2000 TOYOTA CAMRY Clutch plate

Q10008
C
C
A
CBA
ABC A
Q10011
Q10009
± MANUAL TRANSAXLE (S51)MANUAL TRANSAXLE UNIT
MX±7
1857 Author: Date:
23. REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM
(a) Remove the LH and RH fender liner set screws.
(b) Remove the 6 bolts, 4 nuts, front LH and RH suspension
member braces, rear LH and RH suspension member
braces and front suspension member with the lower sus-
pension arm.
Torque:
Bolt A: 181 N´m (1,850 kgf´cm, 134 ft´lbf)
Bolt B: 32 N´m (330 kgf´cm, 24 ft´lbf)
Nut C: 36 N´m (370 kgf´cm, 27 ft´lbf)
24. JACK UP TRANSAXLE SLIGHTLY
Using a transmission jack, support the transaxle.
25. REMOVE LH STIFFENER PLATE
Remove the 3 bolts and LH stiffener plate.
Torque: 37 N´m (380 kgf´cm, 27 ft´lbf)
26. REMOVE REAR END PLATE WITH OIL PAN INSULA-
TOR AND RH STIFFENER PLATE
(a) Remove the 2 bolts and rear end plate with the oil pan in-
sulator.
Torque: 9.3 N´m (95 kgf´cm, 82 in.´lbf)
(b) Remove the 2 bolts and manifold stay.
Torque: 39 N´m (400 kgf´cm, 29 ft´lbf)
(c) Remove the 4 bolts and RH stiffener plate.
Torque: 39 N´m (400 kgf´cm, 29 ft´lbf)
27. REMOVE TRANSAXLE
Lower the engine left side and remove the transaxle from the
engine.
HINT:
At the time of installation, please refer to the following items.

Align the input shaft with the clutch disc and install the
transaxle to the engine.

Temporarily tighten the transaxle mounting bolts.

MX04Z±01
Q09981
Hood
14 (150, 10)
w/ Cruise Control :
Cruise Control Actuator
12 (120, 9)
Clutch Line Bracket
21 (210, 15)
12 (120, 9)
Clutch Release Cylinder
26 (270, 20)
RH Drive Shaft


32 (330, 24)
7.8 (80, 69 in.´lbf)
Flywheel Housing Under CoverRH Fender
Apron SealClutch Accumulator
Vehicle Speed Sensor
Connector
46 (470, 34)
Engine LH Mounting
Insulator with Bracket
Rear RH Suspension Member Brace
37 (380, 27)
Transaxle
64 (650, 47)
36 (370, 27)
10 (100, 7)
Steering Return Pipe
19 (195, 14)
32 (330, 24)
181 (1,850, 134)
Silver Bolt : 44 (450, 33)
Green Bolt : 66 (670, 48)
Suspension Member with
Lower Suspension Arm
Front RH Suspension
Member Brace
181 (1,850, 134)
Control
Cable
Clip13 (130, 9)
Clip
Washer
Starter
21 (210, 15)
39 (400, 29)
Air Cleaner
Case Assembly
with Air Hose
64 (650, 47)Ground Cable
x5Back±Up Light Switch Connector
Engine Wire
20 (200, 14)Hold±Down
Clamp
Battery
LH Drive Shaft
LH Fender Apron Seal RH Exhaust Manifold Stay
64 (650, 47)
181 (1,850, 134)PS Gear Assembly
No.1 Fuel Tube Protector
49 (500, 36)
294 (3,000, 217)
Lock Cap
Rear LH Suspension Member Brace
Stabilizer Bar Link
Hole
Plug
127 (1,300, 94)
39 (400, 29)
80 (820, 59)48 (490, 35)
Silver Bolt : 44 (450, 33)
Green Bolt : 66 (670, 48)
Front LH Suspension
Member Brace RH Fender
Liner
Engine Rear Side
Shutter Plate
56 (570, 41)




62 (630, 46)

62 (630, 46)

Front Exhaust Pipe
No.1 Exhaust Pipe
Support Bracket
33 (330, 24)
Exhaust Pipe Support Stay
33 (330, 24)LH Fender
Liner
66 (670, 48)
Snap Ring

Snap Ring

Cotter Pin

Cotter Pin

Gasket

Gasket

Gasket
Non±reusable part: Specified torque
N´m (kgf´cm, ft´lbf)


