2001 NISSAN PATROL Electronic Repair Manual

LOW BEAM
1. Turn headlamp low beam on.
2. Use adjusting screws to perform aiming adjustment.
+First tighten the adjusting screw all the way and then
make adjustment by loosening the screw.
+Adjust headlamps so that main axis of light is parallel to
center line of body and is aligned with point P shown in
illustration.
+Figure to the left shows headlamp aiming pattern for
driving on right side of road; for driving on left side of
road, aiming pattern is reversed.
+Dotted lines in illustration show center of headlamp.
ªHº: Horizontal center line of headlamps
ªW
Lº: Distance between each headlamp center
ªLº: 5,000 mm (196.85 in)
ªCº: 63 mm (2.48 in)
CEL735
SEL254I
HEADLAMP/WAGON AND HARDTOP MODELS Ð Conventional Type Ð
Aiming Adjustment (Cont'd)
EL-2036

Wiring Diagram Ð H/AIM Ð
TEL389M
HEADLAMP/WAGON AND HARDTOP MODELS
Ð Headlamp Aiming Control Ð
EL-2037

TEL390M
HEADLAMP/WAGON AND HARDTOP MODELS
Ð Headlamp Aiming Control Ð
Wiring Diagram Ð H/AIM Ð (Cont'd)
EL-2038

Wiring Diagram Ð DTRL Ð
TEL675B
HEADLAMP/WAGON AND HARDTOP MODELS
Ð Daytime Light System Ð
EL-2039

TEL484M
HEADLAMP/WAGON AND HARDTOP MODELS
Ð Daytime Light System Ð
Wiring Diagram Ð DTRL Ð (Cont'd)
EL-2040

Wiring Diagram Ð TAIL/L Ð/Type A
Rear combination lamps are not located on rear bumper.
TEL391M
PARKING, LICENSE AND TAIL LAMPS/WAGON AND HARDTOP MODELS
EL-2041

TEL212M
PARKING, LICENSE AND TAIL LAMPS/WAGON AND HARDTOP MODELS
Wiring Diagram Ð TAIL/L Ð/Type A (Cont'd)
EL-2042

Wiring Diagram Ð TAIL/L Ð/Type B
LHD MODELSRear combination lamps are located on rear bumper.
TEL392M
PARKING, LICENSE AND TAIL LAMPS/WAGON AND HARDTOP MODELS
EL-2043