09506-35010Differential Drive Pinion Rear
Bearing ReplacerFront drive shaft
09520-00031Rear Axle Shaft PullerFront axle
09521-24010Drive Shaft Boot Clamping ToolFront drive shaft
09527-1701 1Rear Axle Shaft Bearing RemoverFront axle
W03144
- SUSPENSION AND AXLEFRONT DRIVE SHAFT
SA-17
1351 Author: Date:
2001 AVALON (RM808U)
HINT:
At the time of installation, please refer to the following items.
Coat gear oil to the inboard joint shaft and differential
case sliding surface.
Before installing the drive shaft, set the snap ring opening
side facing downward.
Whether or not the inboard joint shaft is making contact
with the pinion shaft can be known by the sound or feeling
when driving it in.
After installation, check that there is 2 - 3 mm (0.08 - 0.12
in.) of play in the axial direction.
After installation, check that the drive shaft cannot be re-
moved by hand.
(b) Using a screwdriver, remove the snap ring from the in-
board joint shaft.
9. RH drive shaft:
REMOVE DRIVE SHAFT
(a) Remove the bearing lock bolt.
Torque: 32 N´m (330 kgf´cm, 24 ft´lbf)
(b) Using pliers, remove the snap ring and drive shaft.
NOTICE:
Be careful not to damage the dust cover and oil seal.
HINT:
At the time of installation, coat gear oil to the inboard joint shaft
and differential case sliding surface.