36 (370, 27)
± MANUAL TRANSAXLE (E153)MANUAL TRANSAXLE UNIT
MX±3
1804 Author: Date:
MANUAL TRANSAXLE UNIT
COMPONENTS

PP1WA±02
± PREPARATIONENGINE MECHANICAL (5S±FE)
PP±7
59 Author: Date:
SSM (Special Service Materials)
08826±00080Seal Packing Black or equivalent
(FIPG)Camshaft bearing cap
Cylinder head cover
Semi±circular plug
08833±00070Adhesive 1324,
THREE BOND 1324 or equivalentFlywheel or drive plate bolt
Torque converter clutch bolt
08833±00080Adhesive 1344
THREE BOND 1344
LOCTITE 242 or equivalentOil pressure switch

PP0KI±01
± PREPARATIONAUTOMATIC TRANSAXLE (A140E)
PP±73
125 Author: Date:
EQUIPMENT
OBD II scan tool
Torque wrench
Hexagon wrench
Dial indicator with magnetic baseDrive plate
Vernier calipersTorque converter clutch
Straight edgeTorque converter clutch

PP0M3±01
± PREPARATIONAUTOMATIC TRANSAXLE (A541E)
PP±77
129 Author: Date:
EQUIPMENT
Straight edgeTorque converter clutch
Vernier calipersTorque converter clutch
Dial indicator or dial indicator with magnetic baseDrive plate
Hexagon Wrench (10 mm)
Torque wrench
OBD II scan tool

SS0AE±03
± SERVICE SPECIFICATIONSENGINE MECHANICAL (5S±FE)
SS±9
172 Author: Date:
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Oil pump pulley x Oil pump drive shaft2424518
No.2 idler pulley x Oil pump4242531
Crankshaft pulley x Crankshaft1081,10080
Camshaft timing pulley x Camshaft
for use with SST54
37550
38040
27
No.1 idler pulley x Cylinder head4242531
Cylinder head x Cylinder block 1st
2nd49
Turn 90°500
Turn 90°36
Turn 90°
Water bypass pipe x Cylinder head1919514
Spark plug tube x Cylinder head4950036
Camshaft bearing cap x Cylinder head1919014
Cylinder head cover x Cylinder head4445033
RH engine hanger x Generator bracket2525018
Generator bracket x Cylinder head4242531
LH engine hanger x Cylinder head2525018
No.3 timing belt cover x Cylinder head7.88069 in.´lbf
Delivery pipe x Cylinder head131309
Intake manifold x Cylinder head1919514
Fuel inlet hose x Delivery pipe
for use with SST34
29350
30025
21
EGR valve x intake manifold13.313010
EGR pipe x Cylinder head61.260045
Intake manifold stay x Intake manifold3939829
Intake manifold stay x Stiffening plate3939829
Water outlet x Cylinder head1515011
No.2 intake manifold stay x Cylinder head2121415
No.2 intake manifold stay x Intake manifold4242831
Exhaust manifold x Cylinder head4950036
No.1 exhaust manifold stay x Exhaust manifold4242531
No.1 exhaust manifold stay x Transaxle4242531
No.2 exhaust manifold stay x Exhaust manifold4242531
No.2 exhaust manifold stay, LH stiffener plate x Cylinder block TMC made
TMMK made58
42591
42543
31
No.1 rear end plate x Cylinder block9.39582 in.´lbf
Flywheel (M/T) x Crankshaft8890065
Drive plate (A/T) x Crankshaft8385061
Transaxle (M/T) x Cylinder block 14 mm head
17 mm head46
64470
65034
47
Transaxle (A/T) x Cylinder block6667048
Drive plate x Torque converter clutch2728020
No.2 rear end plate x Cylinder block9.39582 in.´lbf
Exhaust pipe bracket, No.2 rear end plate x Transaxle1919514
RH stiffener plate x Cylinder block3939829
RH stiffener plate x Transaxle3939829

SS09N±01
SS±52
± SERVICE SPECIFICATIONSMANUAL TRANSAXLE (S51)
215 Author: Date:
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Transaxle x Engine 17 mm head6465047Transaxle x Engine 17 mm head
14 mm head
64
46
650
470
47
34
Cruise control actuator x Body (w/ Cruise control)131309
Starter x Transaxle3737828
Clutch release cylinder x Transaxle121209
Clutch line bracket x Transaxle Bolt A121209Clutch line bracket x Transaxle Bolt A
(See page MX±4) Bolt B
12
6.9
120
70
9
61 in.´lbf
Manifold stay Front side4242531
Manifold stay Rear side3940029
Front wheel1031,05076
Exhaust pipe bracket Bolt1919514Exhaust ie bracket Bolt
Nut
19
33
195
330
14
24
Front exhaust pipe x Exhaust manifold6263046
Front exhaust pipe x Center exhaust pipe5657041
No.1 exhaust pipe support bracket x Front suspension member3333024
Stabilizer bar link x Stabilizer bar3940029
Stabilizer bar bracket x Front suspension member1919514
PS gear assembly x Front suspension member1811,850134
Front engine mounting insulator x Front suspension member Silver bolt4445033Front engine mounting insulator x Front sus ension member Silver bolt
Green bolt
44
66
450
670
33
48
LH engine mounting insulator x Front suspension member8082059
LH engine mounting bracket x Transaxle6465047
Rear engine mounting insulator x Front suspension member6667048
Steering return pipe x Front suspension member101007
Front suspension member with lower suspension arm Bolt A1811,850134Front sus ension member with lower sus ension arm Bolt A
Bolt B
181
32
1,850
330
134
24Bolt B
(See page MX±4) Nut C
32
36
330
370
24
27
LH stiffener plate3738027
RH stiffener plate3940029
Rear end plate9.39582 in.´lbf
Shift cable grommet retainer x Body4.95043 in.´lbf
Shift lever assembly x Body121209
Transmission case x Transaxle case2930022
Transmission case x Case cover2930022
Transmission case protector1818513
Rear bearing retainer4243031
Output shaft front bearing lock plate1818513
Transaxle case receiver set bolt7.47565 in.´lbf
5th driven gear lock nut1231,25090
Reverse idler shaft lock bolt2930022
Control shaft cover3737527
Control shift lever x Lever shaft6.46556 in.´lbf
Ring gear x Differential case8385061
Selecting bellcrank x Transmission case3738027

SS0AT±01
± SERVICE SPECIFICATIONSAUTOMATIC TRANSAXLE (A140E)
SS±55
218 Author: Date:
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Transaxle x Starter4243031
Transaxle x Rear end plate2525018
Transaxle x No.1 exhaust pipe support bracket1919514
Transaxle x Engine6667048
Torque converter clutch x Drive plate2728020
Body x Front lower brace Bolt
Nut181
361,850
370134
27
Body x Rear lower brace 19 mm head bolt
14 mm head bolt
Nut181
32
361,850
330
370134
24
27
Front suspension member x FR engine mounting TMC made
TMMK made: Green color bolt
TMMK made: Silver color bolt80
66
44820
670
45059
48
32
Front suspension member x RR engine mounting6667048
Front suspension member x LH engine mounting8082059
Transaxle x LH engine mounting6465047
Front suspension member x Steering return pipe mounting bracket101007
Front suspension member x Stabilizer bar bracket1919514
Stabilizer bar x Stabilizer bar link3940029
Ball joint x Lower suspension arm1271,30094
Steering gear housing set bolt x Nut1811,850134
Exhaust manifold x Front exhaust pipe6263046
Front suspension member x Exhaust pipe No.1 support bracket3333024
Front exhaust pipe x Center exhaust pipe5657041
No.1 exhaust pipe support bracket x Exhaust pipe clamp3333024
Axle hub nut2943,000217
Steering knuckle x Tie rod end4950036
Vehicle speed sensor x Transaxle1616012
Park/neutral position switch x Transaxle Bolt
Nut5.4
6.955
7048 in.´lbf
61 in.´lbf
Park/neutral position switch x Control shaft lever131309
Control shaft lever x Control cable1515011
Oil pan x Drain plug4950036
Oil pan x Transaxle4.95043 in.´lbf
Valve body x Manual valve body101007
Valve body x Transaxle101007
Drive shaft center bearing lock bolt3233024
Stiffener plate Front side
Rear side42
39430
40031
29
Exhaust manifold stay Front side
Rear side42
39430
40031
29